Essential University Physics (3rd Edition)
3rd Edition
ISBN: 9780134202709
Author: Richard Wolfson
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 12, Problem 55P
Figure 12.31 shows a popular system for mounting bookshelves. An aluminum bracket is mounted on a vertical aluminum support by small tabs inserted into vertical slots. Contact between the bracket and support occurs only at the upper tab and at the bottom of the bracket, 4.5 cm below the upper tab. If each bracket in the shelf system supports 32 kg of books, with the center of gravity 12 cm out from the vertical support, what is the horizontal component of the force exerted on the upper bracket tab?
FIGURE 12.31 Problem 55
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
1
b
F2
1
1
FR
F1
b.
The figure above shows a crane tower on site at the HWY 1 expansion and Stoney Trail
extension in NW Calgary. You are a design engineer working for the company supplying cranes
for the contractors and you have been asked to evaluate the tower design. The crane tower
supporting the pulley is designed so that the resultant force from the cable tension running over
the pulley is oriented along the tower axis. Note: The tension in the cable is the same on both
sides so ||Fill = ||F2l|| = T.
A 25-ft crane supported at its lower end by a pin is elevated by a horizontal cable. A 250-lb load is
suspended through the cable. The center of gravity of the crane is 10 ft from the pin, and the crane
weighs 200 lb. Hint: You don't have to convert the unit since they cancel out on both sides.
25. Find the tension in the cable.
T
$25016
26. Find the total force acting on the pin.
y
27. Find the direction of the force acting on the pin, o = ?
60⁰°
W(2001b)
A uniform, 8.0-m, 1500-kg beam is hinged to a wall and supported by a thin cable attached 2.0 m from the free end of the beam. The beam is supported at an angle of 30° above the horizontal. (a) find the tension in the cable and (b) how hard does the beam push inward on the wall?
Chapter 12 Solutions
Essential University Physics (3rd Edition)
Ch. 12.1 - The figure shows three pairs of forces acting on...Ch. 12.2 - Prob. 12.2GICh. 12.3 - The figure shows a person in static equilibrium...Ch. 12.4 - Prob. 12.4GICh. 12 - Give an example of an object on which the net...Ch. 12 - Give an example of an object on which the net...Ch. 12 - Prob. 3FTDCh. 12 - Pregnant women often assume a posture with their...Ch. 12 - When you carry a bucket of water with one hand,...Ch. 12 - Is a ladder more likely to slip when you stand...
Ch. 12 - How does a heavy keel help keep a boat from...Ch. 12 - Does choosing a pivot point in an equilibrium...Ch. 12 - If you take the pivot point at the application...Ch. 12 - A short dog and a tall person are standing on a...Ch. 12 - Prob. 11FTDCh. 12 - A body is subject to three forces; F1=1i+2jN,...Ch. 12 - To demonstrate that the choice of pivot point...Ch. 12 - In Fig. 12.11 the forces shown all have the same...Ch. 12 - Figure 12.12a shows a thin, uniform square plate...Ch. 12 - Repeat the preceding problem for the equilateral...Ch. 12 - A 23-m-long log of irregular cross section lies...Ch. 12 - A 60-kg uniform board 2.4 m long is supported by a...Ch. 12 - Where should the child in Fig. 12.14 sit if the...Ch. 12 - A 4.2-m-long beam is supported by a cable at its...Ch. 12 - Figure 12.15 shows how a scale with a capacity of...Ch. 12 - A portion of a roller-coaster track is described...Ch. 12 - Prob. 23ECh. 12 - Youre a highway safety engineer, and youre asked...Ch. 12 - Figure 12.17a shows an outstretched arm with mass...Ch. 12 - A uniform sphere of radius R is supported by a...Ch. 12 - You work for a garden equipment company, and youre...Ch. 12 - Figure 12.20 shows the fool and lower leg of a...Ch. 12 - A uniform 5.0-kg ladder is leaning against a...Ch. 12 - The boom in the crane of Fig. 12.21 is free to...Ch. 12 - A uniform board of length L and weight W is...Ch. 12 - Figure 12.23 shows a 1250-kg car that has slipped...Ch. 12 - Repeat Example 12.2, now assuming that the...Ch. 12 - You are headwaiter at a new restaurant, and your...Ch. 12 - Climbers attempting to cross a stream place a...Ch. 12 - A crane in a marble quarry is mounted on the...Ch. 12 - A rectangular block measures w w L, where L is...Ch. 12 - The potential energy as a function of position for...Ch. 12 - A rectangular block of mass m measures w w L,...Ch. 12 - A 160-kg highway sign of uniform density is 2.3 m...Ch. 12 - A 5.0-m-long ladder has mass 9.5 kg and is leaning...Ch. 12 - Prob. 42PCh. 12 - A uniform, solid cube of mass m and side s is in...Ch. 12 - An isosceles triangular block of mass m and height...Ch. 12 - Youre investigating ladder safety for the Consumer...Ch. 12 - A 2.0-m-long rod has density in kilograms per...Ch. 12 - What horizontal force applied at its highest point...Ch. 12 - A rectangular block twice as high as it is wide is...Ch. 12 - What condition on the coefficient of friction in...Ch. 12 - A uniform solid cone of height h and base diameter...Ch. 12 - Prove the statement in Section 12.1 that the...Ch. 12 - Three identical books of length L are stacked over...Ch. 12 - A uniform pole of mass M is at rest on an incline...Ch. 12 - For what angle does the situation in Problem 53...Ch. 12 - Figure 12.31 shows a popular system for mounting...Ch. 12 - The nuchal ligament is a thick, cordlike structure...Ch. 12 - A 4.2-kg plant hangs from the bracket shown in...Ch. 12 - The wheel in Fig. 12.34 has mass M and is weighted...Ch. 12 - An interstellar spacecraft from an advanced...Ch. 12 - Youre called to testify in a product liability...Ch. 12 - Youre designing a vacation cabin at a ski resort....Ch. 12 - Prob. 62PCh. 12 - Engineers designing a new semiconductor device...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...
