Physics of Everyday Phenomena
9th Edition
ISBN: 9781259894008
Author: W. Thomas Griffith, Juliet Brosing Professor
Publisher: McGraw-Hill Education
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 11, Problem 11E
A typical electric refrigerator (see fig. 11.9) has a power rating of 500 W, which is the rate (in J/s) at which electrical energy is supplied to do the work needed to remove heat from the refrigerator. If the refrigerator releases heat to the room at a rate of 800 W, at what rate (in watts) does it remove heat from the inside of the refrigerator?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
As a gasoline engine is running, an amount of gasoline containing 15,200 J of chemical potential energy is burned in 1 s. During that second, the engine does 3,800 J of work.
(a)
What is the engine's efficiency (in percent)?
(b)
The burning gasoline has a temperature of about 5,000°F (3,000 K). The waste heat from the engine flows into air at about 86°F (303 K). What is the Carnot efficiency (in percent) of a heat engine operating between these two temperatures?
A 361-W heat pump operates between the ground, whose temperature is 6.2, and the interior of a
house at 20.1.
What is the theoretical maximum amount of heat per hour that the heat pump can supply to the
house?
Express your answer in MJ, to at least one digit after the decimal point.
An engineer on Mars operates a motor that loses 45 kilojoules [kJ] of energy as heat in 20 minutes [min] and has an input power rating of 0.29
horsepower [hp]. Determine the efficiency of the motor expressed as a percentage.
Click the icon to view the table of common derived units in the SI system.
Click the icon to view the conversion table.
Click the icon to view SI prefixes (numbers greater than one.)
The thermal conductivity is
%. (Round your answer to one decimal place.)
Chapter 11 Solutions
Physics of Everyday Phenomena
Ch. 11 - Prob. 1CQCh. 11 - Prob. 2CQCh. 11 - In applying the first law of thermodynamics to a...Ch. 11 - Is the total amount of heat released by a heat...Ch. 11 - From the perspective of the first law of...Ch. 11 - Which motor in a hybrid vehiclethe electric or...Ch. 11 - Prob. 7CQCh. 11 - Prob. 8CQCh. 11 - Prob. 9CQCh. 11 - Prob. 10CQ
Ch. 11 - Prob. 11CQCh. 11 - Is it possible for the efficiency of a heat engine...Ch. 11 - Can a Carnot engine operate in an irreversible...Ch. 11 - Does a gasoline-burning automobile engine operate...Ch. 11 - Which would have the greater efficiencya Carnot...Ch. 11 - If we want to increase the efficiency of a Carnot...Ch. 11 - Is a heat pump the same thing as a heat engine?...Ch. 11 - Is a heat pump essentially the same thing as a...Ch. 11 - When a heat pump is used to heat a building, where...Ch. 11 - Is it possible to cool a closed room by leaving...Ch. 11 - Prob. 21CQCh. 11 - Prob. 22CQCh. 11 - Prob. 23CQCh. 11 - Prob. 24CQCh. 11 - Which has the higher entropy, a deck of cards in...Ch. 11 - A hot cup of coffee is allowed to cool down, thus...Ch. 11 - When a substance freezes, the molecules become...Ch. 11 - Which would normally have the greater thermal...Ch. 11 - In what ways is a nuclear power plant similar to a...Ch. 11 - What is the distinction between high-grade heat...Ch. 11 - Prob. 31CQCh. 11 - Prob. 32CQCh. 11 - Is an automobile engine a perpetual-motion...Ch. 11 - Prob. 34CQCh. 11 - Prob. 35CQCh. 11 - The water draining from the bottom of the pond...Ch. 11 - Prob. 37CQCh. 11 - In one cycle, a heat engine takes in 1200 J of...Ch. 11 - A heat engine with an efficiency of 28% does 700 J...Ch. 11 - In one cycle, a heat engine takes in 800 J of heat...Ch. 11 - A heat engine with an efficiency of 35% takes in...Ch. 11 - In one cycle, a heat engine does 700 J of work and...Ch. 11 - A Carnot engine takes in heat at a temperature of...Ch. 11 - A Carnot engine takes in heat from a reservoir at...Ch. 11 - A Carnot engine operates between temperatures of...Ch. 11 - A heat pump takes in 450 J of heat from a...Ch. 11 - In each cycle of its operation, a refrigerator...Ch. 11 - A typical electric refrigerator (see fig. 11.9)...Ch. 11 - A typical nuclear power plant delivers heat from...Ch. 11 - An ocean thermal-energy power plant takes in warm...Ch. 11 - An engineer designs a heat engine using flat-plate...Ch. 11 - Suppose that a typical automobile engine operates...Ch. 11 - Prob. 2SPCh. 11 - A Carnot engine operating in reverse as a heat...Ch. 11 - In section 11.3, we showed that a violation of the...Ch. 11 - Suppose that an oil-fired power plant is designed...