The temperature at which the hollow shaft must be heated for the shrink fit to occur.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4, Problem 4.7P

To determine

The temperature at which the hollow shaft must be heated for the shrink fit to occur.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The assembly consists of a brass shell (1) fully bonded to a solid ceramic core (2). The brass shell [E = 115 GPa, a = 18.7 × 10-6/°C] has dout 50mm. and din = 35mm. The ceramic core [E = 290 GPa, α = 3.1 x 10-6/°C] has a diameter dout = 35mm. At a temperature of 15°C, the assembly is unstressed. AT = 60°C. Find the internal stress in the brass. = 200 mm Brass shell (1) (2) Ceramic core

The assembly consists of a brass shell (1) fully bonded to a ceramic core (2). The brass shell [E = 86 GPa, α= 18 × 10−6/°C] has an outside diameter of 33 mm and an inside diameter of 27 mm. The ceramic core [E = 320 GPa, α= 2.5 × 10−6/°C] has a diameter of 27 mm. At a temperature of 15°C, the assembly is unstressed. Assume L = 320 mm. Determine the largest temperature increase Δ⁢t that is acceptable for the assembly if the normal stress in the longitudinal direction of the brass shell must not exceed 65 MPa.

Another of the steel components manufactured by michael's company is steel railway track sections. Thecomponent has a length of 120m (at a temperature of -10°C) and is to be exposed to a temperaturerange of -10°C to 55°C. In order to calculate the gaps which need to be left between the sections michael'scustomer needs to determine the maximum length which each railway track section will expand to andmichael have been asked to carry out the calculation for them. michael have also been instructed to determinethe percentage change in volume and surface area when exposed to the same initial and finaltemperatures. The customer has informed him that the cross sectional profile of the railway track isrectangular and of breadth 14cm and height 32cm. Assume the coefficient of thermal expansion ofsteel is 12x10-6 /°C. Briefly discuss the changes that occur with in the steel as a result of the change intemperature.