Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω connected in parallel. if we apply average value of 198 V sinusoidal AC voltage to the system . Find the line current, impedance and phase angle of the circuit. (Take Frequency in 60 Hz)

Circuit elements with an inductance of 200 mH, a capacity of 50 μF and a resistance of 10 Ω connected in parallel. if we apply average value of 198 V sinusoidal AC voltage to the system . Find the line current, impedance and phase angle of the circuit. (Take Frequency in 60 Hz)

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: (b) Given that a total impedance of a series circuit is Z = 10 – j13 Q and the operating frequency…

A: In this question, Total impedance Z= 10-13j Operating frequency f= 60Hz. Sketch the series and…

Q: A coil of wire having a value of (5 + j8) ohms is connected in series with a capacitive reactance…

Q: A parallel circuit of 25 – ohm resistor, 64 – mH inductor and 80 - μF capacitor connected across a…

Q: For the given circuit, Is 2 kW 1kVar (cap.) + 2 kV A 4 kW 0 + j100Vrms (~ 0.7pf leading 0.9pf…

Q: Voltage Supply, VL = 450 V Frequency, Felec. = 50 Hz Resistance, R = 352 per phase Inductance, L =…

A: It is given that: VL=450 VR=35 Ω/phL=0.55 H/phfelec=50 Hz

Q: FN.Q4 – Each phase of a star-connected load comprises a resistance of 56 2 and a 155 mH inductance…

Q: 2. An impedance of 4-j3 ohms is connected in parallel with an ideal inductor L across a 110V, 60hz…

A: We need to find out value of inductance for given condition in the given circuit

Q: A coil of wire having a value of (5 + j8) ohms is connected in series with a capacitive reactance…

A: A coil (5 + j8) ohms with in series with a capacitive reactance Xc, this series combination is then…

Q: In Industry, three Inductive loads, each of resistance R = 30 ohms and inductance L = 0.13 H are…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: Q3 For the circuit shown calculate the following :Calculate the impedance of the R = 20 X, = 60 A =…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: A non-reactive resistance of 60 Ω is connected in series with a 36 µF capacitor in each phase of a…

Q: 1. Given a Parallel Resistive - Inductive circuit as shown, determine the: 240 V 60 Hz R 152 = =…

A: Given A parallel resistive - inductive circuit. We need to determine the inductance of the…

Q: When drawing three-phase inductive 250 kW from the 440 V transmission line, the power coefficient is…

A: The complex power in an AC system is defined as the product of rms value of applied voltage and…

Q: Example-Series-1: For the RL circuit, find (1) w, T, L, ZT (2) I†, VR, V L (3) Average power of each…

Q: 1. For the following circuit derive the equation for the power factor, where the conducting angle a…

Q: a) Answer all questions. 1. Which of the following is not an application of transmission line? a.…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A single-phase, 50 Hz, RLC circuit draws a current of 3.5 A. The value of the R, L and C are 80 N,…

A: Given that f=50HzR=80 ohmL=175 mHC= 30 μFI=3.5 A Now calculate inductive and capacitive impedance of…

Q: In Industry, three Inductive loads each of resistance R = 29 ohms and inductance L= %3D 0.06 H are…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: In Industry, three Inductive loads each of resistance R = 20 ohms and inductance L 0.04 H are…

Q: Example23/ Two transformers are designed to match a line having a Z, = %3D 3002, ZR = 75.2 find…

Q: In Industry, three Inductive loads, each of resistance R = 30 ohms and inductance L= 0.13 H %3D %3D…

A: In the Star Connection, the 3 winding's similar endpoints are connected to a common point known as…

Q: In a three-phase system, the apparent power of a consumer is 700 kVA with a power factor 0.7,…

A: Given values are - S=700kVAcosϕ=0.7LaggingVt=400Volt Given that capacitors are connected in delta.

Q: A 440Vrms, 60-Hz source supplies two loads connected in parallel : Load 1(L1): 12 kVA, 0.70 pf…

Q: A 270 kV, three phase transmission line vith a 430 km length. The series mpedance Z =(0.345+j0.794)…

A: Transmission line parameters are given Find the T and π model equivalent circuit parameters

Q: BA series-connected load draws a current i(t) = 4 cos(315t + 10°) A when the applied voltage is v(t)…

A: According to question we have to calculate the value of Apparent power, power factor and value of…

Q: 2. A delta-connected load with 500 resistance, 209mH inductance and 50µF capacitance in series per…

A: In this question we need to find a phase current of the given three phase circuit.

