Which of the following combinations comprise the Transmission Line Impedance? O A. Conductance and Capacitive Reactance in Parallel O B. Conductance and Inductive Reactance in Parallel O C. Resistance and Inductive Reactance in Series O D. Resistance and Capacitive Reactance in Series

Which of the following combinations comprise the Transmission Line Impedance? O A. Conductance and Capacitive Reactance in Parallel O B. Conductance and Inductive Reactance in Parallel O C. Resistance and Inductive Reactance in Series O D. Resistance and Capacitive Reactance in Series

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.8MCQ

See similar textbooks

Related questions

Q: Question 3) A 200 km Three-Phase 50 Hz transposed transmission line is composed of one ACSR,…

A: Given:

Q: Calculate at 6 MHz the position and length of a shorted shunt stub that will match the load…

Q: magnitude of the line current,

Q: The three conductors of a three-phase line are arranged at the corners of a triangle of sides 7 m,…

Q: Calculate the inductance per phase per meter for a three- phase double-circuit line whose phase…

Q: EXAMPLE FIVE: A surge arrester installed at the end of a line has the following characteristics :…

A: A surge arrestor is installed for the protection of the electrical power system from the surges that…

Q: Question 3) A 200 km Three-Phase 50 Hz transposed transmission line is composed of one ACSR,…

Q: A transmission line of 550 Ω surge impedance is connected to a cable of 100 Ω surge impedance at the…

Q: In the analysis of Short Transmission Lines, the Lines should be in which type of Three-Phase…

A: SOLUTION- for short transmission lines show three phase connection used constellation diagram

Q: • Calculate the per phase inductance and reactance of a balanced 30, 60 Hz, line with horizontal…

A: Given 3 phase 60 Hz, r=1 cm=10-2 m

Q: 10. A single phase double circuit transmission line is shown in figure. Conductor 1 and 2 in…

Q: TUTORIAL PROBLEMS 1. A 3-phase overhead transmission line has a total series impedance per phase of…

Q: I. A twin-conductor circuit of three-phase 50 Hz line with horizontal spacing of 6 m. Each…

Q: A short 3-0 transmission line with an impedance of (5 +j 20) º per phase has sending end and…

A: I HAVE EXPLAINED IN DETAIL

Q: Question 3) A 200 km Three-Phase 50 Hz transposed transmission line is composed of one ACSR,…

Q: Shunt conductance of transmission line accounts for. losses. Ohmic O Windage O Series voltage drop…

A: Two conductors or transmission lines separated by very small distance ,a shunt conductance is formed…

Q: Problem statement: A three phase 60- Hz, 550- kV transmission line is 300 km long. The line…

A: we have given ;A three phase system frequency f=60Hzsource voltage =550kVlength of transmission line…

Q: 12500kva load is supplied at a power facter of 0.8 lagging by a 3 phase transmissiom line whose…

A: We can draw the power system as here load is PR+jQR=12500×0.8 kW+j12500×0.6kVAR=10000kW +j 7500kVAR…

Q: A. 0.5m Sm 0.Sm 0.5m Conductor x Conductor Y

Q: A 100 km Three-Phase 50 Hz transposed transmission line is çomposed of bundle of three ACSR,…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Consider the following statements: Surge impedance loading of a transmission line can be increased…

A: we need to explain how SIL can be increased.

Q: Impedance matching is provided at D = 0.074? and L = 0.094? values for an unknown load using the end…

Q: Question 2) A 100 km Three-Phase 50 Hz transposed transmission line is composed of bundle of three…

A: As per our policy we can provide solution for first question only. As we have given : GMR1=1.5…

Q: 3 Phase Losses in the transmission line Per phase resistance of the transmission line

Q: Determine the per unit impedance of a transmission line having an impedance of 30 + j110 Ω on 100…

Q: 4/ Which parameter is neglected or ignored in Short Transmission Lines? A. SHUNT CAPACITANCE ONLY…

Q: A three-phase transposed line is composed of one ACSR 159,000 cmil, 54/19 Lapwing conductor per…

Q: The voltage regulation of a shunt transmission line will be maximum when the value of tan ÖR, for…

A: The voltage regulation formula is, V.R.=IRcosϕR±IXsinϕRV2×100 (+) for lagging (-) for leading

Q: The line-to-line voltages in an unbalanced three-phase

Q: Transmission line conductance is usually neglected in power system studies.