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- An electrical coil is used to heat 20.0 kg of water in a closed well-insulated vessel. The water is initially at 25°C and 1 atm. The coil delivers a steady 3.25 kW of power to the vessel and its contents, 97% of which goes into heating the water. Determine how long it will take to heat the water to its normal boiling point. Answer in minutes with 3 sig. fig's in decimal format. Show all work starting from the full form of the appropriate balance and justifying any terms being zero or negligible. Cite any data sources used.arrow_forwardAir conditioners sold in the United States are given a seasonal energy-efficiency ratio (SEER) rating that consumers can use to compare different models. A SEER rating is the ratio of heat pumped to energy input, similar to a COP but using English units, so a higher SEER rating means a more efficient model. You can determine the COP of an air conditioner bydividing the SEER rating by 3.4. For typical inside and outsidetemperatures when you’d be using air conditioning, estimate the theoretical maximum SEER rating of an air conditioner. (New air conditioners must have a SEER rating that exceeds 13, quite a bit less than the theoretical maximum, but there are practical issues that reduce efficiency.)arrow_forwardAn electric motor running a large copier draws 2.7 kW. The motor runs 3 hours in a day. How much heat is produced in the space PER DAY as a result of the copier’s operation? Convert the result to Btu.arrow_forward
- Consider the thermodynamic process, A->B->C->A shown above. The heat absorbed during A->B is 591J. If the change in internal energy during B->C is 4146J, What is the change in internal energy in SI units during C->A? Express only the number of your answer with 4 significant figures.arrow_forwardA power plant has a power output of 1285 MWand operates with an efficiency of 32.4 percent. Excess energy is carried away as heatfrom the plant to a nearby river that has aflow rate of 1.1 × 106kg/s.How much energy is transferred as heat tothe river each second?Answer in units of J/s.arrow_forwardWhen a certain type of coal is burned at a power plant, 22.6 ×106×106 joules per kilogram are released that is subsequently used to boil water and produce steam. The steam then does work on the turbine to produce electricity. If power is produced at a rate of 480 megawatts as 102000 kilograms of coal are burned per hour, what is the efficiency of the power plant?arrow_forward
- The first law of thermodynamics relates the heat transfer into or out of a system to the change of internal and the work done on the system. How much heat, in joules, is transferred into a system when its internal energy decreases by 165 J while it was performing 27.5 J of work?arrow_forwardA PHYS 1510 student was working on a robotics project. The joints on the machine they were building were powered by pistons. Based on how hot the machine was getting, the student was able to figure out that 2.34 J of thermal energy was produced by every piston every time the piston was fully extended to 0.4064 m. What was the force of friction that the piston experienced during every extension? Assume friction is the only source of thermal energy. Include units in Sl.arrow_forwardA gas is compressed inside a cylinder. An average force of 27 N acts to move the piston 2.5 m. During the compression, 8 J of heat are conducted away from the gas. What is the change in internal energy of the gas? Calculate answer to one decimal.arrow_forward
- At a certain location, the solar power per unit area reaching Earth’s surface is 200 W/m2, averaged over a 24-hour day. If the average power requirement in your home is 3 kW and you can convert solar power to electric power with 10% efficiency, how large a collector area will you need to meet all your household energy requirements from solar energy? (Will a collector fit in your yard or on your roof?)arrow_forwardAnswer the following ASAP: A gasoline engine has a power output of 200 kW. Its thermal efficiency is 35.0%. (a) How much heat must be supplied to the engine per second? (b) How much heat is discarded by the engine per second?arrow_forwardAn automobile engine converts heat into work via a cycle. The cycle must finish exactly where it started, so the energy at the start of the cycle must be exactly the same as the energy at the end of the cycle. If the engine absorbs 226 J of heat per cycle, how much work can it do per cycle?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
The Second Law of Thermodynamics: Heat Flow, Entropy, and Microstates; Author: Professor Dave Explains;https://www.youtube.com/watch?v=MrwW4w2nAMc;License: Standard YouTube License, CC-BY