The reason behind the stoppage of the liquid–vapor boundary line in the phase diagram of a substance at a certain point is to be explained. Concept introduction: A phase diagram is a graph that represents the solid, liquid, and gaseous phases of a substance at different pressures and temperatures. The lines are the boundaries between the two phases and represent the conditions under which the two phases are in equilibrium.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 109AP

Interpretation Introduction

Interpretation: The reason behind the stoppage of the liquid–vapor boundary line in the phase diagram of a substance at a certain point is to be explained.

Concept introduction:

A phase diagram is a graph that represents the solid, liquid, and gaseous phases of a substance at different pressures and temperatures. The lines are the boundaries between the two phases and represent the conditions under which the two phases are in equilibrium.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

6.The diagram below is an example of Liquid-Vapor(LV) Pressure (P vs Mole Fraction).Fill out the question marks with correct number of degrees of freedom. LV Pressure – Composition (LV – PZ) Phase Diagram | How to read this phase diagram: XA = 0 Xe = 1 P = Pg Xx = 1 • We can designate the fraction of A and B in the liquid be XA and Xa, while the fraction of A and B in the gas phase be ya and Yg- XB = 0 F=? Liquid Phase F=? • Z, is the composition of A: • Below the vapor curve, or the bubble curve, A is pure vapor, and Z, = VA • Above the liquid curve, or the dew curve, A is pure liquid, and Z, = Xa P P= P F=? Vapor Phase YA = 1 YA = 0 Ya = 1 ZA Ys = 0

The figure below is the phase diagram of a purse substance. (I), (II) and (III) are the 3 phases of the substance, and there are 3 phase boundaries. Based on this phase diagram, which of the following statement is (are) true about this substance? a) Below 0.7 atm, the liquid phase of this substance can be formed by carefully adjusting temperature. b) The substance can be transformed from liquid to solid by applying pressure. c) The normal boiling point is between 190 K and 210 K. Pressure (in atm) 1.4 1.3 1.2 1.1 1.0 0.9 0.8 (III) 0.7 0.6- 0.5- 120 140 160 180 200 220 T (in Kelvin) O a) only O b) only O c) only O a) and b) O b) and c) O c) and a) O a), b) , and c) O None of the 3 statements is true.

(a) Consider a substance where the intermolecular forces hold the molecules in fixed rigid positions. What is the process called when enough heat has been added to the substance so that the molecules begin to flow? (b) Consider a substance where the intermolecular forces hold the molecules in close contact with each other, but the molecules can flow. What is the process called when enough heat has been added to the substance so that the molecules escape each other? (c) Consider a substance where the intermolecular forces hold the molecules in fixed rigid positions. What is the process called when enough heat has been added to the substance so that the molecules can escape each other?