An Introduction to Thermal Physics
1st Edition
ISBN: 9780201380279
Author: Daniel V. Schroeder
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Question
Chapter 5.1, Problem 17P
(a)
To determine
The work required.
(b)
To determine
The work done in terms of
(c)
To determine
The
(d)
To determine
The enthalpy and Gibbs free energy of the magnetic system.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Assuming a source free region, derive the following equation. The
symbols have the usual meaning.
at
The simple mass on a spring is the basis for our description of almost any oscillation. Lets consider the vibrational states of a simple diatomic molecule, say N2. We will model it as two identical masses connected by a spring as shown in the figure at the top right.This is a little different from the cart on a spring since there is no wall -- both of the atoms are moving. But if we only look at oscillations of the molecule where the center of mass is not moving, the atoms are moving equally and oppositely. When one is going left, the other goes an equal amount to the right and vice versa. This is like two carts attached to a wall and oscillating equally and oppositely as shown in the lower picture. The only difference is the way we treat the spring. When each atom moves a distance x, the spring between the atoms actually stretches a distance 2x, so the force on each atom is -2kx. We can therefore model the motion of one of the nitrogen atoms as a single cart on a spring if we…
There is a one-dimensional solid lattice with two basis atoms of
mass m and M, respectively (lattice constant = a). Let the interaction
between atoms act only on adjacent atoms, and let the bonding force
coefficient be C (Fig.).
M
C
C
a
a) Draw the Brillouin zone and the approximate phonon
dispersion w=w(K), and write the name of each phonon
branch
b)
When K = TT/a, write down the normal mode energy and
discuss the relative motion of adjacent atoms.
c) If two atoms are of the same kind (m = M), plot the Brillouin
%3D
zone and phonon dispersion w=w(K).
Chapter 5 Solutions
An Introduction to Thermal Physics
Ch. 5.1 - Prob. 1PCh. 5.1 - Consider the production of ammonia from nitrogen...Ch. 5.1 - Prob. 3PCh. 5.1 - Prob. 4PCh. 5.1 - Consider a fuel cell that uses methane (natural...Ch. 5.1 - Prob. 6PCh. 5.1 - The metabolism of a glucose molecule (see previous...Ch. 5.1 - Derive the thermodynamic identity for G (equation...Ch. 5.1 - Sketch a qualitatively accurate graph of G vs. T...Ch. 5.1 - Suppose you have a mole of water at 25C and...
Ch. 5.1 - Suppose that a hydrogen fuel cell, as described in...Ch. 5.1 - Prob. 12PCh. 5.1 - Prob. 13PCh. 5.1 - Prob. 14PCh. 5.1 - Prob. 15PCh. 5.1 - Prob. 16PCh. 5.1 - Prob. 17PCh. 5.2 - Prob. 18PCh. 5.2 - In the previous section 1 derived the formula...Ch. 5.2 - Prob. 20PCh. 5.2 - Is heat capacity (C) extensive or intensive? What...Ch. 5.2 - Prob. 22PCh. 5.2 - Prob. 23PCh. 5.3 - Go through the arithmetic to verify that diamond...Ch. 5.3 - Prob. 25PCh. 5.3 - How can diamond ever be more stable than graphite,...Ch. 5.3 - Prob. 27PCh. 5.3 - Calcium carbonate, CaCO3, has two common...Ch. 5.3 - Aluminum silicate, Al2SiO5, has three different...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. T...Ch. 5.3 - Sketch qualitatively accurate graphs of G vs. P...Ch. 5.3 - The density of ice is 917kg/m3. (a) Use the...Ch. 5.3 - An inventor proposes to make a heat engine using...Ch. 5.3 - Below 0.3 K the Slope of the 3He solid–liquid...Ch. 5.3 - Prob. 35PCh. 5.3 - Effect of altitude on boiling water. (a) Use the...Ch. 5.3 - Prob. 37PCh. 5.3 - Prob. 38PCh. 5.3 - Prob. 39PCh. 5.3 - The methods of this section can also be applied to...Ch. 5.3 - Suppose you have a liquid (say, water) in...Ch. 5.3 - Ordinarily, the partial pressure of water vapor in...Ch. 5.3 - Assume that the air