Concept explainers
Tennis Ball Testing
A tennis ball bouncing on a hard surface compresses and then rebounds. The details of the rebound are specified in tennis regulations. Tennis balls, to be acceptable for tournament play, must have a mass of 57.5 g. When dropped from a height of 2.5 m onto a concrete surface, a ball must rebound to a height of 1.4 m. During impact, the ball compresses by approximately 6 mm.
82. If the ball accelerates uniformly when it hits the floor, what is its approximate acceleration as it comes to rest before rebounding?
A. 1000 m/s2
B. 2000 m/s2
C. 3000 m/s2
D. 4000 m/s2
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
College Physics: A Strategic Approach (4th Edition)
Additional Science Textbook Solutions
Introductory Chemistry (6th Edition)
Campbell Biology in Focus (2nd Edition)
Biology: Life on Earth (11th Edition)
Human Anatomy & Physiology (2nd Edition)
Microbiology: An Introduction
Campbell Essential Biology with Physiology (5th Edition)
- Two identical steel balls, each of diameter 25.4 nun and moving in opposite directions at 5 m/s, run into each other head-on and bounce apart. Prior to the collision, one of the balls is squeezed in a vise while precise measurements are made of the resulting amount of compression. The results show that Hookes law is a fair model of the balls elastic behavior. For one datum, a force of 16 kN exerted by each jaw of the vise results in a 0.2-mm reduction in the diameter. The diameter returns to its original value when the force is removed, (a) Modeling the ball as a spring, find its spring constant. (b) Does the interaction of the balls during the collision last only for an instant or for a nonzero time interval? State your evidence, (c) Compute an estimate for the kinetic energy of each of the balls before they collide, (d) Compute an estimate for the maximum amount of compression each ball undergoes when the balls collide, (e) Compute an order-of-magnitude estimate for the time interval for which the balls are in contact. (In Chapter 15, you will learn to calculate the contact time interval precisely.)arrow_forwardA 1 200-kg car traveling initially at vCi = 25.0 m/s in an easterly direction crashes into the back of a 9 000-kg truck moving in the same direction at vTi = 20.0 m/s (Fig. P9.12). The velocity of the car immediately after the collision is vCf = 18.0 m/s to the east. (a) What is the velocity of the truck immediately after the collision? (b) What is the change in mechanical energy of the cartruck system in the collision? (c) Account for this change in mechanical energy.arrow_forwardTwo gliders are set in motion on a horizontal air track. A light spring of force constant k is attached to the back end of the second glider. As shown in Figure P9.41, the first glider, of mass m1, moves to the right with speed v1, and the second glider, of mass m2, moves more slowly to the right with speed v2. When m1 collides with the spring attached to m2, the spring compresses by a distance xmax, and the gliders then move apart again. In terms of v1, v2, m1, m2, and k, find (a) the speed v at maximum compression, (b) the maximum compression xmax, and (c) the velocity of each glider after m1 has lost contact with the spring. Figure P9.41arrow_forward
- Two identical steel balls, each of mass 67.4 g, are moving in opposite directions at 5.00 m/s. They collide head-on and bounce apart elastically. By squeezing one of the balls in a vise while precise measurements are made of the resulting amount of compression, you find that Hookes law is a good model of the balls elastic behavior. A force of 16.0 kN exerted by each jaw of the vise reduces the diameter by 0.200 mm. Model the motion of each ball, while the balls are in contact, as one-half of a cycle of simple harmonic motion. Compute the time interval for which the balls are in contact. (If yon solved Problem 57 in Chapter 7, compare your results from this problem with your results from that one.)arrow_forwardYou are standing on a saucer-shaped sled at rest in the middle of a frictionless ice rink. Your lab partner throws you a heavy Frisbee You take different actions in successive experimental trials. Rank the following situations according to your final speed