Determine which quantities will be affected by increasing the feed to 0.02 in/tooth in example 24.1.

Question

Want to see the full answer?

Answer 1

Question

Chapter 24, Problem 40QTP

To determine

Determine which quantities will be affected by increasing the feed to 0.02 in/tooth in example 24.1.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

In an orthogonal cutting test with a bar of 75 mm diameter is reduced to 73 mm by using a HSS tool with arake angle  = 10o, following observations were made: length of the chip, lc = 69.44 mm, cutting ratio r =0.3, the horizontal component of the cutting force, FH = 1450 N, and the vertical component of the cuttingforce, FV = 850 N. The various parameters recorded in this cutting operation are: depth of cut, d = 2 mm;feed rate, f = 0.3 mm/rev, cutting speed, V = 60 m/min. Using Merchant’s theory calculate the following:1) Friction force along rake face2) Normal force acting on rake face3) Shear force along the shear plane4) Normal force acting on shear plane5) The percentage error in shear angle predicted by Merchant’s theory6) Shear velocity7) Chip velocity8) Total work done9) The shear work proportion out of the total work done10) The friction work proportion out of the total work done

In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting forces were measured as 1259 N and 1601 N, respectively. The measured chip thickness after machining was found to be 0.3 mm. The rake angle was 10° and the axial feed was 100 mm/min. the rotational speed of the spindle was 1000 rpm. Assuming the material to be perfectly and Merchant's first solution, the shear strength of the material is closest to

%9. lu. O V;YA Q1 What is the difference between direct shear and indirect cutting? Q2_What are the factors affecting fatigue Q3_What is the difference between hardness and micro-hardness Q4_What is the fatigue limit? Q5_What is strain hardness? Q6 What is the difference between true stress and engineering stress Q7_What is the difference between true strain and engineering strain? What is the relationship that binds them? Q8_ When do the "ears" appear in drawn cup, through cup drawing tests? Q9 Could we use results of tensile tests predict impact failure behavior, why? Q10_Could you estimate ductile-to-brittle transition temperatures for metals having hexagonal close-packed structure, why? Q11 Can creep of metals happen in room temperature, when? Solve a question 1_2_3_4_5_6_7_8_9_10_11 II