4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive circuit c. RC circuit d. RL circuit
Q: 1. Explain about implementation of iterative methods in power flow studies 2. Inference on a…
A: Implementation of Iterative methods.The network equations for the unknown electrical quantitycan be…
Q: Calculate/ find the following: (i) Inductive reactance (ii) Impedance (iii) Phase angle…
A:
Q: resistor of 20Ω, an inductor of 0.012H, and a capacitor of 90 μF are connected in series with a…
A: In this question we will find phase between v and I in series RLC circuit..
Q: A Thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small surge…
A: According to the question we have to discuss about the construction of Thyristor.
Q: d, what would be the new impedance?
A:
Q: What is the impedance
A:
Q: The three loads in the circuit can be described as follows: Load 1 is a 2400 resistor in series with…
A:
Q: Star circuit to three-phase variable power supply. Set the resistors to a value of 300 Ω and the…
A:
Q: CALCULATE THE THREE-LINE VOLTAGES AND THE PHASE VOLTAGES (with a degrees), THE LINE CURRENT, THE…
A: Note: In last three rows both line and phase current are mentioned (e.g Ian/Iab). so we assume it is…
Q: In class A chopper with R-L load, the continuity of current increases as duty cycle decreases…
A: Inductance has to be increased To increase the continuity of current the period of time should be…
Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source.…
A:
Q: Electric Powers System for Nonelectrical Professional can you explain the purpose of capactictors,…
A:
Q: 5) The method (s) to improve the Power Factor: a. Use of synchronous motors. b. Use of synchronous…
A: The explanation is as follows.
Q: Calculate the required DC supply voltage VCC when RC=1965 ohms, IB=35 uA, VC=8V, R2=4746 ohms,…
A:
Q: hy is the maximum firing angle of the AC resistance trigger circuit limited to 90 degrees?
A: Given We need to enumerate the reason why is the maximum firing angle is 90 degrees ina resistance…
Q: Which methods can be used to estimate or calculate the maximum power point on an I-V curve?
A: The maximum power point is the point at which the product of voltage and current is maximum on an…
Q: 2.)What is the difference between Ampere's law and Biot-Savart's law?
A: A current carrying wire produce magnetic field. The direction is obtained by right hand rule.…
Q: 17 By laminating the core, the Hysteresis losses can be reduced. Select one: True False
A: Given that By laminating the core, the Hysteresis losses can be reduced
Q: Q2. The single-line diagram of a simple three-bi is shown in Figure-2. Each generator is repres-…
A: the single line diagram of a simple three bus power system is shown. Each generator represent by an…
Q: Figure 1 shows the block diagram of the UPFC. With the use of the phasor diagrams, explain how the…
A: Figure 1 shows the block diagram of the UPFC. With the use of the phasor diagrams, explain how the…
Q: Two impedances are connected in parallel to the supply, the first takes a current of 40 A at a…
A:
Q: Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of…
A: The three cases on which real and reactive power flow gets affected are as following, CASE-1 When…
Q: Derive the equation for impedance and phase shift for series RLC circuit connected to the AC…
A: A series RLC circuit is formed by connecting a resistor, inductor, and capacitor in series across a…
Q: What is the magnitude of the impedance of this circuit element?
A:
Q: Suppose I have two peak phasor voltages, V, = 100245° and V, = 75Z-60°. Circle Your Choices: The…
A: In this question we will find RMS value , frequencies etc of given phasor...
Q: 8. Junction 9. Loop 10. Circuit
A: 8. Junction : Junction in an electrical circuit is the point where a number of conductors or may be…
Q: . For a series ac R-L-C circuit, (a) why do the voltage ampltudes not obey the equation V VR+ V +…
A:
Q: A 25-ohm resistor connected in series with a coil of 50-ohm resistance and 150-mH inductance. What…
A:
Q: Assumption used while creating a Load duration curve is O a. Peak loads should be minimum O b. Peak…
A: In this question , we will write condition about load duration curve . Note:- due to bartleby…
Q: What's the settling time (5% Criterion) for this system with its closed- loop poles as shown? jo j8…
A: Solution ; In order to find the setling time we have to find charaterstics equation first so , In…
Q: A 10A current is lagging the voltage by 47° and a 12A current is lagging the voltage by 58°. What is…
A: Given: 10 A current lagging the voltage by 470 and 12 A current lagging the voltage by 580. We have…
Q: es and efficiency at half load
A:
Q: For an RC circuit with reactance of 820 ohm and resistance of 572 ohms, phase angle of the circuit…
A:
Q: What is the real power, reactive power and complex power delivered by the source in the given…
A: The solution can be achieved as follows.
