EXPERIMENT : REMOVAL OF WATER FROM MICROBIAL CELLS USING FREEZE DRYING METHOD Objective To learn on the technique of freeze drying for microbial sample preparation and preservation. Result Weight of test tube (g) -Wi 15.34 Weight of test tube with cells (g) - Ww 34.65 Amount of water removal = weight of test tube with cells – weight of test tube = 34.65 g – 15.34 g = 21.16 g QUESTION: Discuss the result and explain the freeze drying method that used in this experiment.

EXPERIMENT : REMOVAL OF WATER FROM MICROBIAL CELLS USING FREEZE DRYING METHOD Objective To learn on the technique of freeze drying for microbial sample preparation and preservation. Result Weight of test tube (g) -Wi 15.34 Weight of test tube with cells (g) - Ww 34.65 Amount of water removal = weight of test tube with cells – weight of test tube = 34.65 g – 15.34 g = 21.16 g QUESTION: Discuss the result and explain the freeze drying method that used in this experiment.

Principles Of Pharmacology Med Assist

6th Edition

ISBN:9781337512442

Author:RICE

Publisher:RICE

Chapter8: Forms Of Drugs And How They Act

Section: Chapter Questions

Problem 30RQ

See similar textbooks

Similar questions

Question: Determine the amount of dehydrated medium needed to prepare 15 butts, 20 slants, and 25 butt-slants. Include amount for 2 additional units of each as excess to compensate for compounding losses.
Order: Zosyn 0.02 gm/kg Supply: 5 gm powder vial with directions to add 10 mL of sterile water as dilutant to create the concentration of 460 mg/mL. Pt weighs 183 lbs. How much dilutant will you use to reconstitute Zosyn?
The reults for the macroscopic part: 0.30M glycerin – solution was translucent (could see text behind the test tube) 0.15M NaCl – solution was opaque (could not see text behind the test tube) 0.30M NaCl – solution was opaque (could not see text behind the test tube) 0.15M glucose – solution was translucent (could see text behind the test tube) 0.30M glucose – solution was opaque (could not see text behind the test tube) 0.30M Urea – solution was translucent (could see text behind the test tube) Results for microscopic part: 0.30M glycerin – no cells present 0.15M NaCl – normal sized cells 0.30M NaCl – crenated (shrunken and star-shaped) cells 0.15M glucose – no cells present 0.30M glucose – normal sized cells 0.30M Urea – no cells present Determine the osmolarity (hypoosmotic, isosmotic, or hyperosmotic) and tonicity (hypotonic, isotonic, hypertonic) of the following solutions.In which solutions did the osmolarity NOT match the tonicity? For those solutions, why did the osmolarity…
Briefly explain that what is the important to use immobilization techniques in biosensor?..(explain under5 points)
Experiment Title : Surface Modification of poly(vinylidene fluoride) (PVDF) membranes with untreated and treated chitosan for antibacterial performance. QUESTION: From the given title, please make a clear discussion about antibacterial perfomance
Вackground In order to determine whether a newly synthesized chemical might be a useful food preservative, the chemical was tested for its ability to inhibit bacterial growth. Control. 500 ml of cottage cheese was inoculated with 2 ml of a 24-hr culture of Pseudomonas aeruginosa and incubated at 25°C. Five hours after inoculation, a standard plate count showed there were 200 bacterial cells/ml in the cottage cheese. After 11 hours, 1600 cells/ml. After 21 hours, 50,000 cells/ml. After 27 hours, 400,000 cells/ml. Experiment. 500 ml of cottage cheese containing the preservative was inoculated with 2 ml of a 24-hr culture of P. aeruginosa. After 6 hours of incubation at 25°C, a standard plate count was performed. There were 700 bacterial cells/ml in the cottage cheese. After 14 hours, 11,000 cells/ml. After 20 hours, 90,000 cells/ml. After 28 hours, 1, 400, 000 cells/ml. Use the data and the semi-log graph paper to plot growth curves for the control and the experiment. Remember to label…
Topic: Isolation of Crude Ovalbumin from Egg White by Ammonium Sulfate Precipitation (Salting Out) The computed amount of powdered ammonium sulfate was added to the egg white sample portion byportion with constant stirring while submerged in an ice bath. The solution is expected to become moreturbid, and a white precipitate is expected to form. The resulting mixture was then filtered using a cheesecloth. The residue was discarded, and 30.0 mL of thefiltrate was brought from 40% to 60% saturation by adding the required amount of powdered ammoniumsulfate in the same manner as the previous addition. After adding ammonium sulfate, the mixture was allowed to stand with occasional stirring for 30 minutes inan ice bath. The formation of a white precipitate is expected to happen QUESTION: Explain the significance of allowing the mixture to be submerged in an ice bath for a given time.
Procedure Catalase Fill each labelled test tube (A- H) approximately 3 ml with fresh hydrogen peroxide. Add a small amount of material to be tested. perform three trials of each sample at different temperature (100C,370C, 500C) Note whether or not bubbles are produced and the rate of reaction Sample Expected Result Actual Result Interpretation Boiled Liver Bubbles Positive Boiled Leaves Bubbles Negative
INSTRUCTION: Answer the question properly Do not copy in Google, plagiarize checker will be used. QUESTION: In the preparation of Bacterial smear and Gram Staining, what is the purpose of: a) heat-fixing the smear b) prolonged application of heat (without breaking slide) on the smear?
Voges Proskauer test Does color of the medium change to red after both reagents were added and allowed to sit for 60 minutes? If yes, after about how many minutes before you can see red color?
POTATO OSMOSIS (LABORATORY EXPERIMENTATION) MATERIALS: Small basin 2 medium size potatoes (fresh) Table salt Sugar Distilled water (Wilkins or H2Zero) PROCEDURE: A. POTATOES Cut the potatoes to half, making 4 pcs of potatoes Cook one of the half potatoes and set aside the 3 other potatoes Label the cooked potato as letter B. MAKING A CAVITY Make a cavity of each half potato Label the raw potato as A B and C In potato A place salt on the cavity In potato B place sugar in the cavity Leave the potato C empty. Place sugar on the cavity of potato D C. POTATO OSMOSIS - Place distilled water in the basin and arranged the potatoes inside the basin. Leave it for 1hr. Observe after an hour. Do not mind the color of the potato. QUESTIONS: 1. What is your observation from potato A to D? 2. What can you conclude by comparing potato A and potato B? 3. What can you conclude by comparing potato A and potato C?
POTATO OSMOSIS (LABORATORY EXPERIMENTATION) MATERIALS: Small basin 2 medium size potatoes (fresh) Table salt Sugar Distilled water (Wilkins or H2Zero) PROCEDURE: A. POTATOES Cut the potatoes to half, making 4 pcs of potatoes Cook one of the half potatoes and set aside the 3 other potatoes Label the cooked potato as letter B. MAKING A CAVITY Make a cavity of each half potato Label the raw potato as A B and C In potato A place salt on the cavity In potato B place sugar in the cavity Leave the potato C empty. Place sugar on the cavity of potato D C. POTATO OSMOSIS - Place distilled water in the basin and arranged the potatoes inside the basin. Leave it for 1hr. Observe after an hour. Do not mind the color of the potato. QUESTIONS: 1. What can you conclude by comparing potato A and potato D? 2. The liquid in the cavity of some potatoes came from where? 3. What is your conclusion about the experiment?