Additional Science Textbook Solutions
Find more solutions based on key concepts
To measure the heat capacity of an object, all you usually have to do is put it in thermal contact with another...
An Introduction to Thermal Physics
If acceleration is proportional to the net force or is equal to net force.
Conceptual Physics (12th Edition)
1. How many significant figures does each of the following numbers have?
a. 0.73 b. 7.30 c. 73 d. 0.073
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
Find the following for path D in Figure 2.59: (a) The distance traveled. (b) The magnitude of the displacement ...
College Physics
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- In Example 14.3, we found that one of the steel cables supporting an airplane at the Udvar-Hazy Center was under a tension of 9.30 103 N. Assume the cable has a diameter of 2.30 era and an initial length of 8.00 m before the plane is suspended on the cable. How much longer is the cable when the plane is suspended on it?arrow_forwardRuby, with mass 55.0 kg, is trying to reach a box on a high shelf by standing on her tiptoes. In this position, half her weight is supported by the normal force exerted by the floor on the toes of each foot as shown in Figure P14.75A. This situation can be modeled mechanically by representing the force on Rubys Achilles tendon with FA and the force on her tibia as FT as shown in Figure P14.75B. What is the value of the angle and the magnitudes of the forces FA and FT? FIGURE P14.75arrow_forwardA wooden door 2.1 m high and 0.90 m wide is hung by two hinges 1.8 m apart. The lower hinge is 15 cm above the bottom of the door. The center of mass of the door is at its geometric center, and the weight of the door is 260 N, which is supported equally by both hinges. Find the horizontal force exerted by each hinge on the door.arrow_forward
- The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B. A force P is applied at B where P = 20i - 9j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN. 2 m 4 m 6 m B y A 3 m 6 m (2 marrow_forwardA person places his hand palm downward on a scale and pushes down on the scale until it reads (8.31x10^1) N. The triceps muscle is responsible for this arm extension force. Find the force (in N) exerted by the triceps muscle. The bottom of the triceps muscle is 2.50 cm to the left of the elbow joint, and the palm is pushing at approximately 35.0 cm to the right of the elbow joint. (please ignore the number 96 shown in the scale). Give your answer with three significant figures.arrow_forwardThe heels on a pair of women's shoes have a radius of .5cm at the bottom. If 30% of the weight of a woman 480N is supported by each heel, find the stress on each heel.arrow_forward
- Problem 8: Consider a rigid steel beam of length L = 11.5 m and mass mb = 412 kg resting on two supports, one at each end. A worker of mass mw = 78 kg sits on the beam at a distance x from support A. Refer to the figure, though note that it is not drawn to scale. Part (a) When the worker sits at a distance x = 4.5 m from support A, calculate the force, in newtons, that support B must exert on the beam in order for it to remain at rest. Use g with three significant figures. Part (b) The force exerted on the beam by support A is measured and found to be FA = 2180 N. At what distance x, in meters, from support A is the worker sitting now?arrow_forwarda bar of length L is 3m and weight w is 131.7N it is supported at one end by a bolt in a wall and at its other end it is supported horizontally by a cable that forms a 30 degree angle with the bar. A weight of w = 389.9N is placed at x = 1.2m from the wall. What is the cable tension?arrow_forwardQuestion 4: The uniform 7m steel shaft has a mass of 200kg and is B supported by a ball and socket joint at A in the horizontal floor. The ball end B rests against the smooth vertical walls as shown. Compute the forces exerted by the walls and the floor on the ends of the shaft. 7 m m 6 marrow_forward
- The bones of the forearm (radius and ulna) are hinged to the humerus at the elbow. The biceps muscle connects to the bones of the forearm about 2.15 cm beyond the joint. Biceps muscle Assume the forearm has a mass of 2.25 kg and a length of 0.425 m. When the humerus and the biceps are nearly vertical and the forearm is horizontal, if a person wishes to Humerus hold an object of mass 6.55 kg so that her forearm remains motionless, what is the force exerted by the biceps muscle? Radius Elbow. Ulna force: N Handarrow_forwardTwo strips of metal are riveted together at their ends by four rivets, each of diameter 6.0 mm. What is the maximum tension that can be exerted by the riveted strip if the shearing stress on the rivet is not to exceed 6.9 × 107Pa? Assume that each rivet is to carry one-quarter of the load.arrow_forwardProblem 5: A 400.0-N sign hangs from the end of a uniform strut. The strut is 4.0 m long and weighs 600.0 N. The strut is supported by a hinge at the wall and by a cable whose other end is tied to the wall at a point 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University
Static Equilibrium: concept; Author: Jennifer Cash;https://www.youtube.com/watch?v=0BIgFKVnlBU;License: Standard YouTube License, CC-BY