Q: Consider the network depicted in the following figure, and determine the equivalent impedance seen…

Q: а. Still using the circuit above, If it = 0.4931 - 0.1675 j Amperes, running around the loop through…

Q: Calculate the conductance, susceptance and admittance of an impedance that is equal to Z = (3.6 +…

Q: An electric system is rated 20 kVA, 240 V at a 0.558 lagging power factor: a) Determine the…

A: Given, Rated power, 10 kVA Voltage, 240 V Power factor, cosϕ= 0.558

Q: Suppose that the current, i, through a resistor is described by the function i(t) = (60 – t)? + (60…

Q: The balanced system below has a phase voltage of 120 V. It supplies a balanced load Z1 that has…

A: In this question we need to find a total reactive power and true power of the given three phase…

Q: In Industry, three Inductive loads, each of resistance R = 30 ohms and inductance L = 0.13 H are…

A: Phase impedance = R +XL. Where XL is inductive reactance = WL. L is inductance. For delta connected…

Q: In Industry, three Inductive loads each of resistance = 32 ohms and inductance L = 0.16 H are…

A: According to question: a) Phase impedance…

Q: In Industry, three Inductive loads, each of resistance R = 22 ohms and inductance L = 0.07 H in…

Q: Consider an AC circuit with voltage and current equations given as below: v(t) = 120 cos(377t + 45°)…

Q: For the circuit shown in the following figure, a) Find and draw the Thévenin equivalent circuit at…

A: Given that Electrical network as follows

Q: 3 An air line has a characteristic impedance of 70 Q and a phase constant of 3rad/m at 100MHZ.…

A: Characteristics impedance is given 70 ohm Frequency is given f = 100 MHz Phase constant is given β=3…

Q: A transmission line has generalized circuit constants are A=0.93+j0.016,B=20+j140.The load at the…

A: Parameter values of given transmission line is shown below

Q: 3. A. A coil consists of a resistance of 200 N and an inductance of 2500MH. If an alternating…

Q: A factory is supplied with a 3-phase 6600V 60 hz transmission line. The factory has the following…

Q: Given a mesh connected system with reactive factor of 60 percent and true power of 2,500 kW.…

A: We need to find out reactive power

Q: In Industry, three Inductive loads each of resistance R= 24 ohms and inductance L = 0.13 H are…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Given a mesh connected system with reactive factor of 60 percent, true power of 2,500 kW and phase…

A: A network in which devices or nodes are linked together, branching off other devices or nodes known…

Q: 6. A 240-Vrms 50-Hz supply serves a load that is 10 kW (resistive), 15 KVAR (capacitive), and 22…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: IV. A impedance of Z = 25453.13°Q is connected across a source with a voltage of 169.706 sin…

Q: 1.2 Two circuits, the impedances of which are given by Z = 10 + j15 2 and %3D Z, = 6 - j8 2 are…

A: According to question we have to calculate the value of power taken by each branch.

Question

100%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The admittance of a circuit is (0.03-j0.04) Siemens. Find the value of resistance and inductive reactance of the circuit if they are joined a)in series and b) in parallel.
When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed frequency, there is a current of 0.332 A in the resistor. When an inductor is connected across the terminals of the same generator, there is a current of 0.365 A in the inductor. When both the resistor and the inductor are connected in series between the terminals of this generator, what is (a) the impedance of the series combination and (b) the phase angle between the current and the voltage of the generator? Note: The ac current and voltage are rms values and power is an average value unless indicated otherwise. (a) Number (b) Number Buda i Vrms R Irms.R Circuit 1 Units Units Vrms. Irms, L Circuit 2 > L Vrms R www Circuit 3
Impedance of AC circuit and Admittance of AC circuitSHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN DRAW IT MANUAALYY thNAKSS
Three Impedances each of (8 - j24)2 are connected in mesh across a three-phase 420V ac supply. Determine the phase current, line current, active power, reactive power drawn from supply. Also draw the Phasor diagram for the mesh connection and marks the Line current ,phase current line voltage and phase angle between phase current and pahse voltage. phase current (Ip) Line current real power reactive power
Which component of impedance is not dependent on the frequency of the source of voltage? A. capacitance reactance B. inductive reactance C. resistance D. all are independent of the frequency of the source
an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?
4) AC circuit analysis is performed as it was in DC except A) one must use phasors for the voltages and currents and use complex numbers for Impedance. B) one must use phasors for the impedance. C) complex numbers for the V/I ratio are used to represent the power. D) None of the above
A voltage and current applied to a single phase load is v= 195 sin (300t+35°) and i= 175 sin (250t- 40°). Find the single and three phase active and reactive power of the circuit if the voltage and current are in cos waveform. Active Power Reactive Power Three Phase Active power Three phase Reactive Power
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.
An inductive reactance of 6 ohm is connected in series with a parallel combination of a variable resistor R and a capacitive reactance of 15 ohm across 100V , 50 hz supply. a. Solve for the frequency so that the magnitude of the inductive reactance is 2 times the magnitude of capacitive reactance. b. Solve for the value of R so that the total current I will be maximum.
supply 3. Three circuits A, B and C are connected in series across 350 V supply. The voltage across circuit A is 80 V lagging the voltage by 330 and the voltage across circuit C is 140 V leading the supply voltage by 48°. Determine the voltage circuit B and its phase displacement from the supply voltage using wave and vector solution. across 4. Draw the phasor and wave diagram of the following sinusoidal current: