The characteristics of the S. pneumoniae strains that made them particularly well suited for the researcher's experiment. Introduction: Streptococcus pneumoniae is an infectious bacterial species. Bacteria are unicellular organisms that lack a well-defined nuclear membrane. Streptococcus pneumoniae causes pneumonia in humans. The science that deals with a large-scale study of bacteria are termed as bacteriology

Question

Want to see the full answer?

Answer 1

Question

Chapter 11.1, Problem 1EQ

Summary Introduction

To explain: The characteristics of the S. pneumoniae strains that made them particularly well suited for the researcher's experiment.

Introduction: Streptococcus pneumoniae is an infectious bacterial species. Bacteria are unicellular organisms that lack a well-defined nuclear membrane. Streptococcus pneumoniae causes pneumonia in humans. The science that deals with a large-scale study of bacteria are termed as bacteriology

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

To determine the reproducibility of mutation fre-quency measurements, you do the following experiment.You inoculate each of 10 cultures with a single E. coli bac-terium, allow the cultures to grow until each contains 106cells, and then measure the number of cells in each culturethat carry a mutation in your gene of interest. You were sosurprised by the initial results that you repeated the experi-ment to confirm them. Both sets of results display the sameextreme variability, as shown in Table Q5–1. Assuming thatthe rate of mutation is constant, why do you suppose thereis so much variation in the frequencies of mutant cells indifferent cultures?

Droplet based single cell DNA sequencing uses a microfluidic platform which generates droplets encapsulating individual cells. A micrograph of such a device [Zilionis et al, Nature Protocols 2016] is presented in Figure Q3. The channels are 25 μm deep. (a) (b) Oil Figure Q3. Micrograph of the microfluidic droplet device. Scale bars are 100 µm. Adapted from Zilionis et al, Nature Protocols 2016. Red arrowheads show individual cells, and black arrows indicate flow direction. (c) RT/lysis reagents Cells Barcoding hydrogel beads A company wants to explore the design of a prototype of the device made from PDMS. Describe a suitable fabrication process, explaining the rationale behind each individual step. Schematics can be drawn to illustrate your response. You may want to refer to the datasheets at the end of the script. Testing of the prototype was successful and the company wants to explore the feasibility of manufacturing the device from glass. Describe the fabrication process for this…

Amplified target regions of four different samples were separated using gel electrophoresis. DNA fragments labeled with the isotope P32 were separated by gel electrophoresis. P32 was used to a) label fragments for imaging. b) distinguish between the fragment’s 3’ and 5’. c) observe the location of the fragments. d)speed up the rate of separation by electrophoresis