Why do I study spatial design and what are the theories of failure in the state of stillness and in the state of motion

Define the term Worth in value engineering?

The rapid progress of engineering design and information technology has caused difficulties in analyzing system reliability. Because of the increased complexity in system reliability structure (component/subsystem interfaces), many unexpected failure modes could occur, and their behaviors are interdependent. At a system’s design and development stage, the main challenge in analyzing a complex system is the failure uncertainty introduced by the incomplete knowledge of the system. This makes it hard to decompose system reliability into subsystem/component reliability in a deterministic manner, such as series or parallel systems. As a result, some common reliability analysis tools such as fault tree (FT) and reliability block diagram (RBD) become inadequate. Do you agree, why or why not? Are there any other approaches to system reliability assessment beside these tools at the early system’s design and development stage (what are these approaches)?

Sensor systems for obstacle detection and avoidance in mobile robots. • Produce a written report documenting: the choice of sensors, sensor evaluation, the developed processor/measurement system, and overall system performance.

A group of engineers is tasked with designing a new windshield wiper that is easily replaceable and cheaper than previous models. Identify at least one criterion and one constraint for the new windshield wiper design.

Please don't use AI since it is wrong.

Analyze the principles of operation and potential applications of gyroscopic and accelerometer-based input devices, such as those used in gaming controllers and smartphones.

(a) A very important component of a system has a mean time between failures of 100 hr and a mean time to repair of 10 hr. Determine the inherent availability of the system.           (b) If the equipment in Q7 (c i) above is required to meet an inherent availability requirement of 0.985 and a mean time between failures of 100 hr. Calculate the permissible mean time to repair and if the system as a mean of the time intervals between corrective maintenance actions of 900 hrs and the sum of the mean corrective maintenance time intervals including supply downtime and administrative down time of 10 hrs Determine the operational availability of the system

manufacturing benefits from geometric tolerancing in many ways. which of the following is not one such benefit? A. Lowered manufacturing cost B Decreased tolerance for mating parts C. Clear design intent aids the inspection process D. reduces waste.

First read Section 2.14 of the Kaminski & Jensen text entitled, The “Pizza” Procedure for Problem Solving (silly name maybe, but it underscores the need to break large problems intomanageable parts). In describing the major parts of the procedure for solving engineeringproblems, an analogy is made to a stool with three legs. Name and describe in a few words the3 “legs” of the procedure for solving engineering problems: