soil particle is found to be subjected to a maximum stress of 14.6KN/m2 and a minimum stress of - 4.18KN/m2. Find vertical and shear on the plane of angle of friction is 50o with respect to the major principal stress and also find maximum shear

soil particle is found to be subjected to a maximum stress of 14.6KN/m2 and a minimum stress of - 4.18KN/m2. Find vertical and shear on the plane of angle of friction is 50o with respect to the major principal stress and also find maximum shear

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter10: Stresses In A Soil Mass

Section: Chapter Questions

Problem 10.4P

See similar textbooks

Related questions

Q: 3 1. (a) An element of soil is subjected to the two-dimensional stresses shown in Figure Q1. 0,= 150…

Q: The soil stress state is shown in the figure, σx = 10 kN/m2, σy = 50 kN/m2, τxy = -10 kN/m2 : (1)…

A: Note- Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: A rectangular concrete slab, 3 m x 4.5 m, rests on the surface of a soil mass. The load on the slab…

Q: a) determine the horizontal effective stress at A. (Ans. 53.36 kPa) b) determine the lateral…

A: For first layer,S = 30%Water Content (w) = 40%Specific Gravity of soil (GS) = 2.7For second…

Q: Refer to the soil profile shown. Given H1 = 9.89 m., and H2 = 5.80 m. If the ground water table…

A: Formulae used Unit weight of soil (G + es)× Yw/(1+e) For dry sand ,s = 0…

Q: An highway is being built of a soil whose effective stress shear strength parameter c' and O' are…

Q: From the given soil formation of the soil with the following properties is shown in the figure.…

Q: At one point in a soil mass, the minor principal stress is 1,000 psf. What is themaximum value…

A: The principal stresses are defined as the normal stresses at an angle qp at which the shear stress…

Q: Question 1 A 5-m depth of sand overlies a 6-m layer of clay, the water table being at the surface.…

Q: Refer to the soil profile shown. Given H1 = 9.32 m., and H2 = 5.38 m. If the ground water table…

Q: a sample of soil is subjected to two mutually perpendicular direet stresses of 80 kN/m² tensile and…

A: Note: Hi! Thank you for the question, As per the honour code, we are allowed to answer three…

Q: The angle of internal friction of a cohesive soil which was tested using a tri-axial shear apparatus…

Q: The profile of a soil consists of a soil layer 4.0 meters below the ground surface. The weight of…

Q: A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the…

A: This question is related to the Soil Mechanics. There is Option (D) 27.26 is correct answer.…

Q: IV. A soil element is shown in Figure 3. (use equations) 130 kN/m² 35kN/m² 30⁰ 60 kN/m² 10 11. 12 +…

Q: A soil particle is found to be subjected to a maximum stress of 14.6 kN/m², and a minimum stress of…

Q: 4. The initial mean effective stress on a soil is p'o and the deviatoric stress is q = 0. If the…

A: Given:- q=0 To find:- plot total and effective stress path

Q: A cylindrical specimen of soil is compressed by an axial principal stress of 500 kPa and a radial…

Q: 35 At the construction site, 3 m thick clay layer is followed by 4 m thick gravel layer which rest…

Q: The profile of a soil consists of a soil layer 3.8 meters below the ground surface. The weight of…

Q: Refer to the soil profile shown. Given H1 = 8.3 m., and H2 = 4.43 m. If the ground water table rises…

Q: A deposit of homogeneous mixed soils (soil including both coarse-grained and fine-grained sizes)…

A: Given data:

Q: 2. Major and minor total principal stresses acting on a soil element are 348kPa and 160kPa…

A: Mohr's circle The locus of points expressing the magnitude of normal and shear stress at various…

Q: 1. Given the soil profile below, determine the Total Stress and Effective Stress at points A, B, C,…

Q: For soil profile and uniformly distributed loaded area shown below, find the increases in the…

A: Given data in question Unit weights Depths Cross section dimensions of circle and rectangle. To…

Q: Q2/ Determine the variation of total and effective stresses and pore water pressure with depth for…

Q: The effective stress strength parameters of soil are c'= 10 kPa and p = 30°, then shear strength on…

A: Given data- Effective stress parameters-C'=10 kPaϕ=30ototal normal stress σ=300 kPapore water…

Q: Refer to the soil profile shown. Given H1 = 9.89 m., and H2 = 4.4 m. If the ground water table rises…

Q: A circular area having a radius of 3m carries a uniformly distributed load of 96 kPa is applied to…

Q: Saturated clay has the void ratio of 1.65 and density of solids (or density of solid particles) of…

A: Answer We know that horizontal total stress for at rest earth pressure is given by σH = Ko*σV σH =…

Q: A circular area having a radius of 3 m carries a uniformly distributed of 90 kPa is applied to the…

Q: 17. Refer to the soil profile shown. Given H1 = 9.29 m., and H2 = 5.67 m. If the ground water table…

Q: The following picture depicts a soil profile that has two sources of above-ground loading: (1) a…

A: Given data in question Depths Unit weights Coefficient of lateral earth pressure Coefficient of…

Q: 7. Consider a stress state where p = 15 and q 12. The relevant soil properties are o = 35° and c= 3.…

Q: 7. For the soil element shown, determine the following: a. Maximum and minimum principal stresses b.…

Q: Refer to the soil profile shown. Given H1 = 9.80 m., and H2 = 5.17 m. If the ground water table…

A: To Find :- change in effective stress at bottom of clay layer due to rise in water table. Consider…