from largest to smallest. If your final speed is the same in two cases, give them equal rank. (a) You catch the Frisbee and hold onto it. (b) You catch the Frisbee and throw it back to your partner. (c) You bobble the catch, just touching the Frisbee so that it continues in its original direction more slowly. (d) You catch the Frisbee and throw it so that it moves vertically upward above your head. (e) You catch the Frisbee and set it down so that it remains at rest on the ice.arrow_forwardA ball is suspended by a string that is tied to a fixed point above a wooden block standing on end. The ball is pulled back as shown in Figure OQ8.14 and released. In trial A, the ball rebounds elastically from the block. In trial B, two-sided tape causes the ball to stick to the block. In which case is the ball more likely to knock the block over? (a) It is more likely in trial A. (b) It is more likely in trial B. (c) It makes no difference. (d) It could be either case, depending on other factors. Figure OQ8.14arrow_forward
- A 0.240-kg billiard ball that is moving at 3.00 m/s strikes the bumper of a pool table and bounces straight back at 2.40 m/s (80% of its original speed). The collision lasts 0.0150 s. (a) Calculate the average force exerted on the ball by the bumper. (b) How much kinetic energy in joules is lost during the collision? (c) What percent of the original energy is left?arrow_forward(a) Figure P9.36 shows three points in the operation of the ballistic pendulum discussed in Example 9.6 (and shown in Fig. 9.10b). The projectile approaches the pendulum in Figure P9.36a. Figure P9.36b shows the situation just after the projectile is captured in the pendulum. In Figure P9.36c, the pendulum arm has swung upward and come to rest momentarily at a height A above its initial position. Prove that the ratio of the kinetic energy of the projectilependulum system immediately after the collision to the kinetic energy immediately before is m1|/(m1 + m2). (b) What is the ratio of the momentum of the system immediately after the collision to the momentum immediately before? (c) A student believes that such a large decrease in mechanical energy must be accompanied by at least a small decrease in momentum. How would you convince this student of the truth? Figure P9.36 Problem. 36 and 43. (a) A metal ball moves toward the pendulum. (b) The ball is captured by the pendulum. (c) The ballpendulum combination swings up through a height h before coming to rest.arrow_forwardMath Review Solve the two equations mi + MVi = mf + MVf and i Vi = (f Vf) for (a) f and (b) Vf if m = 2.00 kg, i = 4.00 m/s, M = 3.00 kg, and Vi = 0. (See Section 6.3.)arrow_forward
- A 10 g bullet moving at 1,000 m/s goes through a 1.0 kg block. If the bullet goes through the block and comes out at a velocity of 711 m/s, determine the maximum height the block rises to. Use g = 10 N/kg.arrow_forward1. Greg throws a small lump of clay at a larger block of clay, which is at reston a horizontal surface. The small lump has a mass of 24.0 grams. The block has a mass of 65.0 grams. The lump sticks to the block, and together they slide 1.20 m before stopping. If the speed of the lump before the collision is 5.25 m/s, what is the coefficient of friction between the clay at the surface? 2. Amelia rolls a 6.5 kg bowling ball, which hits a 1.6 kg stationary bowling pin. The ball continues forward with a velocity of 2.8 m/s. The pin flies forward (same direction as ball) with a velocity of 4.8 m/s. A. What was the original velocity of the bowling ball? B. Is this collision elastic or inelastic? Justify your answer. 3. A meterstick is on a knife-edge clamp placed at the 50 cm mark. Three equal masses m are located at the 15 cm mark, the 45 cm mark, and the 95 cm mark, respectively. A. What is the support force exerted by the clamp? Give answer in terms of mass m. B. Where should a fourth mass…arrow_forward8. Hannah and her friends go fishing in her 1.20m^3 rowboat, which has a mass of 100 kg. How many 60.0 kg people can get into the boat before the boat sinks? a. 22 b. 20 c. 10 d. 15 e. None of the abovearrow_forward
- Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegeCollege PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning