Calculate the active power, reactive power, power factor, Reactive factor if: v=100 cos (wt+150) V and i=4 cos (wt-1050) V Note: Enter the angle in radians. (rad * pi/180) Consider V and I given in the problem represents Vrms and Irms Active Power, P = Vrms Irms cos(θv – θi) Reactive Power, Q = Vrms Irms sin(θv – θi) Power factor (pf) = cos(θv – θi) Reactive factor (rf) = sin(θv – θi)

Calculate the active power, reactive power, power factor, Reactive factor if: v=100 cos (wt+150) V and i=4 cos (wt-1050) V Note: Enter the angle in radians. (rad * pi/180) Consider V and I given in the problem represents Vrms and Irms Active Power, P = Vrms Irms cos(θv – θi) Reactive Power, Q = Vrms Irms sin(θv – θi) Power factor (pf) = cos(θv – θi) Reactive factor (rf) = sin(θv – θi)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Similar questions

A voltage wave of 250 kHz has a Vmax-5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This voltage waveform has been applied across a 2.5 µH inductor for a very long time so that steady state has been achieved. Diagrams of the wave parameters and circuit are shown in this figure: L What is the average voltage of this wave? Average voltage = 35 V Voltage (arb, unit) 1.25 Minimum current: -3.5€ Amps 1 0.75 0.5 0.25 0 4.25 05 Have you integrated the wave over full cycle? 4.75 4 -1.25 Vmax 0.5 Vmin What is the average current flowing through the inductor? Average current = 3.56 A 15 Period/s On average, there is no power consumed by the inductor. Have you considered this? What are the maximum and minimum currents that flow through the inductor? Maximum current: 0.50 Amps D= 25 TH TH Have you used the relationship for current and voltage in an inductor? Have you considered the slope of the current wave?
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
The 60 Hz AC source and 240 V rms voltage provides a power of 5000 VA for a load with a lagging power factor of 0.85. Determine the reactive power in the capacitor and the value of the capacitor that must be connected in parallel with the load to bring the power factor to 0.92 inductive
2. A series RL circuit has voltage and current equations of e = 141.42 sin 2n30t + 141.42 sin 2n90t volts and i = 9.8 sin (2n30t - 30°) + 5.66 sin (2n90t - 60°) amperes. Determine the inductance L. A. 92.5 mH B. 38.3 mH C. 27.22 mH D. 83.49 mH
Determine the rms current in the figure for Vrms = 16 V and C = 74µF V f=10 kHz
Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below. Measure the voltage Vr and current I from the voltage across R and find the phase angle between the Vi and I.
If the maximum value of an alternating voltage with a frequency of 35 Hz is 100 V, write the equation for this voltage. A u= 70,7.Sin2,198t B u= 63,6.Sin35t C u= 63,6.Sin35t D u= 100.Sin219,8t E u= 63,6.Sin35t
Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine the following: i. Ims ii. Iavg iii. Ip iv. Ipp 10V 1.0 ΚΩ Figure.Q.4.a
For the following voltage and current phasors in rms Voltage magnitude in (V) is 136 and phase angle in degree is 18 Current magnitude in (A) is 0.7 and phase angle in degree is 69 The power factor is: O 0.052 (lagging) O 0.951 (leading) O 0.777 (lagging) O 0.629 (lagging) O 0.629 (leading) O0.777 (leading)
"If lab is equal to 595.8252306 and lb is 344296, the phase sequence is:" O POSITIVE O NEGATIVE
Convert the following phasors into sinusoidal waveforms a. Vi = 20+j15 V, w= 10 rad/s b. V1 = 6(8-j3) V, w= 20K rad/s c. I1 = 12-j5+4/j A, w= 3K rad/s d. I 330+j810 mA, w= 50 rad/s 2200-j560
A 15ohms resistor connected in parallel with an impedance of 8 - j2 across an AC source. The entire circuit takes a total average power of 2000 watts. What is the average power in the 15ohms resistor?