Whether carbon disulphide should dissolve polycarbonate or not.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4, Problem 39CQ

To determine

Whether carbon disulphide should dissolve polycarbonate or not.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

2. In a copper-nickel system as shown in figure, an alloy composition of 35 wt% Ni was cooled down from the temperature of 1300°C. Sketch the expected microstructures at the point a, b, c, d and e and briefly describe the development of these microstructures in the equilibrium cooling. L. L (35 Ni) 1300 L (32 Ni) a (46 Ni) a(43 Ni) L (24 Ni) d 1200 1100 20 30 40 50 Composition (wt% Ni) Temperature (°C))

If the Ksp of Sn(OH)2 (s) is 5.33 x 10-27, what is the solubility of it in the unit of mg/L?

What temperature is required to obtain 0.4%C at a distance of 0.3 mm beneath the surface of a 0.22% C steel in 2h, when 1.1% C is present at the surface? Assume that the iron is FCC. (Please see figure 5.12 below for diffusion coefficient data. Please use your notes for a table of erf() function values Diffusion coefficient D (cm²/s) ܐ ܐ ܐ ܐ 10- 10-5 10- 10-10 10-11 10-12 10-13 10-14 10-15 Temperature (°C) 2000 1500 1200 1000 900 800 700 600 Cin graphite Mg in MgO Ca in Cao H in FCC iron C in FCC iron Fe in FCC iron Fe in BCC iron H in BCC iron C in BCC iron Fe in FeO 500 5 6 7 8 9 10 11 12 13 104 T(K) Figure 5-12 The diffusion coefficient D as a function of reciprocal temperature for some metals and ceramics. In this Arrhenius plot, D represents the rate of the diffusion process. A steep slope denotes a high activation energy.