1MV ll zain IQFirst Quiz.pdf->First QuizA generating station has a maximum demand of 10 MW. Calculate the cost per unit generatedfrom the following data:Annual load factor= 35%Capital cost= Rs 12,50.000Annual cost of fuel and oil = Rs 8.00.000Taxes, wages and salaries = Rs 7,00,000Interest and depreciation = 10%

The cost per unit can be calculated as follows.

A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the following data: = 35% = Rs 12,50,000 Annual load factor Capital cost Annual cost of fuel and oil = Rs 8,00,000 Taxes, wages and salaries = Rs 7,00,000 Interest and depreciation = 10%

A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated from the following data: = 35% = Rs 12,50,000 Annual load factor Capital cost Annual cost of fuel and oil = Rs 8,00,000 Taxes, wages and salaries = Rs 7,00,000 Interest and depreciation = 10%

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: Example 2: Determine the Per Unit Impedances by taking 150 MVA and 11 KV in generator side as base…

A: Per unit, the method is very important for the calculation of a large power network. As we use…

Q: 3. A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

Q: The tariff in force is Rs 150 per kVA of maximum demand and 8 paise per unit consumed. If the load…

A: We have an tariff of RS 150/KVA of maximum demand . Energy charge/unit = 8 Load factor = 30% = 0.3…

Q: Q2) A generating station has a maximum demand of 30 MW, a load factor of 0.6 and plant use factor of…

A: As per the guidelines of Bartleby we supposed to answer first three subparts of the question.

Q: A generating station has a connected load of 40 MW and a maximum demand of 20 MW : the units…

Q: A 3-phase, 420 V, 60 Hz, Y-connected synchronous generator, with a synchronous reactance of 1.20 Ohm…

A: As we have given: VL=420 Vf=60 HzXs=1.2 ΩZs=j1.2 Ωδ=30°Pout=110 kW Step 1: Find E As we know that,…

Q: A transmission line has an actual impedance of 18 ohms, compute for the per unit impedance of this…

Q: A generating station supplies the following loads: 15000 kW, 12000 kW, 8500 kW, 6000 kW and 450 kW.…

A: Total loads are 15000 kW, 12000 kW, 8500 kW, 6000 kW and 450 kW.

Q: Example 4.5. A generating station has an installed capacity of 50,000 kW and delivers 220 × 10 units…

Q: Read the question carefully and match the answer with its respective question: It has been predicted…

A: given present load factor = 0.67 present year maximum demand = 6 MW load factor = average…

Q: GENERATING STATION HAS A CONNECTED LOAD OF 40 MW AND A MAXIMUM DEMAND OF 20 MW : THE UNITS GENERATED…

A: In the question Connected load= 40 MW Maximum load=20 MW THE UNITS GENERATED BEING 60×10^6.…

Q: The total installed electric generating capacity of Pakistan is about 38719 MW. Find the installed…

A: The total installed capacity of the public sector power plants in the country was 19621 MW while the…

Q: A power plant has two units with the following cost characteristics: Rs C = 0.7P? + 220P, + 2500 %3D…

Q: A Wind Energy Conversion System with the following data: Downward wind velocity:9 m/s Upward wind…

Q: 17. What is the share of renewable energies on the total electrical energy generated for 2019/2020?…

A: Introduction:. Electricity is produced using all sources of renewable energy. Geothermal steam is…

Q: A power station has a maximum demand of 100 MW and produces 1008 × 10^3 units per day. The power…

Q: 1. a) Two generating units has the following fuel cost, determine the economic load scheduling of…

A: Solution- Given, F1 =0.16 Pg12+0.22Pg1+100F2 = 0.0080 Pg22+0.22 Pg2+220 PL = 500 MW ∂F1∂P1 = 0.32…

Q: 1/The Nominal System Voltage is stepped-up at the Generating Station in preparation for the Power to…

A: In this answer let us try to understand whether the given statement is true or false.

Q: A 200 MW power station delivers 200 MW for 3 hours, 70 MW for 6 hours and is shut down for the rest…

A: We have an power station and we have been asked to find its annual load factor. Power station…

Q: The fuel-cost curves for a two generators power system are given as follows: C¡ (P1) = 600 + 15 · P1…

Q: A generating station has an average demand of 15 MW. If the plant capacity factor is 50 %, what is…

A: Given, Average demand = 15 MW Plant capacity factor = 50 % = 0.50

Q: Calculate the continuous power that will be available from hydroelectric plant having an available…

A: Givem Data: Efficiency = 0.96 * 0.86 * 0.97 density = 1000 head h = 300 m g = 9.81 Q = massflow =…

Q: generating station supplies the following loads: 15000 kW, 12000 kW, 8500 kW, 6000 kW and 450 kW.…

Q: A particular area can be supplied either by hydro station or steam station. The following data is…

Q: on of the Tariff characteristics is to be fair by charging the big consumer a high rate than the…

A: The first question is subjective and hence out of scope. The solution for rest two questions is as…

Q: For a Power System, following data are given: Bus Data Voltage Magnitude in pu MW |1.03|20° Bus No…

A: A single-line diagram, sometimes known as a one-line diagram, is a simplified notation for…

Q: A utility company is running three generators (where the system demand for the current time period…

Q: B- A generating station has a capacity of 40 MW. If the annual capacity factor is 50%, whereas the…

A: generating station has a capacity of 40 MW If the annual capacity factor is 50%, the annual load…

Q: Q1.An industrial load can be supplied on the following alternative tariffs. (a) H.V. supply at Rs.…

A: An transformer is a device used for the conversion of electrical energy from one AC circuit to…

