Concept explainers
Resolution of the eye, I. Even if the lenses of our eyes functioned perfectly, our vision would still be limited due to diffraction of light at the pupil. Using Rayleigh’s criterion, what is the smallest separation between two pointlike objects that a person could clearly resolve at his near point of 25.0 cm with a pupil diameter of 2.00 mm? Assume that the light has a wavelength of 550 nm. (To get a reasonable estimate without having to go through complicated calculations, we'll ignore the effect of the fluid in the eye ) Based on your answer, does it seem that diffraction plays a significant role in limiting our visual acuity?
Want to see the full answer?
Check out a sample textbook solutionChapter 26 Solutions
College Physics (10th Edition)
Additional Science Textbook Solutions
The Cosmic Perspective
University Physics (14th Edition)
Essential University Physics (3rd Edition)
Conceptual Physics (12th Edition)
University Physics Volume 2
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
- A hydrogen gas discharge lamp emits visible light at four wavelengths, =410 , 434, 486, and 656 nm. (a) If light from this lamp falls on a N slits separated by 0.025 mm, how far from the central maximum are the third maxima when viewed on a screen 2.0 m from the slits? (b) By what distance are the second and third maxima separated for l=486 nm?arrow_forwardThe limit to the eye’s acuity is actually related to diffraction by the pupil. (a) What is the angle between two just-resolvable points of light for a 3.00-mm-diameter pupil, assuming an average wavelength of 550 nm? (b) Take your result to be the practical limit for the eye. What is the greatest possible distance a car can be from you if you can resolve its two headlights, given they are 1.30 m apart? (c) What is the distance between two just-resolvable points held at an arm’s length (0.800 m) from your eye? (d) How does your answer to (c) compare to details you normally observe in everyday circumstances?arrow_forwardTwo slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?arrow_forward
- A diffraction grating with 2000 lines per centimeter is used to measure the wavelengths emitted by a hydrogen gas discharge tube. (a) At what angles will you find the maxima of the two first-order blue lines of wavelengths 410 and 434 nm? (b) The maxima of two other first-order lines are found at 1=0.097 rad and 2=0.132 rad . What are the wavelengths of these lines?arrow_forward(a) Find the maximum number of lines per centimeter a diffraction grating can have and produce a maximum for the smallest wavelength of visible light. (b) Would such a grating be useful for ultraviolet spectra? (c) For infrared spectra?arrow_forward(a) Find the angle between the first minima for the two sodium vapor lines, which have wavelengths of 589.1 and 589.6 nm, when they fall upon a single slit of width 2.00 m. (b) What is the distance between these minima if the diffraction pattern falls on a screen 1.00 m from the slit? (c) Discuss the ease or difficulty of measuring such a distance.arrow_forward
- (a) If the first-order maximum for monochromatic light falling on a double slit is at an angle of 10.0° , at what angle is the second-order maximum? (b) What is the angle of the first minimum? (c) What is the highest-order maximum possible here?arrow_forwarda.) What is the wavelength of light in water? b.) Based on the data given, we can establish the angle for the third-order maximum for these two- slits if separated by a spacing of 0.0100 mm, to be _______ degrees? Basically, a factor of __________ % less than the angle found if the experiment was conducted in a vacuum.arrow_forward= Two light rays (1 and 2) travelling in air (na : 1) from source S (1 m above the surface of water) and meet at a point P on a screen (1 m above the surface of water), as shown below. Light ray 2 reflects from the surface of water (nw 1.33). Determine: = i. the phase difference of the light rays at point P, if wavelength of the light is 500 nm. ii. for what wavelengths we will have constructive interference at P? S Ray 1 Ray 2 Air 2 m Water 1 marrow_forward
- A telescope can be used to enlarge the diameter of a laser beam and limit diffraction spreading. The laser beam is sent through the eyepiece and out the objective, and can then be projected onto a satellite or the Moon. a. If this is done with the Mount Wilson telescope, producing a 2.1 m diameter beam of 690 nm light, what is the minimum angular spread, in radians, of the beam? b. Neglecting atmospheric effects, what is the diameter of the spot this beam would make on the Moon, assuming a lunar distance of 3.84×108 m?arrow_forwardA. An x-ray beam with wavelength 0.130 nm is directed at a crystal. As the angle of incidence increases, you observe the first strong interference maximum at an angle 62.0∘. What is the spacing d between the planes of the crystal? Express your answer in nanometers to three significant figures. B.Find the angle θ2 at which you will find a second maximum. Express your answer in degrees to three significant figures.arrow_forwardProblem A.2: Resolution of Telescopes Telescopes are an essential tool for astronomers to study the universe. You plan to build your own telescope that can resolve the Great Red Spot on the surface of Jupiter at a wavelength of 600 nm. The farthest distance between the Earth and Jupiter is 968 x 106 km and the Great Red Spot has currently a diameter of 16,500 km. (a) Use the Rayleigh criterion to determine the diameter of the lens' aperture of your telescope that is needed to resolve the Great Red Spot on Jupiter. Impacts have formed many craters on the Moon's surface. You would like to study some of the craters with your new telescope. The distance between Moon and Earth is 384,400 km. (b) What is the smallest possible size of the craters that your telescope can resolve?arrow_forward
- University Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStaxPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning