Consider the production of ammonia from nitrogen and hydrogen
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
An Introduction to Thermal Physics
Additional Science Textbook Solutions
Modern Physics
Physics for Scientists and Engineers with Modern Physics
College Physics: A Strategic Approach (3rd Edition)
Sears And Zemansky's University Physics With Modern Physics
Essential University Physics: Volume 1 (3rd Edition)
Physics (5th Edition)
- One process for decaffeinating coffee uses carbon dioxide ( M=44.0 g/mol) at a molar density of about 14,0 mol/m3 and a temperature of about 60 . (a) Is CO2 a solid, liquid, gas, or supercritical fluid under those conditions? (b) The van der Waals constants for carbon dioxide are a=0.3658 Pa m6/mol2 and b=4.286105 m3/mol. Using the van der Waals equation, estimate pressure of CO2 at that temperature and density. `arrow_forwardI need help solving number 11. In question 1, they say U=(3/2)PV I found work on the gas as -3/2PV, so therefore Q should be 6/2PV but the answer key says 6PV.arrow_forwardWhat is the ΔS° for the reaction? Given are the S°, in J K-1 mol-1, of each substance in parentheses. SiCl4 (g, 330.73) + 2 Mg (s, 32.68) → 2 MgCl2 (s, 89.62) + Si (s, 18.83) -198.02 J/K 198.02 J/K -254.96 J/K 254.96 J/Karrow_forward
- Figure I shows the P-V graph for a sample of a gas at 298 K. If this sample were heated to 312 K, this would be represented by a point 25. atm Figure 1 100 V/e 50 A At the top, left end of the line Off the line, above and to the right of it. B At the lower, right end of the line D Off the line, below and to the right of it.arrow_forwardThe enthalpy change for heating a one mole sample of an ideal, monoatomic gas at 25°C is 3.75 KJoules, the enthalpy change for the same process but done at 125 °C would be ________ Kilojoules. (NOTE: express answer in TWO SIGNIFICANT FIGURES)arrow_forwardCalculate AS when 3.2 moles of n-hexane goes from 298 K and 1 atm to 398 K and 2 atm. The table below provides useful data, all at 298 K and 1 atm (reference: Cerdeiriña, Claudio A., et al. "Isobaric thermal expansivity and thermophysical characterization of liquids and liquid mixtures." Physical Chemistry Chemical Physics 3.23 (2001): 5230-5236). You may neglect the pressure and temperature dependence of all quantities. Compound Molar Volume (cm³/mol) Isothermal Compressibility (1/atm) Thermal Expansity (1/K) Cp,m (J/molK) n-hexane 133.09 1.69 x 10-4 1.38 x 10-3 195.66 n-heptane 147.45 1.47 x 10-4 1.246 x 10-3 224.64 n-dodecane 228.55 1.00 x 10-4 9.69 x 10-4 376.22arrow_forward
- Calculate ΔG° (kJ/mol) for a reaction whose equilibrium constant is 1.9 x 106 at 298 K. Report your answer to two decimal places and don't include units.arrow_forwardThe volume V of an ideal gas varies directly with the temperature T and inversely with the pressure P. If a cylinder of 50 liters contains oxygen at a temperature of 200 K and a pressure of 5 atmospheres, what would the gas pressure be if the volume was changed to 30 liters and the temperature raised to 240 K?arrow_forwardHow much energy (in J) is required to evaporate 25% of 4g of water currently at 100 °C? The answer (in fundamental Sl unit) is (type the numeric value only, dont use scientific notation)arrow_forward
- The vapor pressures of the components, A and B, in a binary solution have been modeled and found to obey хара exp(0.75 XB) A A exp(0.75x) where XÃ and are the mole fractions, and PA* and PB* are the vapor pressures of each pure substance at room temperature. (a) If PA* = 0.084 bar and the total pressure of a mixture with XA = 0.40 is 0.125 bars, what is PB*, the vapor pressure of pure B (in bars)? P = X P А P₁ = X_P B QUESTION 14 B B * * Continuation of the previous problem (b) Assuming that the vapor is an ideal gas, what is the mole fraction of component B in the vapor phase?arrow_forwardThe pressure, volume, and temperature of a mole of an ideal gas are related by the equation PV = 8.31T, where P is measured in kilopascals, V in liters, and T in kelvins. Use differentials to find the approximate change in the pressure if the volume increases from 10 L to 10.6 L and the temperature decreases from 335 K to 330 K. (Note whether the change is positive or negative in your answer. I Round your answer to ti decimal places.arrow_forwardA (1.1x10^1) liter bottle is filled with nitrogen (N2) at STP (Standard Temperature and Pressure is 1 atm and 273 K) and closed tight. If the temperature is raised to 100° C, what will be the new pressure in SI units to two significant figures. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: x10 Answerarrow_forward