i = 3 sin(377t + 60°) R. 1.20 X, 212 X 5 0 %3D

Q: Redo it again with full details..

A: Given: 3:8 Decoder To find: we have to form the truth table for 3:8 decoder.

Q: Determine the value of the capacitor to be connected in parallel with ZL (load) in order to correct…

A: In this question,  We need to determine the value of the capacitor to be connected in parallel with…

Q: Derive the expression for total inductance of a transmission line.

A: According to the question we have to drive the expression for total inductance of a transmission.

Q: Explain why Phasor and impedance diagrams have the same angles.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

A:

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

A:

Q: Q6/B: A three-phase double circuit line is shown below, the diameter of each conductor is 2 cm. F…

A:

Q: what would happen to the angular delay of Leading Power Factor if we change the capacitor to…

A: The solution is given below

Q: /hat does it mean when the power factor is leading? rue or false: 1) A load with a leading power…

A:

Q: A non magnetic medium has an intrinsic impedance 360Z30° Q. The loss tangent is

A: Wave is function of space and time. Frequency below which attenuation occur and above which…

Q: n phase margin why the phase go down for first time then go up?

A: As electronic amplifiers the phase margin (PM) that is the difference between the phase lag φ (&lt;…

Q: the cross over frequency of the system with transformer function k[s+1]/s2 and phase margin equal to…

A: In this question,  We need to calculate the the cross over frequency of the system with transformer…

Q: The total impedance of an induction machine is given by 8.5+5.5i 0. If the phase voltage supplied is…

A: Input power factor given by pf = cos (phai) Where phai is = tan-1( imaginary part of impedance/ real…

Q: 12.14: the currenit waveforms of a capacitov are shown in Figuse o Determine root The avesage peak…

A: Given Ip=500 At1=100 μst2=300 μst3=500 μsfs=250 Hz

Q: What's RMS and it's average value in AC circuit? Usually which value we measure in AC circuit?

A: RMS: It stands for Root Mean Square. It is a way of expressing an AC quantity of voltage or current…

Q: Noise due to inductive coupling can be reduced by twisting the wires carrying a signal. True False

A: In radio frequency when disturbance in external source affects the electrical circuit by…

Q: Define the Standing wave and characteristics impedance

A: The definitions are as follows.

Q: Use tle Routh- Hur witz criterion

A:

Q: A load is said to have a leading power factor. Is it capacitive or inductive? Is the reactive power…

A: Since power factor is leading that means current leads the voltage and we have the capcitive load…

Q: What is the relation between the voltage drop and the distance in radial and ring circuit?

A: Concept: Using a constant voltage system, electrical power distribution is performed. Radial…

Q: the 1 Cire at stert) rotor cirouit has much lower impedance than magnetising eircuit. At start…

A: Given data: Iph=4.94 AP3ϕ=214.7 WR1=1.9 ΩVRY=29.8 V

Q: Explain why the phasor and the impedance have the same angle

A:

Q: What are two transform boundaries?

A: The transform boundary refers to a type of boundary where a specific type of transformation or…

Q: Eddy current losses can be reduced by making the core of a stack of plates electrically insulated…

A:

Q: one (360 degrees), all of the instantaneous power falls under positive loops (no negative loops),…

A: Option A  Resistor is the correct answer.

Q: what will be the total and unit for impedance if the given is 8mA and 9mV?

A: Electrical impedance is the amount of opposition that a circuit presents to current or voltage…

Q: winding direction of the secondary winding of the transformers is the same or opposite to the…

A: In this question we will write about voltage induced in secondary of transformer..

Q: 210⁰ and Ic=980 cis - 60°. Find the negative sequence of phase B current. 11. The phase B current of…

A: In this question we need to find a current in line B

Q: The phase angle between magnetizing component current and core loss component current is 90° Select…

A:

Q: The inductance effect is predominant in underground cables than overhead lines. Select one: True…

A: In this question we have to define inductance effect in cable...

Q: Our basis for the construction of line phasors is the COSINE function. True B False

A: In this question we need to verify the given statement is true or false.

Q: From the circuit below, determine secondary winding voltage Vsec if the primary winding voltage Vpri…

A:

Q: i need the answer quickly

A:

Q: Two identical 460/230-V transformers are connected in parallel to a common load with impedance 10 +…

A:

Q: Using the mesh analysis equation for loop 2 what are the steps for conversion for the division of…

A:

Q: Using finite difference method, determine potential and magnitude of electric field at free nodes in…

A: Given data for the question in following way Sides of triangle 16 cm Third side of triangle 18.38 cm…

Q: SUNB Desian aproblem for wge delta transformations Dterminc the eauivalend resistance betreen the…

A: In this question , we have to find out equivalent resistance across A and B..

Q: Leee GH Ia

A:

Q: 0. 2. 6. 7 6. 10 00 -1

A: MATLAB code to generate below shape using matrix method:

Q: How to solve for a (+) Phase Sequence and (-) Phase Sequence? Give an example and explain the steps.

A: When a unsymmetrical fault occurs in the system then system becomes unbalanced. To understand the…

Q: What are the applications of IMPEDANCE and ADMITTANCE OF AN AC CIRCUIT

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.