Silicon 5 R1 V1 AC 10 V3 2 Vout

Q: Calculate the Period T and Frequency f.

A:

Q: Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this…

A: Given the real power P and the power factor pf, we can find the apparent power S using the formula:…

Q: Ac - 100 Vrms R1 - 1k R2 - 500 Rload - 1k Capacitor - 2uF Q1. How much is the capacitor voltage…

A: To determine the phase lag between the capacitor voltage and the AC source voltage, we need to…

Q: not sure what to do here

A: The reactance of inductor is defined as, The impedance of inductor is defined as,

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A:

Q: An AC source has an output rms voltage of 78V at a frequency of 80Hz.  If the source is connected…

A: Given data, The value of inductance L = 25 mH = 25×10-3 H. The value of rms voltage is Vrms= 78 V.…

Q: A sinusoidal voltage having a maximum amplitude of 625 V is applied to the terminals of a 50 n…

A: Average Value of a signal:  It's that steady state equivalent of a time varying signal which would…

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Square voltage wave

Q: The sinusoidal current waveform having the maximum value of 10 A, then the R.M.S value is

A: The value of peak current is given as: I=10A The value of RMS current is given as: IRMS=I2

Q: The sinusoidal current waveform having the R.M.S value of 25 A, then the maximum value is

A: Rms value of the current = 25A Maximum current?

Q: Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

A: Given two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in…

Q: series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100…

A: In this question we will find overall power factor and voltage drop across impedance...

Q: The sinusoidal current waveform having the R.M.S value of 65 A, then the maximum value is

A: For sinusoidal current maximum value=2×R.M.S value

Q: In an RL series circuit, current lags the voltage by 90°. Select one: O True O False In CRO, the…

A: Current in impedance =( voltage across it)/ (impedance in ohms) Using above relation we will find…

Q: For the circuit shown below, determine: a) Amplitude of the Voltage Source b) RMS value of the…

A:

Q: 9. What will be the impedance of a LR-C circuit if it has a circuit current of 3A and a supply…

A: 9. Answer: 40 ohm Explanation: a. It is not a valid option, By using ohms law the resistance is the…

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 5ms/cm and the…

A: Here each square box is 1 cm x 1 cm And 1 cm length is divided into 10 parts.

Q: Given: Vi = Vpeak Sin wt V Vpeak %3| = 5 V With the ideal foward voltage = 0.7V, draw the waveforms…

A: It is given that: V1=VPeak Sin ωtVPeak=5VRL=1KΩVD=0.7V

Q: A. Find the total impedence Zt in polar form. B. Draw the impedence diagram. C. Find the current and…

A:

Q: Determine the rms current in the figure for Vrms = 16 V and C = 74µF V f=10 kHz C

A: RMS voltage is given Vrms=16 V. Capacitance C=74 μF. Frequency f=10 kHz.

Q: How can you tell which phasor is lagging when the two phasors don’t start in the same location such…

A: It is given that:

Q: Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine…

A:

Q: shown in the Vps low is Write the FORMULA for the total impedance of the circuit Zut= R²+ cL- Write…

A:

Q: A voltage wave of 250 kHz has a Vmax=5 V and Vmin=-35 V. The duty cycle of this wave is 0.875. This…

A:

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance.         C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: The sinusoidal current waveform having the R.M.S value of 55 A, then the maximum value is

A: R. M. S value of sinusoidal waveform = 55A Maximum value = R. M. S value *√2

Q: The sinusoidal current waveform having the R.M.S value of 60 A, then the maximum value is

A: We need to tell about the maximum value from RMS value.

Q: QUESTION 6 at is the value the following sinusoidal voltage signal v(t) = 183 cos (234t+53°) V at t…

A:

Q: A sinusoidal signal takes 4.33 seconds to complete one cycle. What is the frequency of that signal?…

A: Given: One time period of SInusoidal waveform = 4.33 seconds  Need to calculate the frequency of…

Q: Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this…

A: Using the formula, we can get the apparent power S given the real power P and the power factor pf.:…

Q: The sinusoidal voltage trace displayed by the CRO, the time/cm switch is on  50 µs/cm and the…

A:

Q: 3 Find average value, RMS value and form factor of waveform shown in figure.

A: Given, Imax=5T=1  (time period) RMS value, Taking straight line equation,…