Q: If 3-phase transfomer configuration in figure in has the givens as listed below: E-line on high…
A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: system will not have comparison element . a. Open loop b. Dynamic С. Closed loop d. Static
A: Given .................system will not have comparison element.
Q: circuit in the figure: A) the impedance seen when viewed from the source B) Flow C) Phase angle…
A:
Q: Which of the following statements is/are true? A In purely inductive circuit, the current leads…
A: Given: Brief description: In the above question they have mentioned multiple choice question…
Q: Problem 2-9 Balanced Capacitor Circuits in Expressed in a Rotating Ref- erence Frame Three balanced…
A: The wye equivalent diagram is
Q: The type of the load whose current and voltage phasors are as shown in the phaser diagram is Im 90°…
A: -Consider the phasor diagram given:
Q: By laminating the core, the Hysteresis losses can be reduced. Select one: True False
A: It is FALSE
Q: Series capacitor compensation is used to reduce fault current levels Compensation of reactive…
A: In this question we will write about series capacitor compensation....
Q: 3. An inductor having a 50 ohms resistance and 100 ohm inductive reactance is connected to a 100…
A:
Q: With the help of mathematical expression and wave forms prove the following. a. V and I are in the…
A:
Q: An impedance coil, in series with a resistor takes a current of 3A when connected to a 120V AC…
A:
Q: When connecting the circuit in the figure to an AC voltage generator, it is possible to say that L O…
A: Note: We are authorized to answer one question at a time, since you have not mentioned which…
Q: ]What happens when we encounter a circuit that has all 3 components in series? Parallel? How do we…
A: To answer above question, one should know basic circuit theory rules: Ohm's law: Ohm's law state…
Q: Develop the mathematical relationships for the design of the inductance and capacitance of a…
A: Distances of conductors are written as: Da1b2=distance between a1 and b2.like…
Q: Question: In load commutation when the load current is kept constant, capacitor voltage gets charged…
A:
Q: Relation between power and power factor in ac circuits . Discuss the power triangle for a load an ac…
A:
4-
Trending now
This is a popular solution!
Step by step
Solved in 3 steps
- Figure 2 shows three "LC" circuits, two of them with capacitance capacitors "C" and the three with inductance coils "L", the three circuits are coupled by means of two capacitance capacitors "Cc". The currents that circulate through each mesh are those indicated in the figure: "I1", "I2" and "I3". Using Kirchhoff's law for voltages and taking into account the definition of current I = −dQ / dt, find the system of coupled equations of the system and then find the normal angular frequencies of the system.Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?A utility company plans to connect a total of 20uF of capacitance to a 7200 volt line. To make this connection four capacitors will be connected in series. What is the capacitance of each capacitor? Answer is 80uF. Now what is the minimum AC voltage rating of each capacitor?
- 1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.Draw an RLC parallel circuit and draw current triangle (using phasor representations) if source phaseis 0 degree and the source current is leading source voltage 30 degrees. Draw voltage and currentphasor diagram for circuit.9. A noninductive load with a resistance of 30 Q2 is connected in series with a capacitor. The capacitor has a capacitive reactance of 25 Q and negligible resistance. The series circuit is energized from a 210 V, 60 Hz source. Determine: a. the impedance of the series circuit. b. the current, in amperes. c. the loss in volts across the noninductive resistance load. d. the loss in volts across the capacitor.
- Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…A 230 V, 50 Hz a.c. supply is applied to a coil of 0.06 H inductance and 2.5 resistance connected in series with a 6.8 F capacitor. Calculate impedance and power consumption and power factor. Now ,In above a.c. circuit, A inductor of 0.2H is connected in parallel with the power supply, find new power factor and power consumption.A resistance RC and a 4 ohms capacitive reactance are in series and the combination isparallel to a 10 ohms resistance. What value of RC will yield a circuit phase angle of 450 ?.
- Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degreesDetermine the capacitance and voltages (Vrms) across the resistor and capacitor and prove that the phasor sum of the series components is equal to the source voltage. Also, solve for its total circuit impedance and total circuit current.Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor