The soil stress state is shown in the figure, σx = 10 kN/m2, σy = 50 kN/m2, τxy = -10 kN/m2 : (1) Please use Mohr circle to draw the soil stress state (2) Calculate the maximum principal stress σ1 and the minimum principal stress σ3 (3) Please find the (pole) position

Q: 3. An earth embankment is shown in Figure 3.48. Determine the stress increase at point B due to the…

A:

Q: Given H1 = 8.3 m., and H2 = 4.43 m. If the ground water table rises by 2.29 meters, determine the…

A:

Q: An embankment consists of clay fill for which c=25 kPa and angle of internal friction is 260 (from…

A: Given Data: c=25 kPa Angle of internal friction=260 Weight of fill per unit volume=18.64 kN/m3…

Q: 7. For the soil profile shown below, plot the variation of total stress, effective stress and pore…

A: Total stress in soil is load per unit area at any given plane in soil mass is either due to self…

Q: RIKN/m² to 72 kN/mス 39 kN /m? to

A:

Q: ,7 For the following soil element at a depth of 20 m, find: (a) The principal stresses, assuming the…

A: Normal Stress: It is defined as the stress which is induced due to the application of axial force on…

Q: A rectangular foundation 4 m × 6 m (Figure P7.20) trans- mits a stress of 100 kPa on the surface of…

A: We have to find the value of depth at which the increase in vertical stress below A less than 10% of…

Q: Q1/ For the following soil profile as shown below, estimate the effective vertical stress at points…

A: Unit weight of clayey sand= 17.5 kN/m3 Saturated unit weight of clay = 21 kN/m3 Saturated unit…

Q: Plot the distribution of total stress, effective stress, and pore- water pressure with depth for the…

A: Following is the given soil profile:   Given: For soil up to the depth of 4.5 m (A-B): Void ratio,…

Q: The "total" shear strength parameters of a soil are given as: 50 kPa; Angle of internal friction…

A:

Q: Given soil formation and the corresponding properties of soil in each layer. To consolidate the…

A: step 1-

Q: Using the principles of Mohr’s circles for the soil element shown in Figure 10.36, determine the…

A: The angle is the rotation stress equation is determine the actual maximum and minimum stress points.…

Q: Q#3. An earth embankment diagram is shown in Figure.1. Determine the vertical stress increase at A…

A: The embankment with sloping side show the trapezoidal load.  It is necessary to calculate the…

Q: A soil element is shown in Fig. 1. Determine the following (clearly show calculation procedures):…

A:

Q: 10-16. A 1 m cube within a mass of stressed soil has a stress of 100 kPa on its top and bottom…

A: since the given question is having multi sub parts therefore as per guidelines only 1-3 subparts…

Q: SITUATION: In accordance with Boussinesq theory, the vertical stress at a point below the center of…

A:

Q: The soil stress state is shown in the figure, σx = 10 kN/m2, σy = 50 kN/m2, τxy = -10 kN/m2 What is…

A: The angle of intersection is given by:

Q: 7. For the soil profile shown below, plot the variation of total stress, effective stress and pore…

A: Effective stress: The term effective stress is defined as the total stress minus pore water…

Q: Using equation 6.14, determine the vertical stress (Aoz) increase below the center of paded area at…

A: Given Area = 6.35*3.35m^2 Depth 2m,4,6,8,10m q= 225kn/m^2 Calculate stress at different different…

Q: Problem1) According to the given soil profile, fill the table and plot the distribution of vertical…

A: Given data- Specific gravity Gs=2.7

Q: A rectangular foundation 4 m x 6 m transmits stress of 300 kPa on the surface of a soil deposit, as…

A: r=4m z=5m

Q: 8.10 An embankment shown in the figure is constructed. Compute and plot the distributions of the…

A: Given data z=10 m γt= 19.2 KN/m3

Q: A soil profile consists of a clay layer underlain by a sand layer, as shown in Figure. If a tube is…

A: From the soil mass, the pore is present that will be made by air and water. The pressure developed…

Q: The stresses on a failure plane in a drained test on a cohesionless soil are as given below: Normal…

A:

Q: For the stressed soil element shown, determine: 1. The major principal stress 2. The minor principal…

A: Note: Hi! Thank you for the question, As per the honour code, we are allowed to answer three…

Q: 7.12 Piot the distribution of total stress,effective stress, and pore- water pressure with depth for…

A:

Q: A 5 m-thick clay (Gs = 2.65, water content = 0.28) is overlain by a 4.50m-thick layer of sand (Gs =…

A:

Q: Refer to the soil profile shown. Given H1 = 9.89 m., and H2 = 4.4 m. If the ground water table rises…

A:

Q: 7. Consider a stress state where p = 15 and q 12. The relevant soil properties are o = 35° and c= 3.…

A:

Q: PROBLEM 2 (15 points): The magnitude of stresses of the soil element represented by the figure below…

A:

Q: Problem 2: A soil element is shown 5.4 kN/m2 in the figure on the right. The magnitude of stresses…

A: Answer:-                 It can solve by the help of formula for major and minor principal stresses.…

Q: A soil profile consists of a clay layer underlain by a sand layer, as shown in the figure. If a tube…

A:

Q: 6. From the given soil profile, the groundwater table is located 2m below the ground level. (See…

A:

Q: 8.10 An embankment shown in the figure is constructed. Compute and plot the distributions of the…

A:

Q: 3. 7.12 Plot the distribution of total stress, effective stress, and pore- water pressure with depth…

A: Schematic diagram of the soil profile: Given data: For soil up to the depth of 4.5 m (A-B): Void…

Q: Q # 3. State the following Failure Theories; Also write their specific equations for Failure…

A: *THEORY OF FAILURE:- Under uniaxial loading circumstance prediction of failure may be very smooth…

Q: Q1 A hydraulic structures shown in fig. determine 1- the uplift pressures corrected at key points by…

A: First consider simple profile of floorstraight, horizontal and with negligible thickness Given depth…

Q: 7.17 A soil profile consists of a clay layer underlain by a sand layer, as shown in Figure P7.17 If…

A: find :- Total , pore water and effective stress at points A,B & C Total and effective lateral…

Q: Plot the distribution of total stress, effective stress, and pore- water pressure with depth for the…

A: Following is the given soil profile:   Given: For soil up to the depth of 4.5 m (A-B): Void ratio,…

Q: 1. Suppose that the forces acting to the faces are distributed uniformly. Then find the thickness &…

A:

Q: An earth embankment is shown in the figure. Determine the stress increase at 2. point A due to the…

A: Given that...

Q: a) As a geotechnical engineer, explain why construction of foundations and other loads (structures)…

A: The explanations of the above given questions are as under

Q: (c). The magnitude of stresses have been applied on soil element where Normal vertical stress is 120…

A: Normal stresses are given and we have to find the stresses on the inclined plane given in question…

Q: Plot the distribution of total stress, effective stress, and pore- water pressure with depth for the…

A: Assume GS = 2.70 For unit weights: Above ground water table: Below ground water table:

Q: An earth embankment is shown in the figure. Determine the stress increase at point B due to the…

A: Consider the given diagram.

Q: Problem 1- Determine the shear stress at points A to D for the following section. Also determine the…

A: It is given that V=10 kN.

Q: A soil profile consists of a clay layer underlain by a sand layer, as shown. If a tube is inserted…

A: To Find Effective stress and Pore water pressure at point A,B & C.

Q: Using the principles of Mohr's circles for the soil element shown, Determine: a. Maximum and minimum…

A:

Planar Stresses