Q: the angle of internal frictional of a cohesive soil which was tested using tria-axial shear…

Q: 6. From the given soil profile, the groundwater table is located 2m below the ground level. (See…

Q: A soil deposit exists with a level ground surface. The saturated unit weight of the soil is 125 pcf,…

A: The given data is shown below:

Q: 6. A cylindrical sample of soil is iso-tropically compressed at 150 KPa under drained condition.…

A: A sample is compressed at 150 kpa at under drained condition and change in radial stress 300 kpa and…

Q: is 15 lb/in.2, at what values of deviator stress and major principal stress is the sample likely to

A: Given data- Minor principle stress (P3)= 15 lb/in² Major principle stress(P1) = ? Angle( ō)= 35…

Q: The soil in a dry granular deposit has an angle of internal friction equal to 35°. At a point in the…

A: Given: Angle of internal friction = 35°Minor principal stress = 1000 psf

Q: A direct shear test was conducted on a silty soil. At failure the normal and shear stresses were…

Q: Q1) Data obtained from a drained triaxle test are cell pressure o3 = 50 kN/ m? and deviator stress o…

Q: for a soil profile consists of a two- way drainage clay layer of 5 meters with W.T at N.G.S., total…

A: For any soil when it is subjected to external loading or surcharge loading it shows the long term…

Q: Figure 2 shows the soil profile for the top 9 m at a site, where the water table is at a depth of 5…

A: Geotechnical engineering is largely concerned with scientifically determining the soil's flexural…

Q: soil profile consisting of three soil layers is shown. Assume: layer 1 as dry soil. Characteristics…

Q: 5-4 For the given soil profile and the piezometric surfaces measured at the top of the two sand and…

Question

A soil particle is found to be subjected to a maximum stress of 14.6KN/m² and a minimum stress of - 4.18KN/m². Find vertical and shear on the plane of angle of friction is 50^o with respect to the major principal stress and also find maximum shear

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A soil specimen is subjected to a tri – axial test. The soil specimen is cohesionless. If the shear stress that causes failure is 300 kPa. and the normal stress at failure is only 500 kPa 5. Determine the angle of shearing resistance in degrees 6. Determine the angle that the failure plane measured from the major principal plane. 7. Determine the total axial stress in kPa at which failure is expected to occur.
1.A dry sand is known to have an angle of internal friction of 29. A triaxial test is planned, where the confining pressure will be 41 kPa. What is the maximum axial stress, in kPa, (major principal stress) that can be applied? Calculate the value to 1 decimal place. Do not provide units in your answer. 2.A clay soil is subjected to a triaxial test under unconsolidated-undrained conditions. At failure, the major and minor principal stresses are 8401 psf and 4875 psf, respectively. What is the shear strength of this soil if the confining pressure is doubled? Provide your answer in psf with no decimals.
A sample of soil (0.1 m X 0.1 m) is subjected to the forces shown in Figure below. Determine (a) σ1, σ3, and α;(b) the maximum shear stress; and (c) the stresses on a plane oriented at 30° counterclockwise from the major principal stress plane.
A cylindrical specimen of soil is compressed by an axial principal stress of 500 kPa and a radial principal stress of 200 kPa. Plot Mohr’s circle of stress and determine (a) the maximum shear stress and (b) the normal and shear stresses on a plane inclined at 300 counterclockwise from the horizontal. Draw the graph with solution.
11. J The effective stress friction angle of a saturated, cohesionless soil is 38°. The ratio of shear stress to normal effective stress on the failure plane is (A) 0.781 (B) 0.616 (C) 0.488 (D) 0.438
The normal stresses acting on two orthogonal planes of a soil sample are 250 kN/m2 and 110 kN/m2 a. Major principal stress b. Minor principal stress c. Normal stress on a plane inclined 60° to the direction of the major principal stress d. Shear stress on a plane inclined 60° to the direction of the major principal stress
For the state of a certain soil stress shown, find maximum shear stress. Express your answer in MPa.
the angle of internal frictional of a cohesive soil which was tested using tria-axial shear apparatus is equal to 26.57. failure occurred when the shearing stress is 250 kPa and the normal stress is 480 kPa. a. determine the maximum principal stress at failure, in kPa. round off to two decimal b. deternmine the cohesion of the soil in kPa. round off to two decimal c. determine the deviator stress at failure in kPa.round off to two decimal
A sample of dry sand is subjected to a tri- axial test. The angle of internal friction is 36.6°. The minor principal stress is 192 KPa. Compute the effective normal stress in KPa at the point where shear occurs at the failure plane.
SITUATION 5: A sand sample is subjected to direct shear testing at it's (in - situ) water content. Two tests are performed. For one of the tests, the sample shears at a stress of 400 kPa when the normal stress is 600 kPa. From these data, 15. Determine the value of the apparent cohesion. c. 230 kPa d. 221 kPa а. 100 kPa b. 179 КРа 16. Determine the corresponding angle of internal friction. a. 22.65 degrees b. 26.57 degrees c. 32.54 degrees d. 18.43 degrees
At failure, the major and minor principal stresses on a triaxial test are 200 kPa and 110 kPa respectively. If the porewater pressure at failure is 25 kPa... Q: What is the sine of the angle of shearing resistance of the soil? Round off your answer to two decimal places.
The effective stress friction angle of saturated, cohesionless soil is 38°. The ratio of shear stress to normal effective stress on the failure plane is O O O 0.781 0.616 0.488