Concept explainers
(a)
Interpretation:
KCl should be classified as strong, weak or non-electrolyte.
Concept Introduction:
Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.
If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.
A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.
A material which will not conduct electricity at all is considered a nonelectrolyte.
(b)
Interpretation:
Concept Introduction:
Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.
If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.
A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.
A material which will not conduct electricity at all is considered a nonelectrolyte.
(c)
Interpretation:
Concept Introduction:
Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.
If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.
A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.
A material which will not conduct electricity at all is considered a nonelectrolyte.
(d)
Interpretation:
Concept Introduction:
Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.
If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.
A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.
A material which will not conduct electricity at all is considered a nonelectrolyte.
(e)
Interpretation:
Concept Introduction:
Conductivity of electricity is a physical property which is typical of species when dissolved in solution, typically, in an aqueous solution.
If the material dissolves properly in water, and conduces electricity, then this is said to be a strong electrolyte.
A material which dissolves and only conduces a small amount, will be considered a weak electrolyte.
A material which will not conduct electricity at all is considered a nonelectrolyte.
Want to see the full answer?
Check out a sample textbook solutionChapter 6 Solutions
Introduction To General, Organic, And Biochemistry
- 4-78 (Chemical Connections 4A) How does fluoride ion protect the tooth enamel against decay?arrow_forward4-81 (Chemical Connections 4C) Balance the lithium iodine battery redox reaction described in this sec tion and identify the oxidizing and reducing agents present.arrow_forwardIn the following acid-base titration experiment NaOH(aq) + HNO3(aq) ———> NaNO3(aq) + H2O(1). What is the molarity of the HNO3 solution if 18.3 mL of 0.115 M NaOH was used to neutralize 25 mL of HNO3? (a) 0.157 M (b) 0.0842 M (c) 3.978 M (d) 0.0157 Marrow_forward
- Which one of the following substances is a strong electrolyte in aqueous solution? (a) Vinegar (b) Glucose (C6H12O6) (c) Methane gas (CH4) (d) Ethyl alcohol (C2H5OH) (e) NaClarrow_forwardIs each of the following very soluble in water? Explain.(a) Benzene, C6H6 (b) Sodium hydroxide(c) Ethanol, CH3CH2OH (d) Potassium acetatearrow_forwardpleaaaaaaaase solve question 8arrow_forward
- Calculate the concentration in % (w/w) of the following solutions. Assume water has a density of 1.00 g/mL. a. 5.4 g of sugar and 1.50 x 102 mL of water Concentration = % (w/w) b. 4.2 g of any solute Concentration = -assignment-take and 2.50 x 10² mL of water % (w/w) c. 5.1 g of any solute and 2.00 x 10² g of any solvent Concentration = % (w/w) Submit Answer Retry Entire Group 2 more group attempts remaining Previous Email Instructorarrow_forwardQ1. A solution was prepared by dissolving 1210 mg of K3Fe(CN)6 (329.2 g/mol) in sufficient water to give 775 mL. Calculate (a) the molar analytical concentration of K-Fe(CN)6- (b) the molar concentration of K+. (c) the molar concentration of Fe(CN) (d) the weight/volume percentage of K3Fe(CN)6. (e) the number of millimoles of K1 in 50.0 mL of this solution. (f) ppm Fe(CN)6¹arrow_forwardLemons contain citric acid (C6H8O7). A lemon juice solution known to contain 1.6 g of citric acid was found to require 25.0 cm3 of 1 M sodium hydroxide solution for neutralization.(a) What is the molar mass of citric acid? (Relative atomic masses: C = 12.0, H = 1.0, O = 16.0)(b) How many moles of citric acid are present in the solution?(c) How many moles of sodium hydroxide are present in 25.0 cm3 of 1.0 M sodium hydroxide? (d) Is citric acid monobasic, dibasic or tribasic? Why?arrow_forward
- (1) To analyze the concentration of chloroform precursors, or natural organic matter, in a drinking water sample, which of the following instruments should be used? (A) TOC analyzer (B) GC (C) AA (D) IC (2) To analyze the concentration of cadmium (Cd) in a water sample, which of the following instruments should be used? (A) TOC analyzer (B) GC (C) AA (D) LC (3) To analyze the concentration of the chlorine residual in a water sample, which of the following instruments should be used? (A) TOC analyzer (B) GC (C) AA (C) AA (D) IC (4) To identify an unknown organic compound in drinking water, which of the following instruments should be used? (A) TOC analyzer (B) GC (D) IC (E) DPD Method (C) conductivity (E) GC/MS (5) To evaluate the quality of a drinking water sample, which of the following parameters may NOT be tested? (A) TSS (B) turbidity (D) TOC (E) coliformsarrow_forwardCalculate the number of moles and the mass of the solute in each of the following solutions:(a) 2.00 L of 18.5 M H2SO4, concentrated sulfuric acid(b) 100.0 mL of 3.8 × 10−5 M NaCN, the minimum lethal concentration of sodium cyanide in blood serum(c) 5.50 L of 13.3 M H2CO, the formaldehyde used to “fix” tissue samples(d) 325 mL of 1.8 × 10−6 M FeSO4, the minimum concentration of iron sulfate detectable by taste in drinking waterarrow_forwardCalculate the molarity of each of the following solutions: (a) 0.195 g of cholesterol, C27H46O, in 0.100 L of serum, the average concentration of cholesterol in human serum (b) 4.25 g of NH3 in 0.500 L of solution, the concentration of NH3 in household ammonia (c) 1.49 kg of isopropyl alcohol, C3H7OH, in 2.50 L of solution, the concentration of isopropyl alcohol in rubbing alcohol (d) 0.029 g of I2 in 0.100 L of solution, the solubility of I2 in water at 20 °C Please show work.arrow_forward
- Introduction to General, Organic and BiochemistryChemistryISBN:9781285869759Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar TorresPublisher:Cengage LearningIntroductory Chemistry: An Active Learning Approa...ChemistryISBN:9781305079250Author:Mark S. Cracolice, Ed PetersPublisher:Cengage Learning