Which of the following is correct when we increase the volume fraction porosity of a ceramic material? both the flexural strength and modulus of elasticity decreases flexural strength decreases, while modulus of elasticity increases O flexural strength increases, while modulus of elasticity decreases both the flexural strength and modulus of elasticity increases

Which of the following is correct when we increase the volume fraction porosity of a ceramic material? both the flexural strength and modulus of elasticity decreases flexural strength decreases, while modulus of elasticity increases O flexural strength increases, while modulus of elasticity decreases both the flexural strength and modulus of elasticity increases

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Which of these elastic moduli describes the ratio between volumetric stress and volumetric strain?a. Young’s Modulusb. Shear Modulusc. Bulk Modulusd. Poisson’s Ratio
12)
25 - Which of the following information cannot be determined from the Stress - Elongation Graph of a material?A) Modulus of elasticityB) Safe stretchingC) Yield StressD) Maximum stressE) tensile stress
An aluminum alloy cylindrical bar of 10 mm diameter is subjected to 5 kN tensile load which reduces the diameter of bar to 9.997 mm. If the Young's modulus of the bar is 6.95 x 104 MPa, calculate the Poisson's ratio of the alloy.
Please answer both
1. The tensile strength vs. temperature curves of aluminum are plotted below. Explain the meaning of these two curves. 400 Ultimate strength 300 Yield strength 200 100 -200 -150 -100 -50 50 100 150 200 250 Temperature, °C Strength, kPa
What is the effect of crosslinks on an elastomer and what is the structural explanation for their effect? What would happen to the amount of stretch, hardness, strength, and creep in an elastomer if the crosslink density were increased?
For material, the modulus of rigidity is 100 GPa and the modulus of elasticity is 250 GPa. The value of the Poisson's ratio is
I need the answer to the question in engineering resistance
Materials, properties and testing Describe the effect bend testing have on the thermal properties of steel.
Urgent
Please annotate the attached image to highlight the different phases of a polymer stress/strain graph. From the attached graph, calculate the following: 1-modulus of elasticity 2-tensile strength 3-the ductility in % of elongation 4- yield strength at a strain offset of 0.002