The indication of fatigue-crack propagation on a fractured surface.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 22CQ

To determine

The indication of fatigue-crack propagation on a fractured surface.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

An aircraft component is fabricated from an aluminum alloy that has a plane strain fracture toughness of 34 MPaym. It has been determined that fracture results at a stress of 221 MPa when the maximum (or critical) internal crack length is 2.94 mm. a) Determine the value of Yona for this same component and alloy at a stress level of 287 MPa when the maximum internal crack length is 1.47 mm. MPaym

(b) An aluminium plate (100 mm width x 300 mm height x 4 mm thick) with a centre-crack is subjected to a mode-l service load of 40 kN. Assume that the fracture toughness of the material is 24 MPa Vm and Y-1.0. (ii) What is the safety factor on crack length? Assume that the yield strength of aluminium is 425 MPa.

A ceramic part is used under a complete reverse cyclic stress with a stress amplitude (S) of 250 MPa. The yield strength and fracture toughness of materials is 550 MPa and 12.5 MPa*sqrt(m), respectively. Y is 1.4. What is the critical surface crack length?