Q: 2. A generating unit of 10 MW capacity supplies the following loads: Domestic consumers with a…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: A system is working at its maximum kVA capacity with a lagging power factor 0·7. An anticipated…

Q: Cost of a 600 kW wind turbine is $ 550000. Other initial costs including that for installation and…

A: Given Power PR =600 kW capacity factor =CF =0.25 number of years n=20 interest rate I=5% =0.05 land…

Q: Peak demand of a generating station is 90 MW and load factor is 0.60. The plant capacity factor and…

A: In the given question peak demand of generating station load factor, plant capacity factor and plant…

Q: Calculate the cost of generation per KWh for a power station having the following data Installed…

A: It is given that: Installed capacity of the plant=200 MWCapital cost=Rs. 400 croresRate of interest…

Q: What is the Total Actual Energy Generated by Davao Power Plant if there are (4) substation with 1.12…

Q: Question 1: A power system network with a thermal power plant is operating by four generating units.…

Q: A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

Q: A base load station having a capacity of 18 MW and a standby station having a capacity of 20 MW…

A: Given: Installed capacity of standby unit =20 MW Installed capacity of base load plant =18 MW…

Q: Compare the annual cost of power supply to a factory having a maximum demand of 500 kW and a load…

A: The solution can be achieved as follows.

Q: . A power plant has the following given data: load factor of 0.48; installed capacity 35 MW; reserve…

A: In this question we need to find the plant use factor.

Q: A base load station having a capacity of 18 MW and a standby station having a capacity of 20 MW…

A: The annual load factor is given by the expression as shown below: Annual load factor=total kwh for…

Q: Given two thermal generating units with the following polynomial cost functions: Coal Fired: ( F(P)…

A: Choose the correct option What is power generation by Generator G1 and G2 for economic dispatch…

Q: Two generating units have the following characteristics: Unit 1 (Gas): H,(P1) = 100 + 4*P, +…

A: For a starting value of Y = 12s / ton, the cost of coal burnt during time period 2 is equal to…

Q: Q3//A// Peak demand of generating station is 90MW and the load factor is 0.6. The plant capacity…

Q: Q1: A generation unit has a daily data, with maximum load of 300 kW, plant capacity factor is 55 %…

Q: QUESTION THREE Calculate the two part tariff on the basis of ZMK per KVA of maximum demand and ngwee…

A: Two-Part Pricing (also called Two Part Tariff) = a form of pricing in which consumers are charged…

Q: A generating station supplies the following loads : 15000 kW, 12000 kW, 8500 kW, 6000 kW and 45 kW.…

A: The solution can be achieved as follows.

Q: A generating station has a connected load of 43 MW and a maximum demand of 20 MW; the units…

A: Given a generating station having, Connected load = 43 MW Maximum demand = 20 MW Units generated…

Question

1MV ll zain IQ
First Quiz.pdf
->
First Quiz
A generating station has a maximum demand of 10 MW. Calculate the cost per unit generated
from the following data:
Annual load factor
= 35%
Capital cost
= Rs 12,50.000
Annual cost of fuel and oil = Rs 8.00.000
Taxes, wages and salaries = Rs 7,00,000
Interest and depreciation = 10%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

5. Draw the daily load curve and load duration curve for a power station with any arbitrary loads you like. From the load curve, determine the following. i. Maximum demand ii. Average demand ii. Daily energy consumption
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.
Load on a small power station is as under. Draw the load curve and calculate 1. Maximum demand 2. Units generated in a day 3. Average demand 4. Daily load factor.
1-Alternators can be overloaded by 10 percentage for 10-15 minutes, this a. Steady state voltage stability will get affected b. may reduce the stability limit c. may disturb Nose point d. may lose Angular stability 2-Often, the network is referred as an infinite bus when a change in input mechanical power or in field excitation to the unit does not cause an appreciable change in a. system frequency or terminal voltage b. system frequency alone c. system frequency and terminal voltage d. Total production cost
Peak demand of a generating station is 90 MW and load factor is 0.60. The plant capacity factor and plant use factor are 0.50 and 0.80 respectively. Determine (i) daily energy produced (ii) installed capacity of plant (iii) utilization factor.
For a power station the yearly load duration curve is a straight line from 50,000 to 4000 kw. To meet the load three turbo-generators are installed. The capacity of two generators is 16,000 kw each and the 3rd is rated at 7,000 kw. Determine the following a) Load factor. b) Capacity factor. c) Maximum demand.
Hoover Dam has a nameplate capacity of 2080 MW[] and an annual generation averaging 4.2 TW·h. (The annual generation has varied between a high of 10.348 TW·h in 1984, and a low of 2.648 TW·h in 1956.) Determine the capacity factor. Ans. 23% (Show the Solutions)
Borduria Generation owns three generating units that have the following cost functions: Unit A: 15 + 1.4 PA + 0.04 P2 A $/h Unit B: 25 + 1.6 PB + 0.05 P2 B $/h Unit C: 20 + 1.8 PC + 0.02 P2 C $/h How should these units be dispatched if Borduria Generation must supply a load of 350 MW at minimum cost?
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
Explain about the power production scenario and write down about the growth.
A generating station has a maximum capacity of 100 kW and costs $300,000. The annual fixed charges are 12% of the cost of the generating station consisting of 5% interest, 5% depreciation and 2% taxes. Find the fixed charges per kWh generated if load factor is (a) 100% and (b) 25%.
A generating station has a connected load of 43 MW and a maximum demand of 20 MW; the units generated being 61.5 x 106 kWh per annum. Determine the demand factor and load factor of the system is.