The torque required for the material to become fully plastic. The permanent angle of twist of the tube.

Question

Want to see the full answer?

Answer 1

Question

Chapter 5.10, Problem 140P

To determine

The torque required for the material to become fully plastic.

The permanent angle of twist of the tube.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A motor is used to drive a gear assembly at 200 rpm. The main gear is in the center of a 1 m long (0.5 m to the left and right of the gear) 50 mm diameter solid circular shaft, and power is taken from the two shaft ends. 25 kW is taken on the left end and an unknown amount of power is taken at the right end. the torque to the left side of the gear is? maximum shear stress to left of gear? If the maximum shear stress on the shaft to the right of the gear is 125 MPa, approximately how much power is being drawn off from the right side of the shaft? The shaft can be made from 6061-T6 aluminum. It has adequate strength to withstand the loading conditions in the scenario, including the loading on the right side of the shaft. true or false?

The answer is 1290N, but I am not entirely sure how they got there. However, I noticed that when I calculated the torques for the person and that of the ladder, my answer would be correct if I multiplied by sin(60) or cos (30) instead. Using the sum of these values, I would divide it by the length of the ladder and sin(30), which would give the correct answer, but I'm a bit confused as to why I need to take sin(60) or cos(30) to calculate the torques for the weight of the ladder and the human, but then use sin(30) when calculating the torque for the perpendicular force. I would appreciate a work through of the problem and some explanation for my difficulties above, thank you.

Please help me solve this. I need answer asap. Tysm!! A flanged bolt coupling consists of eight d-mm diameter steel bolts on a bolt circle 275 mm in diameter, and four d-mm diameter steel bolts on a concentric bolt circle 193 mm in diameter. If the torque that can be applied is 9821 Nm without exceeding a shearing stress of 54.36 MPa in the bolts, what is the diameter of the bolts? Round off the final answer to two decimal places.