you exhale is at 35C, with a...Ch. 5.3 - Prob. 44PCh. 5.3 - Prob. 46PCh. 5.3 - Prob. 47PCh. 5.3 - Prob. 48PCh. 5.3 - Prob. 49PCh. 5.3 - The compression factor of a fluid is defined as...Ch. 5.3 - Prob. 51PCh. 5.3 - Prob. 52PCh. 5.3 - Repeat the preceding problem for T/Tc=0.8.Ch. 5.3 - Prob. 54PCh. 5.3 - Prob. 55PCh. 5.4 - Prove that the entropy of mixing of an ideal...Ch. 5.4 - In this problem you will model the mixing energy...Ch. 5.4 - Suppose you cool a mixture of 50% nitrogen and 50%...Ch. 5.4 - Suppose you start with a liquid mixture of 60%...Ch. 5.4 - Suppose you need a tank of oxygen that is 95%...Ch. 5.4 - Prob. 62PCh. 5.4 - Everything in this section assumes that the total...Ch. 5.4 - Figure 5.32 shows the phase diagram of plagioclase...Ch. 5.4 - Prob. 65PCh. 5.4 - Prob. 66PCh. 5.4 - Prob. 67PCh. 5.4 - Plumbers solder is composed of 67% lead and 33%...Ch. 5.4 - What happens when you spread salt crystals over an...Ch. 5.4 - What happens when you add salt to the ice bath in...Ch. 5.4 - Figure 5.35 (left) shows the free energy curves at...Ch. 5.4 - Repeat the previous problem for the diagram in...Ch. 5.5 - If expression 5.68 is correct, it must be...Ch. 5.5 - Prob. 74PCh. 5.5 - Compare expression 5.68 for the Gibbs free energy...Ch. 5.5 - Seawater has a salinity of 3.5%, meaning that if...Ch. 5.5 - Osmotic pressure measurements can be used to...Ch. 5.5 - Because osmotic pressures can be quite large, you...Ch. 5.5 - Most pasta recipes instruct you to add a teaspoon...Ch. 5.5 - Use the Clausius–Clapeyron relation to derive...Ch. 5.5 - Prob. 81PCh. 5.5 - Use the result of the previous problem to...Ch. 5.6 - Prob. 83PCh. 5.6 - Prob. 84PCh. 5.6 - Prob. 85PCh. 5.6 - Prob. 86PCh. 5.6 - Sulfuric acid, H2SO4, readily dissociates into H+...Ch. 5.6 - Prob. 88PCh. 5.6 - Prob. 89PCh. 5.6 - When solid quartz dissolves in water, it combines...Ch. 5.6 - When carbon dioxide dissolves in water,...Ch. 5.6 - Prob. 92P
Knowledge Booster
Similar questions
- Consider an Ising model in the presence of an external magnetic field B, which gives each dipole an additional energy of if it points up and +MBB if it points down (where MB is the dipole's magnetic moment). Analyze this system using the mean field approximation to find the analogue of equation 8.50. Study the solutions of the equation graphically, and discuss the magnetization of this system as a function of both the external field and the temperature. Sketch the region in the T-B plane for which the equation has three solutions.arrow_forwardCompute the thermodynamics of the spin 1 paramagnet in the presence of a field H. Since this is spin 1, the allowed spin values will be +1, 0, –1. Calculate the magnetic susceptibility in the zero field limit as well as magnetization in the low and high temperature limits. The magnetization M is just the total spin of the material times a constant, whereas the magnetic susceptibility is the ease with which the sample gets magnetized on ƏM/ƏH. While computing, please do assume that the maximum number of particles in the Spin 0 state is one. This assumption will greatly simplify the calculations, however, it is an unphysical application of a field: X = assumption.arrow_forwardIn this and following questions, we develop a model for spontaneous emission of a photon by a diatomic molecule AB (a model molecule), which rotates and vibrates. In intermediate calculations, atomic units (a.u.) will be used: unit of mass = the mass of electron, unit of charge is the proton charge e, (e is a positive constant so that the charge of electron is -e). The initial state of the molecule is an excited rotational (1=1) and excited vibrational state (v=1). We consider a molecule with the reduced mass µ = 10,000 a.u. (it is similar to the mass of CO). After emitting a photon, the molecule will go to the 1=0, v=0 state. The first question is about the model potential of the molecule. It is represented by a potential of the form: V(r) = C6 p12 C12 p6 " where r is the distance between A and B in the molecule, C6 and C12 are positive constants (C6 =2 and C₁2-1). This potential has a well meaning that the molecule is bound. The first thing to do is find vibrational states of the…arrow_forward
