A power station of 4 MW has an overall efficiency of 0.35 and a fuel calorific value of 7500 k.calorific /kg. If the loaf factor and plant capacity factor of the station is 0.8 and 0.7 respectively. The fuel cosumprtion in kg for one hour at *.maximum load 11467 O 17649 O non of them O 23544 29750 O

A power station of 4 MW has an overall efficiency of 0.35 and a fuel calorific value of 7500 k.calorific /kg. If the loaf factor and plant capacity factor of the station is 0.8 and 0.7 respectively. The fuel cosumprtion in kg for one hour at *.maximum load 11467 O 17649 O non of them O 23544 29750 O

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2 j0.125 Bus 1 j0.40 j0.20 j0.10 Bus 4
a) Explain briefly how electricity can be sold to a grid by use solar energy. b) Wind farm consist of ten wind turbines with nominal capacity of 2MWper turbine, has a total of 20 MW for farm as a whole, in year 2020, the farm produced a total energy 43416MWH, find a capacity factor.
Three phase Bridge rectifier operated from a 380V, 50Hz source throughout three-phase Y/Y connected transformer with ration 2:1. The load current has continuous character with negligible ripples and average thyristor current of 15A. The circuit inductance per phase is 1.2mH. The rectified voltage due to overlapping angle is 90 % of that voltage when this angle is neglected. 1- How much will the voltage drop be due to circuit inductance * 2- How much will the dc average voltage Vdc(alpha) be. 3- How much will the firing angle be ? 4- The overlapping angle. 5- How much is the percentage change of the output dc power if the thyristors T2, T4 and T6 are replaced by three diodes D2, D4, D6. 6- How much will be the maximum RMS phase current for the mentioned in previous task circuit ( semi-converter). 7- If an additional of 1 mH inductances are added to the existing inductances in the phases , how much will the overlapping angle be. The dc load current is kept constant & the…
A 6 ampere supply has a frequency of 25 Hz. Find the instantaneous value of current a. at 0.00986sec from zero going to the positive direction. b. at 0.00986 sec from zero going to the negative direction. c. at 986 degrees. Show complete solutions.
Q4. The source current in the circuit shown is in Figure 3a) What impedance should be connected across terminals a,b for maximum average powertransfer?b) What is the average power transferred to the impedance in (a)?c) Assume that the load is restricted to pure resistance. What size resistor connected across a,bwill result in the maximum average power transferred?d) What is the average power transferred to the resistor in (c)?v
A primary feeder has 3200kW an annual peak load input and at the time of peak load it has a total copper loss 150kW. The total annual energy supplied to the feeder is 7.5 x 106 kWh. Determine the following: 1) The annual loss factor 2) The total annual copper loss energy 3) The cost of total annual copper at BD 0.05/kWh.
The 3-phase half-wave rectifier given in the figure is connected to 3-phase 380 380 V 50 Hz network and feeds 20 Ω ohmic load. Plot the average value of the current flowing through the load and the waveform (vdc) of the voltage across the load on the dashed curves given.
shown in the below figure. The reserve capacity in the plant at 70% capacity factor is bne MW4 90 50 puig 7.2 lust % Time 100 500 0 (а) zero (b) 10 MW (d) 50 MW (c) 30 MW
A 120 V, 60 W lamp is to be operated on 220 V, 50 Hz supply mains. For the lamp to operate in correct voltage, calculate the value of (i) non-inductive resistance and (ii) pure inductance (U.P.T.U. 2005–06)
2. Syngas enegy content is about....... a. Two time of natural gas b. Half of natural gas c. No energy is available
3. Explain the environmental impacts of Geothermal power plant
Identify the characteristics of AC and DC voltage. Runs at a higher temperature Answer 1Choose...DCAC More dangerous to transfer Answer 2Choose...DCAC Easy to produce Answer 3Choose...DCAC Easier to transform voltages Answer 4Choose...DCAC Voltage remains at a constant value Answer 5Choose...DCAC Cheaper to produce