Volume of 0 .750-carat diamond has to be calculated. Concept Introduction: Density is a physical property and specific for each substance under fixed conditions. It is defined as the ratio of mass of a substance to the volume of the substance. They are usually expressed as grams per cubic centimeter ( g/cm 3 ) for solids and grams per milliliter ( g/mL ) for liquids. Density = mass volume From the above formula volume can be calculated if the mass and density is known by rearranging the formula as shown below; Volume = mass density

Question

Want to see the full answer?

Answer 1

Question

Chapter F, Problem A.19E

Interpretation Introduction

Interpretation:

Volume of 0.750-carat diamond has to be calculated.

Concept Introduction:

Density is a physical property and specific for each substance under fixed conditions. It is defined as the ratio of mass of a substance to the volume of the substance. They are usually expressed as grams per cubic centimeter (g/cm3) for solids and grams per milliliter (g/mL) for liquids.

Density = massvolume

From the above formula volume can be calculated if the mass and density is known by rearranging the formula as shown below;

Volume = massdensity

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

51. A concentrated perchloric acid solution is 65.8% HClO4 by mass and its density is 1.68 g mL−1. What volume (in litres) of the concentrated perchloric acid solution is needed to make 1.81 L of 2.62 mol L−1 HClO4(aq)?

One way the U.S. Environmental Protection Agency (EPA) tests for chloride contaminants in water is by titrating a sample of silver nitrate solution. Any chloride anions in solution will combine with the silver cations to produce bright white silver chloride precipitate. Suppose an EPA chemist tests a 200. mL sample of groundwater known to be contaminated with iron(III) chloride, which would react with silver nitrate solution like this: FeCl3(aq) + 3 AgNO3(aq) 3 AgCl(s) + Fe(NO3),(a9) The chemist adds 56.0 mM silver nitrate solution to the sample until silver chloride stops forming. She then washes, dries, and weighs the precipitate. She finds she has collected 2.8 mg of silver chloride. Calculate the concentration of iron(III) chloride contaminant in the original groundwater sample. Be sure your answer has the correct number of significant digits. mg L Submit Assignment Continue Accessibility Privacy O 2020 McGraw-Hill Education. All Rights Reserved. Terms of Use 888 %23 5 6 2 3 E R. G…

A geochemist measures the concentration of salt dissolved in Lake Parsons and finds a concentration of 25.·gL−1 . The geochemist also measures the concentration of salt in several nearby non-isolated lakes, and finds an average concentration of 4.2·gL−1 . Assuming the salt concentration in Lake Parsons before it became isolated was equal to the average salt concentration in nearby non-isolated lakes, calculate the percentage of Lake Parsons which has evaporated since it became isolated. Round each of your answers to 2 significant digits.