A: There are four parameters present in the transmission line: Inductance, capacitance, resistance and…

Q: Question 3: A three-phase, 60-Hz transposed transmission line has a flat horizontal configuration as…

A: Given XL=0.486 Ω/KmXL=2πfLL=XL2πfL=0.4862×3.14×60L=1.289 mH/Km Expression of L…

Q: What is the primary reason for adopting transposition of conductors in a three phase distribution…

A: In this question we will write about transposition of conductors in 3 phase distribution system....

Q: Calculate a. The synchronous impedance Z, per phase b. The total resistance of the circuit, per…

A: In this question, We need to determine the synchronous impedance Zs and total resistance of the…

Q: which end Power factor correction sub-stations are located. a. Sending end of transmission line b.…

A: Power factor correction is very crucial part of the power system. If power factor is low, efficency…

Q: A rectangular surge of 500 kV 3µs travels along the terminated line by an inductance of 2mH. If the…

A: Given Rectangular voltage magnitude vm=500 kvTime duration t=3 μsSurge impedance Z0=600…

Q: A 132 Kv, 50 Hz, 3-phase tensmission line delivers loaed of 5omw at 08 lagging Pf. 9, the…

A: For a 3-phase transmission line,Voltage, V=132kVFrequency, f=50HzPower, P=50MWPower factor,…

Q: A single-phase transmission line 30 kV, 60 Hz, 100 kVA, consists of two hard-drawn aluminium…

Q: A Three-phase transposed line is composed of one conductor per phase with flat horizontal spacing of…

A: In this question we will find distance between conductors D with given GMD....

Q: b. Determine the inductance per km per phase of a single circuit 460 KV line using two bundle…

A: Given:- r=2.5 cm

Q: A short 3-φ transmission line with an impedance of (5 + j 20) Ω per phase has sending end and…

A: Resistance of each conductor R=5 ohm Reactance of each conductor XL=20ohm Load power factor is 0.8…

Q: 1. A single phase overhead transmission line deliw and reactance per conductor are 0-15 Q and 0-0

A: According to question:

Q: A 3 phase transmission line is supplying 8 kV to an 800 kVA, 0.85 pf lagging load. The resistance…

A: For a 3-ϕ transmission line - PL=800kVAVS=8kVPF=0.85 (lagging)The resistance and reactancec per…

Q: A short single phase transmission line has a loop impedance of (0.2+j1.2) ohm. At what leading power…

A: Given: A short single phase transmission line has, Loop impedance, Z=0.2+j1.2 Ω so Resistance, R =…

Q: iv. For a long high voltage transmission line with light loading: (a) The voltage is generally high…

Q: A transmission line is composed of ACSR conductors consiting of eight aluminum strands and two steel…

A: The given ACSR 8 stranded conductor is, Diameter=2 cm ; radius, r=1 cm

Q: 9. Determine the transformer tap ratios when the receiving end voltage is equal to the sending end…

A: Given data: VR=VSVs=230 kVPo=80 MWpf=0.8ZL=40+j150 Ω

Q: lease help solve this question A 100 km Three-Phase 50 Hz transposed transmission line is composed…

Question

Which of the following combinations comprise the
Transmission Line Impedance?
O A. Conductance and Capacitive Reactance in
Parallel
O B. Conductance and Inductive Reactance in
Parallel
O C. Resistance and Inductive Reactance in
Series
O D. Resistance and Capacitive Reactance in
Series

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
in phase margin why the phase go down for first time then go up?
128, An equipment has an impedance 0.9 p.u. to a base of 20 MVA, 33 kV. To the base of 50 MVA, 11 kV, the p.u. impedance will be (a) 4.7 (c) 0.9 (b) 20.25 (d) 6.75
estimate the value of equivalent impedance
The total reactive power consumed by the three-phase load(in VAr) is??
Please help with this balanced three-phase circuit problem.
What is total admittance and impedance from source side.
about Three-phase Circuits
4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive circuit c. RC circuit d. RL circuit
According to the Reactive Power Compensation Regulation, capacitive reactive power should not exceed what percent of active power in the power plants whose power is greater than 50 KVA?
2. The pu impedance of a circuit element is 0.15. If the base kV and base MVA are halved. Then the new value of pu impedance of the circuit element is A. 1.2 C. 1.1 3. The pu impedan B. 1.0 B. ambient tempera- ture D. 0.8 E. none
a) Determine the voltage across XC (with VDR). b) Determine total current. c) Determine the voltages across R and XL. d) Sketch the phasor diagram with all the voltages and current.