The point of beginning of stage II creep.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 7CQ

To determine

The point of beginning of stage II creep.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

For a bronze alloy, the stress at which plastic deformation begins is 275 MPa (40,000 psi), and the modulus of elasticity is 115 GPa (16.7 x106 psi). (a) What is the maximum load that may be applied to a specimen with a cross-sectional area of 325 mm2 (0.5 in.2) without plastic de- formation? (15pts)(b) If the original specimen length is 115 mm (4.5 in.), what is the maximum length to which it may be stretched without causing plastic deformation?(15pts)

1) Please indicate in the stress-strain diagram given below the stress levels that can cause creep. 2) The effect of an increase in service temperature or applied stress is to shift the 3) Dislocation density . In Region number (...) while creep deformation is increasing at an increasing rate. 4) Dislocation density is remains constant in Region number (.) while the creep rate is increasing. 5) For some applications the amount of creep in Region number (.) is taken as the design criteria.

At an axial load of 25 kN, a 50-mm-wide by 15-mm-thick polyimide polymer bar elongates 3.1 mm while the bar width contracts 0.26 mm. The bar is 220 mm long. At the 25-kN load, the stress in the polymer bar is less than its proportional limit Determine (a) the modulus of elasticity. (b) Poisson's ratio. (c) the change in the bar thickness. Answers: (a) E- (b) v- (c) Audness GPa mm