Two impedances consist of resistance of (15 ohms and series connected inductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henry and a capacitance of 100 microfarad, all in series) are connected in series and are connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltage across each impedance, (c) individual and total power factor.

Two impedances consist of resistance of (15 ohms and series connected inductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henry and a capacitance of 100 microfarad, all in series) are connected in series and are connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltage across each impedance, (c) individual and total power factor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Similar questions

A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
Derive the formula and relation for voltage and current in a pure resistive- AC circuit and prove that in this type of circuit, the current and the voltage are always in phase.
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following:a. Circulating currentb. Voltage across the resistorc. Voltage across the capacitord. Real power supplied by the source
Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.
Draw AC and DC equivalent circuit for the circuit given in Figure 4
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
There era two type of currents, a. direct current and b. alternating current. For each of these type, name as many as you can the specific application and discuss them as to their effectiveness And safety.
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
In order to obtain a highly links between two winding's, the coupling coefficient will be equal to . . of its maximum value. * .... ..... Twice One half Less than half More than half
write a report to compare between ac througe capactance and ac throughe in inductance then:for the cirucit shown beside, find the total impedance between a & b and cirucit current (I)