Introductory Circuit Analysis (13th Edition)
13th Edition
ISBN: 9780133923605
Author: Robert L. Boylestad
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 3, Problem 14P
- In construction the two most common wires employed in general house wiring are #12 and #14, although #12 wire is the most common because it is rated at 20 A. How much larger in area (by percent) is the #12 wire compared to the #14 wire?
- The maximum rated current for #14 wire is 15 A. How does the ratio of maximum current levels compare to the ratio of the areas of the two wires?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
State the main constituent elements of electrical cables, as well as the materials from
which they may be made. Describe the following designations: H05VV-U 1G4 mm? and
LSXAV 3x16 mm?.
Two wires A & B made from two different materials have temperature coefficient of resistance equal to 0.0025 and 0.0005 ohm per C , respectively . It is desired to make a coil of wire having a resistance of 1200ohms with a temperature coefficient of 0.001 , using suitable lengths of the two given wires connected in series . Determine the required length of wire A ?
5. What is the resistance of a copper bus-bar with the dimensions shown figure below.
Chapter 3 Solutions
Introductory Circuit Analysis (13th Edition)
Ch. 3 - Convert the following to mils: 0.2Â in. 1/32Â in....Ch. 3 - Calculate the area in circular mils (CM) of wires...Ch. 3 - Prob. 3PCh. 3 - What is the resistance of a copper wire 200 ft...Ch. 3 - What is the area in circular mils of an aluminum...Ch. 3 - A 2.2 resistor is to be made of nichrome wire. If...Ch. 3 - What is the diameter in inches of a copper wire...Ch. 3 - A wire 1000 ft long has a resistance of 0.5 and an...Ch. 3 - A contractor is concerned about the length of...Ch. 3 - What is the cross-sectional area in circular mile...
Ch. 3 - Prob. 11PCh. 3 - Determine the increase in resistance of a copper...Ch. 3 - What is the new resistance level of a copper wire...Ch. 3 - In construction the two most common wires employed...Ch. 3 - Compare the area of a #12 wire with the area of a...Ch. 3 - Compare the area of a #20 hookup wire to a #10...Ch. 3 - For the system in Fig. 3.46, the resistance of...Ch. 3 - From Table 3.2, determine the maximum permissible...Ch. 3 - The resistance of a copper wire is 2 at room...Ch. 3 - The resistance of an aluminum bus-bar is 0.02 at...Ch. 3 - The resistance of a copper wire is 1.2 at room...Ch. 3 - The resistance of a copper wire is 25m at a...Ch. 3 - The resistance of a copper wire is 1 at 20C (room...Ch. 3 - If the resistance of 1000 ft of wire is about 1 at...Ch. 3 - Verify the value of 20 for copper in Table 3.4 by...Ch. 3 - Prob. 26PCh. 3 - Prob. 27PCh. 3 - A 22 wire-wound resistor is rated at +200PPM for a...Ch. 3 - A 100 wire-wound resistor is rated at +100PPM for...Ch. 3 - What is the approximate increase in size from a 1...Ch. 3 - If the resistance between the outside terminals of...Ch. 3 - If the wiper arm of a linear potentiometer is...Ch. 3 - Show the connections required to establish 4k...Ch. 3 - Find the range in which a resistor having the...Ch. 3 - Find the color code for the following 10%...Ch. 3 - Is there an overlap in coverage between 20...Ch. 3 - Given a resistor coded yellow, violet, brown,...Ch. 3 - How would Fig. 3.26(a) change if the resistors of...Ch. 3 - Find the value of the following surface mount...Ch. 3 - Find the conductance of each of the following...Ch. 3 - Find the conductance of 1000 ft of #12 AWG wire...Ch. 3 - Find the conductance of a 10,20 and 100 resistor...Ch. 3 - The conductance of a wire is 100 S. If the area of...Ch. 3 - Why do you never apply an ohmmeter to a live...Ch. 3 - How would you check the status of a fuse with an...Ch. 3 - How would you determine the on and off states of a...Ch. 3 - How would you use an ohmmeter to check the status...Ch. 3 - Using metric units, determine the length of a...Ch. 3 - Repeat Problem 11 using metric units; that is,...Ch. 3 - If the sheet resistance of a tin oxide sample is...Ch. 3 - Determine the width of a carbon resistor having a...Ch. 3 - Derive the conversion factor between (CM-/ft) and...Ch. 3 - In your own words, review what you have learned...Ch. 3 - Visit your local library and find a table listing...Ch. 3 - Find at least one article on the application of...Ch. 3 - Using the required 1MA/cm2 density level for...Ch. 3 - Research the SQUID magnetic field detector and...Ch. 3 - Find the resistance of the thermistor having the...Ch. 3 - Using the characteristics of Fig. 3.38, determine...Ch. 3 - Referring to Fig. 3.40(a), find the terminal...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- The resistance of wire increases from 40 – ohm at 20 0C to 50 – ohm at 70 0C. Find the temperature coefficient of resistance at 0 0C.arrow_forwardA conductor with a will cause a smaller voltage drop, since its resistance is smaller. O a. large cross-sectional area O b. no cross-sectional area C. Small cross-sectional area O d. Same cross-sectional areaarrow_forwardDetermine the resistance of a busbar made of copper if the length is 16 meters long and the cross area is a 5x5 sq. cm. Use 1.7241 micro ohm-cm as the resistivity. (Provide drawing or FBD)arrow_forward
