Microelectronics: Circuit Analysis and Design
4th Edition
ISBN: 9780073380643
Author: Donald A. Neamen
Publisher: McGraw-Hill Companies, The
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 13, Problem 13.4EP
To determine
The value ofsmall-signal differential voltage gain of the 741 op-amp input stage
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
In the Figure below if volts/div-5 then Vims is (in volt)
Selectone.
O a. 2.6
O b.12.75
O c. 9.19
O d.18
c) Using a Si diode, design a clamper circuit that will result in the desired output waveform
as shown in Figure Q2c. Show overall analysis to justify the proposed design.
Vi
Vo
20
Designed
Clamper
Circuit
- 3 V
-20
- 43 V-
Figure Q2c
The average (DC) value of a half-wave rectified
voltage with a peak value of 200 V is:
a. 63.7 V
b.
127.3 V
c.
d. OV
141 V
2. Voltage regulation is determined by:
a. load current
b. Zener current and load current
c.
changes in load resistance and output voltage
d. changes in no-load voltage and full-load voltage
When a 60-Hz sinusoidal voltage is applied to the
input of a full-wave rectifier, the output frequency is:
a. 120 Hz
b.
60 Hz
c. 240 Hz
d.
0 Hz
Chapter 13 Solutions
Microelectronics: Circuit Analysis and Design
Ch. 13 - Prob. 13.1EPCh. 13 - Prob. 13.2EPCh. 13 - Prob. 13.4EPCh. 13 - Repeat Example 13.5 assuming Early voltages of...Ch. 13 - Prob. 13.6EPCh. 13 - Prob. 13.3TYUCh. 13 - Prob. 13.4TYUCh. 13 - Prob. 13.5TYUCh. 13 - Prob. 13.6TYUCh. 13 - Prob. 13.8EP
Ch. 13 - Prob. 13.11EPCh. 13 - Prob. 13.10TYUCh. 13 - Prob. 13.12TYUCh. 13 - Prob. 13.12EPCh. 13 - Prob. 13.13EPCh. 13 - Prob. 13.15EPCh. 13 - Prob. 13.15TYUCh. 13 - Consider the LF155 BiFET input stage in Figure...Ch. 13 - Describe the principal stages of a generalpurpose...Ch. 13 - Prob. 2RQCh. 13 - Prob. 3RQCh. 13 - Describe the operation and characteristics of a...Ch. 13 - Describe the configuration and operation of the...Ch. 13 - What is the purpose of the resistorin the active...Ch. 13 - Prob. 7RQCh. 13 - Prob. 8RQCh. 13 - Describe the frequency compensation technique in...Ch. 13 - Sketch and describe the general characteristics of...Ch. 13 - Prob. 11RQCh. 13 - Sketch and describe the principal advantage of a...Ch. 13 - Prob. 13RQCh. 13 - What are the principal factors limiting the...Ch. 13 - Consider the simple MOS opamp circuit shown in...Ch. 13 - Prob. 13.2PCh. 13 - Prob. 13.5PCh. 13 - Consider the input stage of the 741 opamp in...Ch. 13 - Prob. 13.7PCh. 13 - Prob. 13.8PCh. 13 - Prob. 13.10PCh. 13 - The minimum recommended supply voltages for the...Ch. 13 - Prob. 13.12PCh. 13 - Consider the 741 opamp in Figure 13.3, biased with...Ch. 13 - Prob. 13.14PCh. 13 - Consider the output stage of the 741 opamp shown...Ch. 13 - Prob. 13.16PCh. 13 - Prob. 13.19PCh. 13 - Prob. 13.20PCh. 13 - Prob. 13.21PCh. 13 - Prob. 13.22PCh. 13 - Prob. 13.23PCh. 13 - Prob. 13.24PCh. 13 - (a) Determine the differential input resistance of...Ch. 13 - An opamp that is internally compensated by Miller...Ch. 13 - The CMOS opamp in Figure 13.14 is biased at V+=5V...Ch. 13 - Prob. 13.34PCh. 13 - Consider the MC14573 opamp in Figure 13.14, with...Ch. 13 - Prob. 13.36PCh. 13 - Prob. 13.37PCh. 13 - Prob. 13.39PCh. 13 - Prob. 13.41PCh. 13 - In the bias portion of the CA1340 opamp in Figure...Ch. 13 - Prob. 13.57PCh. 13 - In the LF155 BiFET opamp in Figure 13.25, the...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Q1. a) Figure Q1 is a single phase 2-level voltage source converter (VSC) with a total DC voltage V-1000V. A PWM scheme, by comparing a reference value with a 1kHz triangular waveform, is used to control the switches S₁ and S2, and output 340v at Vo. With the aid of graphs explain how pulse signals for the switches are generated, sketch the output voltage Vo, determine the duty cycle and the modulation index. Va + 2 it Va d + TS₁ V {1+5₂ = Figure Q1 A single phase VSCarrow_forwardAn unipolar PWM full bridge circuit has a Vr.rms of 125V at a duty cycle D1 of 0.7. What is Vd? What is Vo.rms?arrow_forwardBuild an AC/DC dual power supply circuit that draws a 60Vp-p sinusoidal voltage, to provide a dc output voltage of +15 V. Full analysis of voltages and currents should be included. What modifications would you recommend to draw more current while maintaining same output voltage?arrow_forward
