(a)
Interpretation:
Number of moles of ascorbic acid in the sample has to be identified.
Concept introduction:
In order to express the concentration, many units have been used. One among them is
Molarity, defined as number of moles of solute divided by number of liters of solution.
Given by,
(b)
Interpretation:
Molarity of ascorbic acid in in fruit juice has to be identified.
Concept introduction:
In order to express the concentration, many units have been used. One among them is
Molarity, defined as number of moles of solute divided by number of liters of solution.
Given by,
(c)
Interpretation:
Number of moles of ascorbic acid in the sample has to be identified.
Concept introduction:
In order to express the concentration, many units have been used. One among them is
Molarity, defined as number of moles of solute divided by number of liters of solution.
Given by,
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
Fundamentals of General, Organic, and Biological Chemistry (8th Edition)
- MD ordered morphine SO4 gr 2/5 and the pharmacist has a stock solution of gr 1/8 per milliliter of morphine SO4. How many milliliters of the stock solution is required to fill the Rx?arrow_forwardA 100 mL solution of 0.1 M glycine at pH 1.72 was titrated with 2 M LIOH. The pH was monitored and the result were plotted as shown in the graph. The key points of the titration are designated as I to V. Identify the key point in the titration corresponding to the pH at which the carboxyl group is half deprotonated. 12 JL30 (V) 9.60 (IV) 8 5.97 pH 6 2.34 CII) 2 (I) 0.5 1.0 1.5 2.0 OH (equivalents) IV O Il and IV Nextarrow_forwardPotentiometric titration curve is given below, which is obtained during the potentiometric titration between strong base KOH (0.2 M) with strong acid HI, label the point in the curve from the following options. If more than one points are present than write as x, y(means separate by using comma) a)The point where pH is because of excess OH - ions. b) The point where pH is only because of HI in water. c)The point where [HI]= [I] in water. d)The point where pH=pka e) The point where all HI is neutralized. f) The point where pH corresponds to solution of [I- ] in water. 14 13 12 11 10 9 pH 6. TITIT TITarrow_forward
- What mass of sodium glycolate (NaC2H3O3) should be added to 400.0 mL of 1.00 M glycolic acid to produce a buffer solution with a pH of 4.00? Ka = 1.47 x 10-4arrow_forwardCalculate the normality of a solution that contains 4.5 g of (COOH)2 in 3000 mL of solution? (Assume the (COOH)2 is to be completely neutralized in an acid-base * reaction.) 0.033 N O 0.33 N O 0.166 N O 0.0166 N 0.45 N O 0.045 N 000.0 OOarrow_forwardA monoprotic weak acid, HA, dissociates in water according to the reaction HA(aq) = H*(aq) + A¯(aq) The equilibrium concentrations of the reactants and products are [HA] = 0.290 M, H+| = 3.00 × 10¬4 M, and [A-] = 3.00 x 10-4 M. Calculate the value of pKa for the acid HA. pKaarrow_forward
- Given the titration curve of the hypothetical polyprotic acid X at 0.100 M concentration (pKa1=4.0, pKa2=8.0, pKa3=12.0) titrated with 0.600 M NaOH, identify the pH at point C, H, E, and M.arrow_forwardA 25.0 mL sample of a fruit juice requires 13.0 mL of 0.0100 M I2 solution for reaction. How many moles of ascorbic acid are in the sample?arrow_forward80mL of a 0.3M solution of hexapeptide Leu-His-Cys-Glu-Asn-Arg is adjusted to pH=pl. The solution is then titrated with 0.2M HCI to a final pH of 2.1. Sketch the titration curve, labelling the pH and volume axes. Indicate the volume of HCl needed to reach each relevant pKa value and equivalence point(s). Relevant pka values are: 2.1, 4.3, 6.0, 8.3, 9.8, and 12.5.arrow_forward
- A 0.578-g saltwater sample was titrated with 1.864 g AgNO3 solution to reach the endpoint of the reaction. Calculate the following by showing all necessary solutions: 1. mol AGNO3 if the AGNO3 solution was prepared by dissolving 5.0 g of AgNO3 in distilled water until 100 ml is reached. (MW AgNO3 = 169.87 g/mol) 2. % Cl in the saltwater sample (MM CI = 35.45 g Cl /mol CI" )arrow_forwardConcanavalin (ConA) is a 25.5KDa protein with pl of 4.7 and optical absorbance (A 0.1% 289) of 1.14. calculate the concentration of an aqueous solution of pure BSA protein with an absorbance of 0.66 at 280nm. give your answer in units of mg/ml ?arrow_forwardHighlight your values of A,B,C and D. For your question: A mL of B mol/L sodium phosphate solution is combined with C mL of D mol/L calcium bicarbonate. (Calcium bicarbonate is soluble.) A mL B mol/L C mL D mol/L 75.0 ml 0.300 67.5 0.350 Before you begin your reaction, you must accurately produce 1.500 L of your sodium phosphate solution from sodium phosphate trihydrate solid. Write out a procedure to explain all the steps you will take in the lab when making the solution to ensure that your solution concentration is accurate. Please include calculations that show the required mass of solid. Also include the correct names of all equipment used.arrow_forward