Concept explainers
(a)
Interpretation:
The units of Do and E should be identified.
Concept introduction:
Diffusivity is calculated as follows.
Where,
Do = the preexponential factor.
E = the activation energy for diffusion.
R = 1.987
(b)
Interpretation:
The plot for straight line on rectangular coordinates should be explained.
Concept introduction:
Diffusivity is calculated as follows.
Where,
Do = the preexponential factor.
E = the activation energy for diffusion.
R = 1.987
(c)
Interpretation:
Plot the data in rectangular coordinates and find the values for D0 and E from the resulting line.
Concept introduction:
Diffusivity is calculated as follows:
Where,
Do = the preexponential factor.
E = the activation energy for diffusion.
R = 1.987
Learn your wayIncludes step-by-step video
Chapter 2 Solutions
EBK ELEMENTARY PRINCIPLES OF CHEMICAL P
- Given T = 223 K, Assume a 1 m3 air mass at z = 10 km contains 365 µg SO2 and 11.8 moles of air what is the concentration of SO2 in ppm?arrow_forwardConsider the following reaction where Ke = 9.52x10 at 350 K. CHa(9) + CCla(0) =2CH,Cl2(9) A reaction mixture was found to contain 3.07x102 moles of CHa(g), 3.96x10 moles of CCIA(g) and 1.21x102 moles of CH,Cl2(g), in a 1.00 liter container. Is the reaction at equilibrium? If not, what direction must it run in order to reach equilibrium? The reaction quotient, Qo equals The reaction A. must run in the forward direction to reach equilibrium. B. must run in the reverse direction to reach equilibrium. C. is at equilibrium.arrow_forwardZ = [2(σP)/kT][8RT/pi(M)]1/2 2A. Based on the kinetic theory of gases, collision frequency is related to temperature, pressure and molecular cross section. Explain conceptually and based on the equation how the collision frequency is related to pressure. 2B. How does collision frequency relate to temperature. 2C. Sketch a plot of the relationship between collision frequency and temperature. Label your axes.arrow_forward
- Explain in terms of the Kinetic Molecular Theory the following situations: a) Why does compressing a gas raise the temperature of the system? b) Explain why the density of a gas is so much lower than the density of its liquid form? c) Explain in detail the dissolving process of KCl in water. d) Explain why the solid precipitate AGl (s) forms when solutions of KCl (aq) and AgNO3 (aq) are mixed.arrow_forwardExplain the relationship between the partial pressure of agas and its rate of diffusion.arrow_forwardIron(III) hydroxide (MM = 106.87 g/mol) has a Ksp of 6.3 x10-38. If 35.9 g Fe(OH)3 is stirred into 6,034.63 L H2O, how many micrograms of iron(III) hydroxide will dissolve?Report your answer to the nearest whole number.arrow_forward
- Since the specific volume of nitrous oxide gas (N 2 O) at a pressure of 100 kPa and a temperature of 47 ° C multiplied by the compressibility factor is 0.453 m ^ 3 / kg, what is the compressibility factor of this gas?arrow_forwarda. Ethanol vapours were allowed to completely fill a large jug with a volume of 15.5L. The ethanol was burned yielding 5.5mL of pure liquid water in the bottom of the jug at the end of the reaction. C2H5OH + 3 O2 ? 2 CO2 + 3 H20 If the room temperature was 21.5 oC and the pressure was 0.996atm, calculate the percentage yield of the water gathered in the jug. b. A 10.0 mL sample of sulfuric acid with an unknown concentration was titrated with 3.5 x 10-4 mol/L NaOH. If 20.4mL of the sodium hydroxide was required to completely neutralize the acid, determine the concentration of the sulfuric acid in the sample. Then, determine the original pH of the sulfuric acid samplearrow_forwardThe diagram below shows some isotherms of water. (a) S Estimate values for the critical constants and the van der Waals constants a and b for this gas. (b) Using the information from part (a), estimate the radius of a water molecule. Compare to the value of 1.37 A obtained from interpolation of ionic radii (Y. Zhang and Z. Xu, American Mineralogist 80 (1995) 670-675). PIMPa C 8 15- 10- M 50 400°C 374°C 350°C 300°C 425°C 450°C 275°C 100 150 200 250 300 350 Vicm mole 400 500arrow_forward
- 1. A piece of metal "X" weighing 0.0382 g was placed in an eudiometer containing dilute aqueous HCI. After the metal fully dissolved,15.4 mL of hydrogen gas was collected by displacement of water and a 400 mm column of water was observed. The water temperature was 25 degrees Celcius and the barometric pressure was 758.8 mm Hg (torr). Refer to the introduction and data sheet to solve the following problems. a) Calculate the volume occupied by the hydrogen gas at STP. b) How many moles of the metal were consumed in the reaction? c) What is the molar mass of the metal?arrow_forwardCalculate the collision frequency, z, and the collision density, ZAA, in ammonia, d = 380 pm, at 30 °C and 120 kPa. What is the percentage increase when the temperature is raised by 10 K at constant volume?arrow_forwardIf the partial pressure of N2 is 2.70 x 105 Pa and the partial pressure of Ne is 5.00 x 105 Pa in a given mixture, what is the mole fraction of Ne (XNe)?arrow_forward
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistryChemistryISBN:9781259911156Author:Raymond Chang Dr., Jason Overby ProfessorPublisher:McGraw-Hill EducationPrinciples of Instrumental AnalysisChemistryISBN:9781305577213Author:Douglas A. Skoog, F. James Holler, Stanley R. CrouchPublisher:Cengage Learning
- Organic ChemistryChemistryISBN:9780078021558Author:Janice Gorzynski Smith Dr.Publisher:McGraw-Hill EducationChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningElementary Principles of Chemical Processes, Bind...ChemistryISBN:9781118431221Author:Richard M. Felder, Ronald W. Rousseau, Lisa G. BullardPublisher:WILEY