- In the circuit of the following figure, the input voltage Vs is 15 volts rms with a frequency of 60 Hz, R equals 150 Ohms and C equals 100,000 Pico Farads. The diodes are Germanium (Vd = 0.2 volts) and the Zener diode is 12 volts. a) The magnitude of the ripple voltage at Cb) The Magnitude of the Peak Inverse Voltage (PIV) for D1 and D2.arrow_forwardA resistor Ra is in series with a voltage source Va. Draw the circuit. Label the voltage across the combination as v and the current as i. Draw and label the volt–ampere characteristic (i versus v).arrow_forwardPart 2: In a step-up converter, consider all the components to be ideal, Let Va be 8-16 V, V. 24 V (regulated), fs-20 kHZ, Po ≥ 6 W. i). Calculate the minimum inductance L required to keep the converter operation in continuous-conduction mode under all conditions. ii). Specify the value of inductor for a maximum ripple of 3%. iii). Design a capacitor for part (i) and (ii) with a voltage ripple of less than 2%.arrow_forward
- Consider the Zener diode circuit shown in Figure. The Zener Breakdown Voltage (Vz) is 5.6 V at Iz= 0.1mA. Zener resistance is r,= 10 0. What is Vo without load (RL= ∞) ? R= 0.5 kQ Vo Vps= 10 Varrow_forwardA six stage Cockcroft Walton type DC voltage multiplier circuit has stage capacitance of 0.01 mF and supply voltage of 100 kV at a frequency of 100 Hz. It delivers and a load current of 1mA. It will have, what the value for follwing Qustion? 96 Voltage regulation Maximum output voltage possible Optimum number of stages No load voltage Voltage droparrow_forwardGiven the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz (operating values). a) 0.11A b) 22mA to 89mA c) 9A d) 0.11A to 9Aarrow_forward
- c. If a 480 ?F capacitor is added to the output in the figure, calculate the following:i. Vripple.ii. Average voltage, Vdc.iii. Sketch a graph of the input and output voltage against time of the capacitor. (Built-in-potential of silicon = 0.7V)arrow_forwardVps = 10 V R = 0.1k02 ww -ovo R₁. Consider the Zener diode circuit shown in figure. The Zener diode voltage is Vz= 5.8V at Iz= 10mA and the Zener resistance is rz = 200. a) Find the output voltage for RL = 1k0 b) Find the change in the output voltage when the load resistance varies +ARL.arrow_forward3 A peak rectifier (peak tollower) Cir cuit is gian below. Vs is a GOH3 Sinuscidal Vollge with peak value Upz50V. 50V. The load resistance R= Sk . Find the Vallke of the capacitance C Such that the peak- to-peak ripple 2 volts. (idenl diede) Voltage Vr Vsarrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,
Introductory Circuit Analysis (13th Edition)
Electrical Engineering
ISBN:9780133923605
Author:Robert L. Boylestad
Publisher:PEARSON
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Programmable Logic Controllers
Electrical Engineering
ISBN:9780073373843
Author:Frank D. Petruzella
Publisher:McGraw-Hill Education
Fundamentals of Electric Circuits
Electrical Engineering
ISBN:9780078028229
Author:Charles K Alexander, Matthew Sadiku
Publisher:McGraw-Hill Education
Electric Circuits. (11th Edition)
Electrical Engineering
ISBN:9780134746968
Author:James W. Nilsson, Susan Riedel
Publisher:PEARSON
Engineering Electromagnetics
Electrical Engineering
ISBN:9780078028151
Author:Hayt, William H. (william Hart), Jr, BUCK, John A.
Publisher:Mcgraw-hill Education,
Why HIGH VOLTAGE DC power Transmission; Author: ElectroBOOM;https://www.youtube.com/watch?v=DFQG9kuXSxg;License: Standard Youtube License