Explanation Introduction: The ROM is the type of memory in which the data can only be read and not be written. The ROM comes under the category of the volatile memory as they store the data even when the system is turned on, thus the data can be retained later. Consider the row inputs are W 1 , W 2 , W 3 and W 4 is the row inputs and the C 1 , C 2 , C 3 and C 4 are the columns input. Also, let the output bits are D 1 , D 2 , D 3 and D . For case (i). To obtain the output 1011 the required row and column inputs are W 1 , C 2 , C 3 and C 4 must be at logic 1. The transistors that must be in the conduction state are the M 00 , M 02 and M 03 . For case (ii). To obtain the output 1111 the required row and column inputs are W 2 , C 1 , C 2 , C 3 and C 4 must be at logic 1

Microelectronics: Circuit Analysis and Design

4th Edition

ISBN: 9780073380643

Author: Donald A. Neamen

Publisher: McGraw-Hill Companies, The

See similar textbooks

Concept explainers

Quantization and Resolution

Quantization is a methodology of carrying out signal modulation by the process of mapping input values from an infinitely long set of continuous values to a smaller set of finite values. Quantization forms the basic algorithm for lossy compression algori…

Probability of Error

This topic is widely taught in many undergraduate and postgraduate degree courses of:

Question

Chapter 16, Problem D16.93P

To determine

To design: The 4×4 bit NMOS mask programmed ROM to produce the given outputs.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Chapter 16, Problem 16.92P

Chapter 16, Problem D16.94P

Students have asked these similar questions

1. How do the data retention characteristics of RAM and ROM storage devices differ? 2. What is the purpose and use of the Program Counter (PC), Stack Pointer (SP), and Memory Address Register (MAR) registers? 3. Write an 8085 program to store 4EH in memory location 2840H and store 3EH in memory location 2841H, exchange them and store the result in memory locations 2842H and 2843H respectively. Solve this problem using three different methods. 4. Write a program to exchange the content of memory locations [2801] [2800] with [2803] [2802]. 5. The following program is supposed to add the contents of memory location 2050h to the Accumulator. The program works correctly only part of the time. Show that it is wrong to execute the program and how to correct it. MOV LDA ADC HLT В.А 2050H в 6. In a multibyte addition program, when you must use the ADD instruction? When you must use the ADC instruction? 7- The 8085-instruction set does not include a clear accumulator instruction. Which…

Question 3 a) Convert the following unsigned binary numbers to decimal. i) 101101112 ii) 010011012 iii) 100101102 b) Assume a digital to analog conversion system uses a 10-bit integer to represent an analog temperature over a range of -100C to 1000C. If the actual temperature being read was 36.5oC, what would be the closest possible value that the system could represent? Expiain the term aliasing and discuss how it can be avoided in digital sampling. d) Show the output waveform of an AND gate with the inputs A, B, and C indicated in the figure below. A B C

ir I need the solution step by step and clear line please Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine a- The number of quatization levels b- The step size of the quantizer or resolution. c- The quantization level when the analog voltage is 3.2 volts. d- The binary code produced by the ADC. e- The quatization error when the analog voltage is 3.2 volts.

Chapter 16 Solutions

Microelectronics: Circuit Analysis and Design

Ch. 16 - Consider the NMOS inverter with resistor load in...Ch. 16 - The enhancementload NMOS inverter in Figure...Ch. 16 - Prob. 16.3EP Ch. 16 - Prob. 16.4EP Ch. 16 - Consider the NMOS inverter with enhancement load,...Ch. 16 - Prob. 16.2TYU Ch. 16 - (a) Consider the results of Exercise Ex 16.1....Ch. 16 - Prob. 16.5EP Ch. 16 - Prob. 16.6EP Ch. 16 - (a) Design a threeinput NMOS NOR Logic gate with...

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

To design: The 4 × 4 bit NMOS mask programmed ROM to produce the given outputs.

Solution Summary: The author explains that the 4times 4 bit NMOS mask programmed ROM produces the given outputs.

Concept explainers

To design: The 4×4 bit NMOS mask programmed ROM to produce the given outputs.

Want to see the full answer?

Chapter 16 Solutions