- What is the definition of electrical resistance? What is an “ohmic” resistance? Are all resistance ohmic in nature?arrow_forwardUsing the figure shown, what will be the amount of current i (short-circuit current) in the circuit if R2 is to be replaced with a short-circuit or a conducting wire.arrow_forwardAn copper wire has a total length of 2820 inches (in.) and a cross-sectional area of 4in. by6 in. Find the resistance of the wire.arrow_forward
- State the characteristics of voltage and current in a series circuit connection of resistors. State the characteristics of voltage and current in a parallel circuit connection of resistors. please explain it properly.arrow_forwardTwo wires A and B made from two different materials have temperaturecoefficient of resistance equal to 0.0019 and 0.0019 ohm per degreeCelsius, respectively. It is desired to make a coil of wire having a resistance of1219 ohms with a temperature coefficient of 0.001, using suitable lengths ofthe two given wires connected in series. Determine the required length ofwire A. Put an illustration figute with compelte solutions, step by step, kindly handwritten it. THank you!arrow_forwardI changed the wire material from copper to aluminum to string refer to the figures below. Can you explain the difference of the three materials?arrow_forward
- The resistance of a 2m length of cable is 2.5 . Determine (a) the resistance of a 7m length of the same cable and (b)the length of the same wire when the resistance is 6.250.arrow_forward3. The figure on the left below shows a schematic diagram of a battery. The voltage measured by U1 is called the terminal voltage given R1 = 1 ohm. In the figure on the right below, the terminal voltage of each of the battery-resistor combination is Vr = 1.5 volts. Find the following: a. The current passing through R5. b. The currents passing through R1 and R3 C. The voltage across R1. d. The voltage of the battery EMF. e. The percentage of voltage loss ot the battery due to the internal resistance R1. The power dissipated by the internal resistance R1. g. The power dissipated by R5 if R1 = R2 = R3 = R4 = 0. h. The percentage of power dissipation loss due to the four resistors R1, R2, R3, and R4 f. R1 R3 S10 R1 U1 1.500 EMF EMF R5 100 V1 R2 $10 EMF R4 EMF EMFarrow_forwardElectrical Engineering I need the answer as soon as possible 2y what is Cele and cladding ?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Introductory Circuit Analysis (13th Edition)Electrical EngineeringISBN:9780133923605Author:Robert L. BoylestadPublisher:PEARSONDelmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningProgrammable Logic ControllersElectrical EngineeringISBN:9780073373843Author:Frank D. PetruzellaPublisher:McGraw-Hill Education
- Fundamentals of Electric CircuitsElectrical EngineeringISBN:9780078028229Author:Charles K Alexander, Matthew SadikuPublisher:McGraw-Hill EducationElectric Circuits. (11th Edition)Electrical EngineeringISBN:9780134746968Author:James W. Nilsson, Susan RiedelPublisher:PEARSONEngineering ElectromagneticsElectrical EngineeringISBN:9780078028151Author:Hayt, William H. (william Hart), Jr, BUCK, John A.Publisher:Mcgraw-hill Education,
Introductory Circuit Analysis (13th Edition)
Electrical Engineering
ISBN:9780133923605
Author:Robert L. Boylestad
Publisher:PEARSON
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Programmable Logic Controllers
Electrical Engineering
ISBN:9780073373843
Author:Frank D. Petruzella
Publisher:McGraw-Hill Education
Fundamentals of Electric Circuits
Electrical Engineering
ISBN:9780078028229
Author:Charles K Alexander, Matthew Sadiku
Publisher:McGraw-Hill Education
Electric Circuits. (11th Edition)
Electrical Engineering
ISBN:9780134746968
Author:James W. Nilsson, Susan Riedel
Publisher:PEARSON
Engineering Electromagnetics
Electrical Engineering
ISBN:9780078028151
Author:Hayt, William H. (william Hart), Jr, BUCK, John A.
Publisher:Mcgraw-hill Education,
What is an electric furnace and how does it work?; Author: Fire & Ice Heating and Air Conditioning Inc;https://www.youtube.com/watch?v=wjAWecPGi0M;License: Standard Youtube License