Answered: Calculate the Apparent power (complex…

Calculate the Apparent power (complex in VA), real power (real part in W) and reactive power (imaginary part in VAr) in each of the component below: -jpost35052 200230 v 202 V. 4052

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: Analogue Electronics II Design 2 different configurations of active band pass filter for the freque...

A: Given: A 2 different configurations of active bandpass filter for the frequency with a bandwidth of ...

Q: Convert the point P(3,4,5) from cartesian to spherical co-ordinates

Q: 4. An incandescent lamp, rated at 100 W, gives a certain amount of light when placed across the 120 ...

Q: Question: Given the following circuit (see pic) a. List and identify the resistors that are in serie...

Q: Four charges form an isosceles trapezoid: Q1 = +2C is located at vertex X; Q2 = -3C is located at ve...

Q: 30 k2 20 k2 50 k2 10 kN Reg 40 k2. 20 kN 40 kN • What is the value of equivalent resistance Reg? 30 ...

Q: へ97 7る? 4323 8. て 22 て

A: Mesh Analysis Mesh analysis is also called loop analysis. To determine unknown currents in the circu...

Q: Question 1f: Convert the following hexadecimal number to decimal: АCEF 44271 Question 1g: Determine ...

A: In Hexadecimal code A = 10 B = 11 C = 12 D = 13 E = 14 F = 15

Q: Consider a step down converter supplied by a DC power source of magnitude Vs 100 Vv. The switching p...

A: using expression for peak to peak ripple voltage of step down converter calculate critical value of ...

Q: E2.7 Find Ix and I, in Fig. E2.7. 1.5Ix 6 mA 1 mA Ix Figure E2.7

A: Circuit diagram is given as, Applying node at point 1. Ix-6+I1=0Ix+I1=6...........eqn 1

Q: 5. What will be the output of the following code? for i=1 : 3 i=i-1 end

A: The following lines of code are given: for i=1:3 i=i-1 end From the given options, the correct optio...

Q: g(t) = A sinc(2Wt)

Q: The given circuit contains a dependent current source wherein both the magnitude and direction is de...

A: Determine the value and sign of the voltage V1 for the given circuit ?

Q: why does the value of the current increases when the value of the voltage is increased?

A: Yes it's true the value of the current increases when the value of the voltage is increased. accord...

Q: Following system of linear equation has been obtained after per- forming loop variable analysis on a...

A: A mesh is defined at a loop which does not contain any other loops within it. To apply mesh analysis...

Q: 23.57 * An Ionic Crystal. Figure P23.57 Figure P23.57 shows eight point charges arranged at the come...

A: GIVEN: a cube at the corner charge -q and +q are arranged FIND: (a) calculate the potential energy ...

Q: 2) The circuit shown below is at steady state before the switch closes. t = 0 in) Find the 2nd order...

Q: nstruction: Create a spreadshneet file named LastName_FirstName_PrelimExam_Part2 using Microsoft Exc...

A: You can type formulas in excel sheets to get the values of all the columns at once. First, you need ...

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to ...

Q: An RC network has values of R = 1.2 kN and C = 0.22 µF. Find fe || Select your answer. 3.79 kHz 1.89...

Q: Find V, in the circuit of Fig. 13.40.

A: From the following figure, Vo=8I3 .....(1)Apply KVL in loop I1240=4I1+V1 ......(2)Apply KVL in loop ...

Q: Find /and Vab in the circuit below 10 V 30 V 8 V

Q: A single phase transmission line is delivering 450 kVA load at 12 kV. Its resistance is 4.5 and indu...

A: Given,R=4.5ΩXL=6ΩcosϕR=0.9lagV.R.=Vs-VRVR×100 .....(1)Sending end voltage, Vs=VRcosϕR+IR2+VRsinϕR+IX...

Q: A B T2 1 1 1 1 1 1 1 1

A: Given truth table of the boolean function

Q: Design a voltage regulator that will maintain an output voltage of 20 V across a 1-k-ohm load with a...

A: In this questions given multipart but i have solved only three parts A most typically used to conv...

Q: Given a silicon diode current of 6mA and reverse current 1nA, find the forward diode voltage VD in v...

A: Given a silicon diode current of 6mA and reverse current 1nA, find the forward diode voltage VD in v...

Q: A 400V, 3-phase Induction motor has output of 30HP and operates at power factor of 0.85 lagging with...

A: Given: Voltage, V=400 V Output power Pout=30 HP Power factor, 0.85 Efficiency, 87% To find: Value o...

Q: what industry does cleaning equipment for electronic devices belong?

A: Scrubbers are used to remove stains from areas with hard floors. They're perfect for large commercia...

Q: Solve Sor i;lt) and deter m DC value of ux (t). 3. -er mine ix 10 COS 20EV 30r ZA 10n

A: The solution is given below

Q: Find the voltage, current and power gains of the amplifier circuit.

