Concept explainers
(a)
Interpretation:
The flow-chart for the given process is to be drawn and labelled. Also, the degree of freedom analysis is to be done on the given system using atomic balance.
Concept introduction:
A flowchart is the complete representation of a process through boxes or other shapes which represents process units and arrows that represents the input and output of the process. The flowchart must be fully labelled to infer important data about the process involved.
Degree of freedom analysis is the procedure to analyze any missing information needed for material balance calculations. The procedure involves complete labelling of the flowchart representing the process and then determining number of unknown variables
Mathematically, degree of freedom
(b)
Interpretation:
The molar flow of oxygen supplied to the boiler is to be calculated.
Concept introduction:
Stoichiometry is the calculation of the reactants and the products involved in aa chemical reaction. It is based on the law of mass conservation. According to the stoichiometry, total mass of the reactants equals the total mass of the products.
(c)
Interpretation:
The remaining molar flowrates in the given process are to be determined along with the molar composition of the flue gas on a dry basis.
Concept introduction:
Stoichiometry is the calculation of the reactants and the products involved in aa chemical reaction. It is based on the law of mass conservation. According to the stoichiometry, total mass of the reactants equals the total mass of the products.
Mole fraction
Here,
Molar composition on a dry basis means that the composition of any mixture free from its moisture contents.
(d)
Interpretation:
Two safety or environmental issues that must be considered in the construction and operation of such plants are to be listed.
(e)
Interpretation:
Two pros and two cons of using pure oxygen despite of air are to be listed.
![Check Mark](/static/check-mark.png)
Want to see the full answer?
Check out a sample textbook solution![Blurred answer](/static/blurred-answer.jpg)
Chapter 4 Solutions
ELEMENTARY PRINCIPLES OF CHEM. PROCESS.
- A rebreathing gas mask contains potassium superoxide, KO2, which reacts with moisture in the breath to give oxygen. 4KO2(s)+2H2O(l)4KOH(s)+3O2(g) Estimate the grams of potassium superoxide required to supply a persons oxygen needs for one hour. Assume a person requires 1.00 102 kcal of energy for this time period. Further assume that this energy can be equated to the heat of combustion of a quantity of glucose, C6H12O6, to CO2(g) and H2O(l). From the amount of glucose required to give 1.00 102 kcal of heat, calculate the amount of oxygen consumed and hence the amount of KO2 required. The ff0 for glucose(s) is 1273 kJ/mol.arrow_forwardWhen one mole of ethylene gas, C2H4, reacts with fluorine gas, hydrogen fluoride and carbon tetrafluoride gases are formed and 2496.7 kJ of heat are given off. What is Hf for CF4(g)?arrow_forwardWater gas, a mixture of carbon monoxide and hydrogen, is produced by treating carbon (in the form of coke or coal) with steam at high temperatures. (See Study Question 83.) C(s) + H2O(g) CO(g) + H2(g) Not all of the carbon available is converted to water gas since some is burned to provide the heat for the endothermic reaction of carbon and water. What mass of carbon must be burned (to CO2 gas) to provide the energy to convert 1.00 kg of carbon to water gas?arrow_forward
- The carbon dioxide exhaled in the breath of astronauts is often removed from the spacecraft by reaction with lithium hydroxide 2LiOH(s)+CO2(g)Li2CO3(s)+H2O(l) Estimate the grams of lithium hydroxide required per astronaut per day. Assume that each astronaut requires 2.50 103 kcal of energy per day. Further assume that this energy can be equated to the heat of combustion of a quantity of glucose, C6H12O6, to CO2(g) and H2O(l). From the amount of glucose required to give 2.50 103 kcal of heat, calculate the amount of CO2 produced and hence the amount of LiOH required. The H for glucose(s) is 1273 kJ/mol.arrow_forwardMethane, CH4, can be converted to methanol, which, like ethanol, can be used as a fuel. The energy level diagram shown here presents relationships between energies of the fuels and their oxidation products. Use the information in the diagram to answer the following questions. (The energy terms are per mol-rxn.) (a) Which fuel, methanol or methane, yields the most energy per mole when burned? (b) Which fuel yields the most energy per gram when burned? (c) What is the enthalpy change for the conversion of methane to methanol by reaction with O2(g)? (d) Each arrow on the diagram represents a chemical reaction. Write the equation for the reaction that converts methane to methanol.arrow_forwardAlthough the gas used in an oxyacetylene torch (Figure 5.7) is essentially pure acetylene, the heat produced by combustion of one mole of acetylene in such a torch is likely not equal to the enthalpy of combustion of acetylene listed in Table 5.2. Considering the conditions for which the tabulated data are reported, suggest an explanation.arrow_forward
- Chlorine dioxide, ClO2, is a reddish yellow gas used in bleaching paper pulp. The average speed of a ClO2 molecule at 25C is 306 m/s. What is the kinetic energy (in joules) of a ClO2 molecule moving at this speed?arrow_forwardInsoluble AgCl(s) precipitates when solutions of AgNO3(aq) and NaCl(aq) are mixed. AgNO3(aq) + NaCl(aq) AgCl(s) + NaNO3(aq) rH = ? To measure the energy evolved in this reaction, 250. mL of 0.16 M AgNO3(aq) and 125 mL of 0.32 M NaCl(aq) are mixed in a coffee-cup calorimeter. The temperature of the mixture rises from 21.15 C to 22.90 C. Calculate the enthalpy change for the precipitation of AgCl(s), in kJ/mol. (Assume the density of the solution is 1.0 g/mL and its specific heat capacity is 4.2 J/g K.)arrow_forwardWhen one mol of KOH is neutralized by sulfuric acid, q=56 kJ. (This is called the heat of neutralization.) At 23.7C, 25.0 mL of 0.475 M H2SO4 is neutralized by 0.613 M KOH in a coffee-cup calorimeter. Assume that the specific heat of all solutions is 4.18J/gC, that the density of all solutions is 1.00 g/mL, and that volumes are additive. (a) How many mL of KOH is required to neutralize H2SO4? (b) What is the final temperature of the solution?arrow_forward
- In a bomb calorimeter, the reaction vessel is surrounded by water that must be added for each experiment. Since the amount of water is not constant from experiment to experiment, the mass of water must be measured in each case. The heat capacity of the calorimeter is broken down into two parts: the water and the calorimeter components. If a calorimeter contains 1.00 kg water and has a total heat capacity of 10.84 kJ/C, what is the heat capacity of the calorimeter components?arrow_forward4.60 Why are fuel additives used?arrow_forwardWhat mass of carbon monoxide must be burned to produce 175 kJ of heat under standard state conditions?arrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage Learning
![Text book image](https://www.bartleby.com/isbn_cover_images/9781337399074/9781337399074_smallCoverImage.gif)
![Text book image](https://www.bartleby.com/isbn_cover_images/9781133949640/9781133949640_smallCoverImage.gif)
![Text book image](https://www.bartleby.com/isbn_cover_images/9781337398909/9781337398909_smallCoverImage.gif)
![Text book image](https://www.bartleby.com/isbn_cover_images/9781285199047/9781285199047_smallCoverImage.gif)
![Text book image](https://www.bartleby.com/isbn_cover_images/9781305580343/9781305580343_smallCoverImage.gif)
![Text book image](https://www.bartleby.com/isbn_cover_images/9781305079373/9781305079373_smallCoverImage.gif)