PID Control: The Proportional Integral Derivative (PID) control refers to a feedback control method. It performs the combined actions of proportional, integral, and derivative controls. It is one of the most widely used process controller. The PID control is used to maintain a process variable within the limits of a specified set point. These process variables can be temperature, flow, level, or speed. It also allows the control process operations to take place outside the Central Processing Unit (CPU), which in fact, greatly reduces the additional burden of CPU. Tuning: The appropriate values of gain, rate, and reset time parameters should be determined by tuning to achieve the required control of a PID controller. The controller’s output will be changed by tuning parameters due to the deviation in the process variable from the set point, and thus, the value of process variable is also changed. Generally, three methods are used in PID controller tuning as follows: Manual tuning Auto tune Intelligent tuning.

Question

Want to see the full answer?

Answer 1

Question

Chapter 14, Problem 15RQ

Program Plan Intro

PID Control:

The Proportional Integral Derivative (PID) control refers to a feedback control method.

It performs the combined actions of proportional, integral, and derivative controls.

It is one of the most widely used process controller.

The PID control is used to maintain a process variable within the limits of a specified set point. These process variables can be temperature, flow, level, or speed.

It also allows the control process operations to take place outside the Central Processing Unit (CPU), which in fact, greatly reduces the additional burden of CPU.

Tuning:

The appropriate values of gain, rate, and reset time parameters should be determined by tuning to achieve the required control of a PID controller.

The controller’s output will be changed by tuning parameters due to the deviation in the process variable from the set point, and thus, the value of process variable is also changed.

Generally, three methods are used in PID controller tuning as follows:

Manual tuning

Auto tune

Intelligent tuning.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Explain the significance of low-power modes in microcontroller design for battery-powered devices.

ROSPSPS One of the uses of a microcontroller is that it can control time for a digital output or process. This feature can be used to control traffic lights, garden sprinkler timers and fish feeders or other applications. Figure Q3a shows a circuit that can measure an analogue reading and display it on the LCD. LCD1 LMO16L 2l. 8E888888 U1 RV1 OSCIICLKIN RBOANT 34 35 36 RBYPGM 14 OSCZICLKOUT RB1 RB2 RADIANO RAIAN1 RAZIANZVREFCVREF RASIANGVREF+ 37 RB4 RB5 4 38 RB6PGC Tk 40 RAAITOCKVC10UT RASIANASSIC20UT R87/PGD 15 RCOTIOSOTICKI 16 REQIANSRD RE1IANSWR REZIANTICS RCVT1OSVCCP2 17 18 RC2/CCP1 10 RC3/SCK/SCL 23 RC4SDVSDA 24 MCLRIVpp/THV RCS/SDO RCG/TX/CK 25 26 RCTIRXDT 19 RDOPSPO 20 RDUPSP1 RD2/PSP2 21 22 RD3PSP3 27 RDAPSP4 28 RDSPSPS RD6PSP6 ROTIPSP7 PIC16F877A Figure Q3(a) c) UART is a microcontroler module that enables it to send and receive data from outside. i) Design a programme that can write thet word 'START’ on the UART terminal, enter a new line below and write the character that…

CMOS operates more reliably than TTL in a high-noise environment because of its(a) lower noise margin (b) input capacitance(c) higher noise margin (d) smaller power dissipation