Answered: In the LTE downlink, what is the…

In the LTE downlink, what is the theoretical data rate that can be achieved with the minimum resource allocation if 64-QAM is used (assume a standard cyclic prefix)?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter25: Television, Telephone, And Low-voltage Signal Systems

Section25.1: Television Circuit

Problem 15R

See similar textbooks

Related questions

Q: Implement the below given function using 3-to-8 Binary Decoder with only NAND gates. f(w1,w2,w3) =…

Q: Given the following binary bit stream, draw the corresponding signal after applying the following…

Q: For 2048-point sequence FFT with signal to noise ratio of 30 dB, how many numbers of bits required…

A: The given parameters are as follows:- For a 2048-point FFT sequence, Signal to Noise ratio( SNR) =…

Q: and 1, we assume that, for a given binary channel, 30% of the time a 1 is transmitted; the obability…

Q: Given the following notation, solve and construct the following: a. J (E,F,G,H) = Σ…

Q: a) Binary data is to be sent at the rate R, = 100 K bits/s over a channel with 40 dB transmission…

A: we need to calculate transmitted power.

Q: 2. A TDMA System operates at 100Mbps with a 2ms frame time. Assume that all slots are equal length…

Q: When А В are the inputs to a NAND gate, what is the output expression according to De Morgan's…

Q: (16) PSK and coherent ASK systems use the same peak pulse amplitudes and Ha the same values of P,…

Q: A binary data stream needs to be transmitted at 4 Mbit/s by means of binary signaling. To reduce ISl…

A: The pulse rate for this system is given by, 1T=2fB1+r where, fB=bandwidth1T=Data Rater=roll-off…

Q: using OR gate Desgin (NAND, AND, NORINOG) gate

A: NAND, AND, NOR, and NOT gate is designed by using OR gate as shown below

Q: 20.a. More spares should be purchased for equipment with a small A. receiver sensitivity threshold.…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: If a binary sequence of 100000001 is digitally encoded. Which line encoding format will most likely…

A: If a binary sequence of 100000001 is digitally encoded, the line coding format having…

Q: a) (no +35), =(?), = (?), = (?),6 b) Calculate the following subtraction using 10's complement…

Q: ght sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each output…

Q: Question 2: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: 5. A circuit-switch TDM-link uses 512-bit frames with 24 slots. a) How many circuits' are allocated…

Q: 4. a. What is meant by: i) Bit-masking? ii) 2's complement?

A: Given & to find: What is meant by: i) Bit-masking ii) 2's complement

Q: If the 7 bit hamming code word received by receiver is 1011011 , assuming the even parity, state…

A: Hamming code: R.W. Hamming develop hamming code for error correction. this method, encodes the…

Q: What is the probability of error with a PSK system with a bit rate of 20kpbs, BW of 50 kHz, Noise…

A: The solution is given below

Q: Draw constellation diagram of 8-QAM modulation?

A: CONSTELLATION DIAGRAM: 1. When dealing with multilevel ASK(Amplitude Shift Keying), PSK (Phase…

Q: A binary CP-FSK receiver observes the following phases: 0,3π/4,37π/2, π/4, π,7π/4, π, π/4 What is…

A: It is given that: 0,3π4,3π2,π4,π,7π4,π,π4

Q: This elementary problem begins to explore propagation delay and transmission delay, two central…

Q: Construct a 4-to-16-line decoder with five 2-to-4-line decoders with enable. Use block diagrams.

Q: How many OC signals are used in a SONET network with a 622.08 Mbps line rate? A. 8064 B. 4 C. 12 D.…

A: The solution is given below

Q: With a target BER=0.01, given SNR=30 dB, what is the maximum achievable data rate (in unit of bits…

A: The SNR is expressed in decibels. It may be calculated by dividing the signal power by the noise…

Q: What is the 64-QAM constellation and phase (in degrees with 3 significant digits only) of the point…

Q: 16. What should the PMD value be in a 10 Gbps fiber link? A. Exactly 10 ps B. Less than 7 ps C.…

A: For 10 Gbps (SONET OC-192) fiber transmission, the maximum value of the PMD should be 10 ps. For 10…

Q: 4) Illustrate the generation of noncoherent version of PSK signal for the input binary sequence…

A: Non-coherent PSK Generation : Initially, we are giving the input binary stream and delayed output…

Q: The operating point of a quadrature amplitude modulation QAM256 system is shown. This is a standard…

Q: How many OC signals are combined into a 40 Gbps SONET network

A: D) 516096 From table 39813.12 Mbps i.e 40 Gbps the number of OC signals/channels combined are 516096

Q: Q4. Consider the QPSK digital modulation scheme (a) What does the abbreviation QPSK stand for? (b)…

Q: The ATM protocol has a CRC for the payload * True *False What is the payload data rate of an…

A: According to the question, The ATM protocol has a CRC for the payload * True *False What is the…

Q: We need to use synchronous TDM and combine 20 digital sources, each of 100 Kbps. Each output slot…

Q: A call processor in exchange requires 240 ms to compute the call (call processing time). What is…

A: We are authorized to answer one question at a time, since you have not mentioned which one you are…

Q: Question 1. Calculate the peak LTE OFDMA downlink data throughput of 20-MHz channel bandwidth using…

A: Given data, The no. of sub-carriers for 20MHz channel bandwidth=256 and for 128QAM=27 so, 7 bits are…

Q: If the sequence "111111." is transmitted using Differential Manchester encoding, what is the ratio…

Q: Explain the operation of a 2 x 4 line decoder with enable and active low output.

Q: Draw constellation diagram of 8-QAM modulation? File upload

A: Modulation is process by which some properties of carrier signal is varied according tomodulating…

Q: Sketch the Bipolar RZ Voltage encoding on a classic Ethernet for the bit stream 0001110101.

A: RZ (Return to Zero) is a line coding system used wherein the signal returns to zero between each…

Q: If the sequence 111111 is transmitted using Differential Manchester encoding. what is the ratio of…

A: The baud rate is the rate at which information is transferred in a communication channel. The rate…

Q: 1.What is predecoding in decoders? how to implement predecoding with NAND and NOR gates?

A: Bartleby has policy to solve only first question. Reupload the question

Q: Six message signals each of bandwidth 5 kHz are time division multiplexed and transmitted.…

A: According to the question we have to determine the signaling rate and the minimum channel bandwidth…

Q: 7. QPSK modulation, pulse forming raised cosine roll off coefficient a 0.2, bit rate 200 kbit / s,…

A: Given; Coefficient a=0.2 Bitrate Rb=200 kbps

Q: III) Explain briefly about requirements of LTE. Also describe the challenges of OFDM-MIMO in LTE.…

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Concept explainers

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors. The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.

Question

Detailed answer please. Thank you

In the LTE downlink, what is the theoretical data rate
that can be achieved with the minimum resource
allocation if 64-QAM is used (assume a standard
cyclic prefix)?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. Determine the number of terminal phase states in the state trellis diagram for (a) a full response binary CPFSK with either h = 2/3 or 3/4 and (b) a partial response L = 3 binary CPFSK with either h = 2/3 or 3/4 .
Question 5: a) In the context of WCDMA, answer the following questions: What is the chip rate of WCDMA? i. ii. What is the duration for WCDMA frame? iii. For the figure shown below, what is the spreading factor? Symbol iv. V. vi. vii. Data Spreading code Spread signal Datax code Spreading What is the corresponding processing gain? For the figure shown below, what is the multiplexing mode used? Uplink Downlink Frequency Time WCDMA has a frequency reuse of 1 between different cells. What does that mean? If fast fading occurs when the path difference between two received signals is half wavelength. Calculate the path difference at a frequency equals to 2 GHz.
Explain with the aid of equations the following: i. How to improve the noiseless channel capacity? ii. How to improve the SNqR in the PCM system?
Given that the base address is FoH. 1. Create a new asm project “Lab2_Q1.asm". Assume that port A of 8255A PPI is connected to 8085. Write assembly code to send the value of FFH to FoH. Enter a delay of 2 ms for each transmission.
The %-error for the 12 bit linear PCM code for a voltage of 0.318V and a resolution of 0.01V when sent using companding is ________ %.
On our MCS, which chip is used for uni-directional bus buffering? 74LS
Consider the baseband signaling of the textual message 'OK' (excluding the quotes) in a wired DCS using binary line codes. Assume to bit duration is 1 ms. (a) Covert the message "OK" into a bit stream based on the 6-bit ASCII standard. (b) Describe mathematically and plot the non-return to zero code. evel (NRZ-L) line Stu (c) Describe mathematically and plot the bi-o-L (Manchester) line code. (d) escribe mathematically and plot the bipolar level line code.
19. With necessary diagrams and equations, describe the operation of different types of single-phase PWM inverters. Compare multiple-pulse and sinusoidal pulse modulation schemes with single-phase PWM scheme.
Consider a binary sequence with a long sequence of Is followed by a single "0" and then a long sequence of "1s" as shown below. Draw waveforms for this sequence, using the following formats: (a)Unipolar RZ signaling. (b) Bipolar NRZ signaling. (c) Spilt - phase (Manchester) signaling. Binary sequence: 1111011111
Q6: Sectoring is a way to do what? a. Achieve branch circuits. b. Put each phone call in a different time slot. c. Do SS7 look-ahead call placement. d. Partition Voice mail boxes e. It is an ISDN-PRI way of brining in trunks f. Achieve frequency reuse. g. None of the above
Q12: CSMA/CD is a protocol used in what Data Link Layer protocol? a. Polling b. Token Passing bus c. Token Passing ring d. Ethernet e. TDMA f. FDMA g. CDMA h. None of the above
Answer all questions below: 1. Draw the general block diagram of Frequency Division Multiplexing (FDM) 2. Multiplexing is a technique that allows the (simultaneous) transmission of multiple signals across a single data link. Figure Q2 below shows a multiplexer with four 500 kbps data stream inputs and 1 data stream output where the unit of data is 1 bit. Determine: i. ii. iii. 500 kbps The type of multiplexing technique used. The input bit duration. The output bit rate. 500 kbps 500 kbps. 500 kbps. ... ... ... 1 0 1 0 1 0 1 0 0000 1 1 1 1 0 1 0 0 MUX Figure Q2 Frames 0101 0001 110100010101