EBK EXPERIMENTAL ORGANIC CHEMISTRY: A M
6th Edition
ISBN: 9781305687875
Author: Gilbert
Publisher: CENGAGE LEARNING - CONSIGNMENT
expand_more
expand_more
format_list_bulleted
Videos
Question
Chapter 6.2, Problem 3E
Interpretation Introduction
Interpretation:In a TLC experiment, the reason for the spot of the sample to be analyzed to not immersed in the solvent in the developing chamber should be explained.
Concept introduction:Thin Layer Chromatography is a sensitive chromatographic technique which used to analyze small quantities of the samples by solid-liquid adsorption method. Rectangular glass plate is coated with anadsorbent; sample to be analyzed is run on the plate in the developing chamber with the mobile phase to give spots of the analyzed sample.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
How does increasing the polarity of the developing solvent affect the Rf of a compound on a silica gel TLC plate?
how does TLC determine if a sample is pure?
a pigment in the thin layer chromatography traveled beyond or farther than the solvent front. Therefore, the Rf value of that certain pigment is greater than 1.
What does this mean to the experiment?
Chapter 6 Solutions
EBK EXPERIMENTAL ORGANIC CHEMISTRY: A M
Ch. 6.2 - Prob. 1ECh. 6.2 - Prob. 2ECh. 6.2 - Prob. 3ECh. 6.2 - Prob. 4ECh. 6.2 - Prob. 5ECh. 6.2 - Prob. 6ECh. 6.2 - Prob. 7ECh. 6.2 - Prob. 8ECh. 6.2 - Prob. 9ECh. 6.3 - Prob. 1E
Ch. 6.3 - Prob. 2ECh. 6.3 - Prob. 3ECh. 6.3 - Prob. 4ECh. 6.3 - Prob. 5ECh. 6.3 - Prob. 6ECh. 6.3 - Prob. 7ECh. 6.3 - Prob. 8ECh. 6.3 - Prob. 9ECh. 6.3 - Prob. 10ECh. 6.3 - Prob. 11ECh. 6.3 - Prob. 12ECh. 6.3 - Prob. 13ECh. 6.3 - Prob. 14ECh. 6.3 - Prob. 15ECh. 6.3 - Prob. 16ECh. 6.3 - Prob. 17ECh. 6.3 - Prob. 18ECh. 6.3 - Prob. 19ECh. 6.3 - Prob. 20ECh. 6.4 - Prob. 1ECh. 6.4 - Prob. 2ECh. 6.4 - Prob. 3ECh. 6.4 - Prob. 4ECh. 6.4 - Prob. 5E
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.Similar questions
- What is 2D gel electrophoresisarrow_forwardIf a TLC was run in a solvent system that caused all the spots to show up at the baseline, how could the system be adjusted so that Rf values could be determined?arrow_forwardA student spots an unknown sample on a TLC plate and develops it in dichloromethane solvent. Only one spot, for which the Rf value is 0.95, is observed. Does this indicate that the unknown material is a pure compound? What can be done to verify the purity of the sample?arrow_forward
- In reverse phase chromatography which analyte will elute first, most polar or least polar?arrow_forwardDifferentiate between isocratic elution and gradient elution. Why is gradient elution sometimes a necessary technique in HPLC? What are the steps involved in gradient elution?arrow_forwardThe identity and ratio of solvents are necessary in chromatography for achieving a good separation. What would happen if your solvent had an overly polar TLC developer? What would happen if it was overly non-polar?arrow_forward
- 5. Summarize your conclusions from the TLC simulator. Circle the correct answer in each description about TLC separation of organic compounds on silica gel plates. a) A more polar compound has a lower/higher retention factor. b) A less polar compound has a lower/higher retention factor. c) A more polar solvent causes a lower/higher retention factor. d) A less polar solvent causes a lower/higher retention factor. e) To increase the retention factor of a spot, you should add more ethyl acetate/hexane.arrow_forwardIn HPLC, why is purging or initialization being done before analysis of samples, explain.arrow_forwardWhat is the purpose of thin layer chromography lab? What is a hypothesis I can use when conducting a TLC lab and how can that hypothesis be tested?arrow_forward
- Why is it important to see the level of solvent in the developing chamber when running a TLC experiment.?arrow_forwardWhat would happen if we use longer columns and select adsorbing materials with 200-400 mesh sizes for gel filtration chromatography using a column experiment?arrow_forward2. In HPLC analysis, why Would peak area is preferred to peak height in evaluating the caffeine concentration? 3. Why was pure caffeine sample added into samples of unknown caffeine concentration in HPLC analysis?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
EBK A SMALL SCALE APPROACH TO ORGANIC LChemistryISBN:9781305446021Author:LampmanPublisher:CENGAGE LEARNING - CONSIGNMENT
EBK A SMALL SCALE APPROACH TO ORGANIC L
Chemistry
ISBN:9781305446021
Author:Lampman
Publisher:CENGAGE LEARNING - CONSIGNMENT
Thermogravimetric Analysis [ TGA ] # Thermal Analysis # Analytical Chemistry Part-11# CSIR NET/GATE; Author: Priyanka Jain;https://www.youtube.com/watch?v=p1K-Jpzylso;License: Standard YouTube License, CC-BY