- Consider an ideal two-state electronic paramagnet such as DPPH,with µ = µB. In the experiment described above, the magnetic field strength was 2.06 T and the minimum temperature was 2.2 K. Calculate the energy, magnetization, and entropy of this system, expressing each quantity as a fraction of its maximum possible value. What would the experimenters have had to do to attain 99% of the maximum possible magnetization?arrow_forwardProblem 4.38. Two magnetic systems in thermal contact Consider two isolated systems of noninteracting spins with NA energies are EA = -2µB and Eg = -2µB. = 4 and NB = 16. Their initial (a) What is the total number of microstates available to the composite system? (b) If the two systems are now allowed to exchange energy with one another, what is the probability that system A has energy EA? (c) What is the mean value of EA and its relative fluctuations? Calculate the analogous quantities for system B.arrow_forwardWe worked out the multiple expansion for the vector potential of a line current because that's the most common type, and in some respects the easiest to handle. For a volume current J: a) Write down the multipole expansion, analogous to the equation µol A(r) = 4л 1 dľ = 1 for. ' Pn (cos 0') dľ', L pn+1 47 n=0 b) Write down the multipole expansion, and prove that it vanishes. c) Using the equation a = r x dl, and m = I i da = la. Show that the dipole moment can be written as m = (r x J) dt.arrow_forward
- What is the magntiude of the integral of B over dl for part b? Enter in your answer in micro-T*m. Assume that all currents are 19.2 A instead of what the textbook has noted.arrow_forwardStarting from equation 7.83 attached, derive a formula for the density of states of a photon gas (or any other gas of ultrarelativistic particles having two polarization states). Sketch this function.arrow_forwardIn free spoce, E (2,t) = 10. sin (wt - 82) ox, (V/m) %3D Show that the overage power po ssing through circular disk with a radius of 15.5 m in the Constant plane z= is IW. (Please write down , explaining all the Steps)arrow_forward
- Consider a free Fermi gas in two dimensions, confined to a squarearea A = L2. Because g(€) is a constant for this system, it is possible to carry out the integral 7.53 for the number of particles analytically. Do so, and solve for μ as a function of N. Show that the resulting formula has the expected qualitative behavior.arrow_forwardWhat is the magntiude of the integral of B over dl for part d? Enter in your answer in micro-T*m. Assume that the upward current is 4.4 A instead of what the textbook has noted, and assume that the downward 4 A current is really 12.7 A and that the downward 3 A current really is 6.5 A.arrow_forward6.2 Let the "uniform" ensemble of energy E be defined as the ensemble of all systems of the given type with energy less than E. The equivalence between (6.29) and (6.27) means that we should obtain the same thermodynamic functions from the "uniform" ensemble of energy E as from the microcanonical ensemble of energy E. In particular, the internal energy is E in both ensembles. Explain why this seemingly paradoxical result is true.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Modern PhysicsPhysicsISBN:9781111794378Author:Raymond A. Serway, Clement J. Moses, Curt A. MoyerPublisher:Cengage Learning
Modern Physics
Physics
ISBN:9781111794378
Author:Raymond A. Serway, Clement J. Moses, Curt A. Moyer
Publisher:Cengage Learning