A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. There are 7% SUTs and 7% TTs in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, what value for the peak-hour factor was used?

A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. There are 7% SUTs and 7% TTs in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, what value for the peak-hour factor was used?

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter9: Capacity And Level Of Service For Highway Segments

Section: Chapter Questions

Problem 21P

See similar textbooks

Similar questions

A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, b.) Determine vp
A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, a.) Determine fy (Express in three decimals)
A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak-hour traffic volume is 3900 vehicles, c.) what value for the driver population factor was used? (Express in three decimals)
A six-lane freeway (three lanes in each direction) in a scenic area has a measured free-flow speed of 55 mi/h. The peak hour factor is 0.80, and there are 8% large trucks and buses and 6% recreational vehicles in the traffic stream. One upgrade is 5% and 0.5 mi long. An analyst has determined that the freeway is operating at capacity on this upgrade during the peak hour. If the peak hour traffic volume is 3900 vehicles, compute for the driver population factor used?
A four-lane freeway (two lanes on each direction) is located on mountainous terrain with 11-ft lanes, a 5-ft right-side shoulder, and a 3-ft left-side shoulder, and a 60- mph design speed. The freeway currently operates at capacity during the peak hour. If an additional 11-ft lane is added, and all other factors stay the same, what will the new level of service be?
A two-lane rural highway carries a peak hour volume of 465 (vph) and has the following characteristics: Roadway: 60mph design; 11 foot lanes, 2 foot shoulders; rolling terrain; 60% no-passing zones; length = 3 miles. Traffic: 70/30 directional split; 4% trucks; 2 percent recreational vehicles; 1 percent buses; PHF = 0.95 a) What Level of Service will the highway operate under during peak periods? b) What is the capacity of the highway? Explain why this is less than 2,800 (vph)?
A 6-lane urban freeway is suggested to be designed with the following data: F.ADT = 45000 vpd, design hour factor= 0.12 and directional split = 65%. Rolling terrain, 10% trucks, 5% buses, 6% Rvs, PHF is 0.91 and all traffic are commuters. Then based on the HCM 2000 procedure, the equivalent passenger- car hourly flow rate is about
A four-lane freeway with the following characteristics: ten foot travel lanes lateral obstructions at 0 feet at the roadside total ramp density is 4.5 ramps/mile rolling terrain The roadway has a current peak demand volume of 3500 veh/h. The peak hour factor is 0.95 and there are no trucks, buses, or RVs in the traffic stream because the roadway is classified as a parkway and such vehicles are prohibited. At what level of service will the freeway operate during its peak period of demand?
A four-lane basic freeway segment on level terrain is being redesigned. The current roadway has 12 ft lanes with 4 ft shoulders. The proposed alignment would expand to six 11-ft lanes with 2 ft shoulders. The road carries 3000 vehicles in the peak hour in one direction, with 925 coming in the peak 15 minutes. The truck mix is 70/30 and makes up 10% of traffic. What is the density and LOS (level of service) before and after the proposed change?
A six-lane freeway (three lanes in each direction) in mountainous terrain has 10-ft lanes and obstructions 5 ft from the right edge. There are zero ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The traffic stream consists of mostly commuters with a peak hour factor of 0.84, peak-hour volume of 2500 vehicles, and 4% recreational vehicles. What is the level of service?
If Vf = 2327 VPH with 9% trucks, VR1 = 653 VPH with 5% trucks, and VR2 = 594 VPH with 8% trucks, what is the passenger car equivalents (Vpcph) of the onramp? Assume that the roadway is urban.
A section of the roadway has the following flow-density relationship q=50k-0.4k^2 [q is in veh/h unit and k in vh/mile]. What is the flow, speed,and density at capacity? What is the density when highway is at one-third of its capacity.