Essential University Physics (3rd Edition)
3rd Edition
ISBN: 9780134202709
Author: Richard Wolfson
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 12, Problem 18E
A 60-kg uniform board 2.4 m long is supported by a pivot 80 cm from the left end and by a scale at the right end (Fig. 12.14). How far from the left end should a 40-kg child sit for the scale to read zero?
FIGURE 12.14 Exercises 18 and 19
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A father and his son are supposed to carry a load of 500 N. They decided to use a pole (of uniform mass distribution) 4.0 m long and weighing 60 N. They support the pole at the ends. Where should the load be placed so that the father supports three times as much weight as his son?
A uniform plank 8.00 m in length with mass 40.0 kg is supported at two points located 1.00 m and 5.00 m, respectively, from the left-hand end. What is the maximum additional mass you could place on the right-hand end of the plank and have the plank still be at rest?
A non-uniform rod (an object that tapers on one end) is 3.0 m long and it weighs 5.0 N. A 1.0-N load is suspended at the tip of the smaller end. If the weight is concentrated 1.70 m from the tip of the smaller end, how far from the bigger end of the rod shall it be balanced?
Chapter 12 Solutions
Essential University Physics (3rd Edition)
Ch. 12.1 - The figure shows three pairs of forces acting on...Ch. 12.2 - Prob. 12.2GICh. 12.3 - The figure shows a person in static equilibrium...Ch. 12.4 - Prob. 12.4GICh. 12 - Give an example of an object on which the net...Ch. 12 - Give an example of an object on which the net...Ch. 12 - Prob. 3FTDCh. 12 - Pregnant women often assume a posture with their...Ch. 12 - When you carry a bucket of water with one hand,...Ch. 12 - Is a ladder more likely to slip when you stand...
Ch. 12 - How does a heavy keel help keep a boat from...Ch. 12 - Does choosing a pivot point in an equilibrium...Ch. 12 - If you take the pivot point at the application...Ch. 12 - A short dog and a tall person are standing on a...Ch. 12 - Prob. 11FTDCh. 12 - A body is subject to three forces; F1=1i+2jN,...Ch. 12 - To demonstrate that the choice of pivot point...Ch. 12 - In Fig. 12.11 the forces shown all have the same...Ch. 12 - Figure 12.12a shows a thin, uniform square plate...Ch. 12 - Repeat the preceding problem for the equilateral...Ch. 12 - A 23-m-long log of irregular cross section lies...Ch. 12 - A 60-kg uniform board 2.4 m long is supported by a...Ch. 12 - Where should the child in Fig. 12.14 sit if the...Ch. 12 - A 4.2-m-long beam is supported by a cable at its...Ch. 12 - Figure 12.15 shows how a scale with a capacity of...Ch. 12 - A portion of a roller-coaster track is described...Ch. 12 - Prob. 23ECh. 12 - Youre a highway safety engineer, and youre asked...Ch. 12 - Figure 12.17a shows an outstretched arm with mass...Ch. 12 - A uniform sphere of radius R is supported by a...Ch. 12 - You work for a garden equipment company, and youre...Ch. 12 - Figure 12.20 shows the fool and lower leg of a...Ch. 12 - A uniform 5.0-kg ladder is leaning against a...Ch. 12 - The boom in the crane of Fig. 12.21 is free to...Ch. 12 - A uniform board of length L and weight W is...Ch. 12 - Figure 12.23 shows a 1250-kg car that has slipped...Ch. 12 - Repeat Example 12.2, now assuming that the...Ch. 12 - You are headwaiter at a new restaurant, and your...Ch. 12 - Climbers attempting to cross a stream place a...Ch. 12 - A crane in a marble quarry is mounted on the...Ch. 12 - A rectangular block measures w w L, where L is...Ch. 12 - The potential energy as a function of position for...Ch. 12 - A rectangular block of mass m measures w w L,...Ch. 12 - A 160-kg highway sign of uniform density is 2.3 m...Ch. 12 - A 5.0-m-long ladder has mass 9.5 kg and is leaning...Ch. 12 - Prob. 42PCh. 12 - A uniform, solid cube of mass m and side s is in...Ch. 12 - An isosceles triangular block of mass m and height...Ch. 12 - Youre investigating ladder safety for the Consumer...Ch. 12 - A 2.0-m-long rod has density in kilograms per...Ch. 12 - What horizontal force applied at its highest point...Ch. 12 - A rectangular block twice as high as it is wide is...Ch. 12 - What condition on the coefficient of friction in...Ch. 12 - A uniform solid cone of height h and base diameter...Ch. 12 - Prove the statement in Section 12.1 that the...Ch. 12 - Three identical books of length L are stacked over...Ch. 12 - A uniform pole of mass M is at rest on an incline...Ch. 12 - For what angle does the situation in Problem 53...Ch. 12 - Figure 12.31 shows a popular system for mounting...Ch. 12 - The nuchal ligament is a thick, cordlike structure...Ch. 12 - A 4.2-kg plant hangs from the bracket shown in...Ch. 12 - The wheel in Fig. 12.34 has mass M and is weighted...Ch. 12 - An interstellar spacecraft from an advanced...Ch. 12 - Youre called to testify in a product liability...Ch. 12 - Youre designing a vacation cabin at a ski resort....Ch. 12 - Prob. 62PCh. 12 - Engineers designing a new semiconductor device...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...Ch. 12 - Youve been hired by your states environmental...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Write each number in decimal form.
44. 8.72 × 10–10
Applied Physics (11th Edition)
(II) What is the magnitude of the acceleration of a speck of clay on the edge of a potter's wheel turning at 45...
Physics: Principles with Applications
Check Your Understanding What are the values of the gravitational potential energy of the hiker at the base, an...
University Physics Volume 1
11. A ball thrown horizontally at 25 m/s travels a horizontal distance of 50 m before hitting the ground. From...
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
(a) By how many percent is the torque of a motor decreased if its permanent magnets lose 5.0% of their strength...
University Physics Volume 2
Explain all answers clearly, with complete sentences and proper essay structure, if needed. An asterisk (*) des...
The Cosmic Perspective Fundamentals (2nd Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A 8-m uniform beam of weight 120 N is supported by two ropes at the ends. If a 500-N person sits at 3.0 m from the left end of the beam, (a) what is the tension in the right rope? (b) What is the tension in the left rope?arrow_forwardA uniform 8.00 m, 1500 kg beam is hinged to a wall and supported by a thin cable attached 2.00 m from the free end of the beam. The beam is fixed to the wall at an angle of 30 degrees above the horizontal. The angle between the cable and the beam is 40 degrees. What are the unknowns? -direction of tension in the cable -direction of the hinge force -magnitude of rhe tension in the cable -magnitude of the hinge forcearrow_forwardA uniform, 8.0-m, 1500-kg beam is hinged to a wall and supported by a thin cable attached 2.0 m from the free end of the beam. The beam is supported at an angle of 30° above the horizontal. (a) find the tension in the cable and (b) how hard does the beam push inward on the wall?arrow_forward
- A 60 kg uniform board 2.4 m long is supported by a pivot d=80 cm from the left end. How far from the left end should a 41.6 kg child sit so that the board is balanced? Answer: cmarrow_forwardA 60-kg uniform board 2.4 m long is supported by a pivot 80 cm from the left end and by a scale at the right end (see figure below). (a) How far from the left end should a 40-kg child sit for the scale to read zero? (b) How far from the left end should a 40-kg child sit for the scale to read 100 N?arrow_forwardProblem 8: Consider a rigid steel beam of length L = 11.5 m and mass mb = 412 kg resting on two supports, one at each end. A worker of mass mw = 78 kg sits on the beam at a distance x from support A. Refer to the figure, though note that it is not drawn to scale. Part (a) When the worker sits at a distance x = 4.5 m from support A, calculate the force, in newtons, that support B must exert on the beam in order for it to remain at rest. Use g with three significant figures. Part (b) The force exerted on the beam by support A is measured and found to be FA = 2180 N. At what distance x, in meters, from support A is the worker sitting now?arrow_forward
- A uniform 8.00 m, 1500 kg beat is hinged to a wall and supported by a thin cable attached 2.00 m from the free end of the beam. The beam is fixed to the wall by a hinge at an angle of 30.0 degrees above the horizontal. The angle between the cable and the beam is 40 degrees. What is the angle between the tension in the cable and the horizontal. (Hint angles in a triangle add to 180 degrees) -10 degrees -30 degrees -15 degrees -20 degreesarrow_forwardTwo men are carrying a ladder of length l by supporting it at its ends. The ladder is horizontal, and its center of gravity is 1/4 of the way from one end. At what distance x from this end must a can of paint, of mass 3/4 of that of the ladder, be suspended so that the men carry equal loads?arrow_forwardA drawbridge is suspended by a cable as shown below. The drawbridge has a mass of M-3.5 x 10^5 kg and a length L=22.0 m, and is raised by an angle e=60° above the horizontal. The cable is connected close to the end of the bridge and makes an angle 62-15°from horizontal when the bridge is raised. Assuming the hinge that the bridge pivots on is frictionless, find. a)l The magnitude of the tension in the cable when the bridge is raised. b) The magnitude of the force on the hinge when the bridge is raised. Hingearrow_forward
- A tightrope walker stands on a wire that is supported by a pole at each end. The tightrope walker creates a tension of 3.42 ✕ 103 N in a wire making an angle 6.2° below the horizontal with each supporting pole. Calculate how much this tension stretches the steel wire (in cm) if it was originally 16 m long and 0.50 cm in diameter. There is no accompanying image. This is the complete question.arrow_forwardA diving board 3.00 m long is supported at a point 1.00 m from the end, and a diver weighing 500 N stands at the free end. The diving board is of uniform cross section and weighs 280 N. Find (a) the force at the support point and (b) the force at the left-hand end. K-1.00 m* 2.00 m-arrow_forward. A carpenter and his assistant are to carry a uniform wooden beam, which is 6 m long and weighs 100 kg, on their shoulders. Both men are of the same height so that the beam is carried horizontally. However, the carpenter is the stronger of the two and wishes to bear 50% more of the weight of the beam than his assistant. If one end of the beam is placed on the assistant's shoulder, how far from the other end of the beam should the carpenter put his shoulder? [71arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Glencoe Physics: Principles and Problems, Student...
Physics
ISBN:9780078807213
Author:Paul W. Zitzewitz
Publisher:Glencoe/McGraw-Hill
Static Equilibrium: concept; Author: Jennifer Cash;https://www.youtube.com/watch?v=0BIgFKVnlBU;License: Standard YouTube License, CC-BY