A: The given amplifier is a common collector amplifier. The value of various gain of the amplifier can ...

Q: 1. For the fixed-bias configuration of Fig. 4.118, determine: a. b. Ilcơ с. d. Vc- e. VR. f. VẸ- 16 ...

Q: For the network of Figure Vcc = 16 V a. Determine re b. Calculate Zi and Zo C. Find Av 3.9 k2 d. Rep...

Q: Question 2. Questions regarding the 4-bit right shit register built in the experimental part. a. How...

Q: a) Given la50 A and Va 0.7 V for the circuit in Fig. Q2a, perform the following 20 Volts 3k 20 k Fig...

Q: Use Kirchhoff’s Law to find the power dissipated in the 5Ω resistor, determine the currents I1,I2,I3...

A: GIVEN: A circuit diagram R1=2ΩR2=5ΩR3=2ΩR4=20ΩR5=10Ω FIND: the value of ...

Q: (a) Applying the Kirchhoff's second law, show that the system of differential equa- tions is dle dl,...

A: This question comes under electrical circuit theory . It is a problem related to voltage drop across...

Q: 3 21.38 A point charge is placed at each corner of a square with side length a. All charges have mag...

A: In this question, We need to determine the electric field due to charge put at the corner of the sq...

Q: Problem: The 20 V source shown below supplies 4 W of power to the rest of the circuit. The alue of v...

Q: - Find the value

Q: Justify: why low attenuation and immunity to electromagnetic interference are the disadvantages of a...

A: ATTENUATION Strength of the signal fall with distance over transmission medium .They extent to atte...

Q: Applying the Kirchhoff's second law, show that the system of differential equa- tions is (a) dl dl. ...

A: According to the question, we need to solve the circuit for part (a).

Q: 3.8 In the circuit shown in the image below, if V1 = 64 V and R1 = 19 Q, determine voltage vo in V. ...

Q: +2

A: The given figure is shown below:

Q: Task 2: Your supervisor asked you to analyse the following signal processing system that exists in a...

A: i.roots of the equation are s = -1,-2,-3,-4,-5

Q: A corporation will make the following disbursements: a. P 50, 000 on December 31, 1991 b. P 100,000 ...

Q: In the circuit given below, h = 125 mA and /2 = 45 mA. Write the node-voltage equations by inspectio...

Q: Derive equation for E1 and E2

A: The circuit given is shown below:

Q: For a unity feedback control system with controller G.(s) = K and plant Gp(s) = 1/[s(s+K1)], (a) %3D...

A: The feedback is an electric signal that is sent from the output to the controller, allowing the cont...

Q: In the Chapman-Enksog predictive model of conductivity of gases, increasing the temperature from 300...

A: Chapman–Enksog theory's core ideas may be applied to a wide range of physical models, including gas ...

Q: different configurations shown in

Question

4. Calculate the Apparent power (complex in VA), real power (real part in W) and reactive
power (imaginary part in VAr) in each of the component below:
-j2052
350
200230v
40s2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Reduce to its simplest form using msop
2_53528980697... -> For the circuit shown below, detemine the voltage of the -j10 2 capacitive reactance. -j5 0 ILOA(T) ==j102 jlon is Q 102 O 0.5L-90 52 A.
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of lohm and an inductance of 10mH, find the source voltage. output 5A -current 2A ten toff
0 Consider the image below. Derive an expression for E as a function of the excitation voltage E¡ and the resistances R₁ and R₂. You may have to use Ohm's law and/or Kirchhoff's laws. Ei allt R1 Eo 0 R2
Given the following find: The reactive power dissipated by the source is (in Vars) The apparent power dissipated by the source is (in VA)
A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of 50MVA and 10kV. O 0.606 p.u. O 0.506 p.u. O 0.806 p.u. O 0.706 p.u.
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of 1ohm and an inductance of 10mH, find the source voltage. 5A 2A ton toff output _current
low voltage systems What is the general reason for selecting the capacitor voltage with a value greater than 400 V (such as 415,445 V) in Reactive Power Compensation? a) Reduce losses b) Harmonics C)Current decrease d) Voltage drop
A FET has a gm = 6000 mS. Determine the rms drain current for each of the following rms values of Vgs. (a) 10 mV (b) 150 mV
Choose the % derating factor of the string which is having 8 number of SCR connected in series to withstand a DC voltage of 1864 V and steady state voltage rating of 803 V. O a. 5.38 Ob. 14.51 Oc 70.98 O d. 29.02
15. You are working on a power factor correction installation, and you notice with a clip-on ammeter as you add in capacitance the current drops, you add more capacitance and the current drops, you add more capacitance the current rises. How do you know when you are at unity power factor?