The feed to the batch process consists of a solution of 500 L of ethanol with 120 mole of A and 120 mole of B.  If the temperature of the solution is sufficient, A and B will react to form P (the desired product): A (eth) + B (eth) → P (s)             DHreact = − 250 kJ/mol   what is the ampunt of product per batch?

Q: Consider the following chemical reaction: N2 + O2 → 2 NO If 10.0 g of N2 reacts with excess oxygen…

A: The reaction given is: N2 + O2 → 2 NO Mass of N2 reacted with excess O2, mN2 = 10.0 g The molar mass…

Q: Iron oxide, FeO(s) (mol mass 71.85 g/mol and specific mass 2.5g/cm3) is reduced to metallic iron,…

A: The question asks us to think of a chemical process that uses hydrogen gas to convert iron oxide to…

Q: Calculate AHrxn for the process

A:

Q: A chemical engineer is studying the following reaction: H,(9)+Cl,(9) - 2 HCI(9) At the temperature…

A:

Q: In a reaction, 0.77 kg of V₂05 are reacted with 0.88 kg of Ca as the following chemical. Equation :…

A:

Q: Calculate Kp for the reaction S(s) + 2 CO(g) SO2(g) + 2 C(s) At the temperature in question, 2 bar…

A: In thermodynamics, equilibrium constant Kp, the equilibrium constant is calculated from the partial…

Q: Exereuse 1. 69 The total combustions of mole of Liquid methanol under Standard pressure and…

A: Moles of methanol = 1 molAmount of heat released during combustion at STP = 725.2 kJ/mol

Q: Given the following reaction with a feed rate of 10.0 kg/s each of H₂ and O₂: 2H2(g) + O2(g) → 2H₂0…

A: Given reaction of H2 and O2 is  2H2+O2→2H2O Feed rate=10kg/s conversion(XA) =0.67 Water enters at…

Q: Methanol (CH3OH) and acetic acid (CH3COOH) react in the gas phase at a temperature of 170°C to form…

A: Given data: Equilibrium constant = 3.87 Initial number of moles of methanol = 92 mol Moles of…

Q: 2. Ethanol is produced by the hydration of ethylene according to the first reaction below. However,…

A: Ethanol is produced by the hydration of ethylene and and side reaction produces the diethyl ether as…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A second-order reaction is a type of chemical reaction where the rate of reaction is proportional to…

Q: added

A: V = 36.9 + 1 ml = 37.9 ml Patm = 760 torr T = 18.8 deg C Use PV = nRT to find n = ?

Q: 1 mole of nitrogen tetraoxide was placed in a container and allowed to dissociate according to the…

A: Write the reaction as follows: N2O4g  → 2NO2g   The volume of the mixture, V = 36 L The pressure of…

Q: A liquid is fed to a distillation column at 4 atm absolute pressure. Its composition as a mole…

A: Given:P=4 atmxB=0.4 ; xP=0.25 ; xHx=0.2 ; xHp=0.15

Q: Molar mass of elements (g/mol) C H 0 S N 12.01 1.01 16.0 32.0 14.01 Cl F 35.45 19 Consider the…

A:

Q: A gas mixture containing 30% C2H4 and 70% H₂O reacts to obtain ethanol according to the following…

A: The objective of the question is to determine whether the reaction can produce the target amount of…

Q: A solution of methylene chloride (CH,CI,) and ethanol (CH,CH,OH) is boiling at 62.7 °C. A sample of…

A: A mixture of methylene chloride (M) and ethanol (E) is boiled. The temperature of the boiling…

Q: A distillation column with a partial reboiler and a total condenser is being used to separate a…

A: In distillation, separation is possible only above the minimum reflux ratio, which is the lowest…

Q: Baker's yeast (S. Cerevisiae) is grown in a large 800 L batch reactor according to the following…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: ) Propane (CnH2n+2) is burned with atmospheric air. The analysis of the products on a dry basis is…

A: Given that: Basis product feed= 100 mol (supposed)  Molar mass of propane= 44 g/mol Molar mass of…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A:

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass…

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O…

Q: A distillation column is being used to separate a mixture of benzene, toluene, and cumene. The feed…

A: The composition of feed is The mole fraction of benzene, z1 = 0.4 The mole fraction of toluene, z2 =…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A (eth) + B (eth) → P (s)             DHreact = − 250 kJ/mol For ethanol, the maximum solubility…

Q: The combustion of ethane (C₂H6) in air gave the following balanced actual combustion reaction:…

A: Write the reaction as follows: C2H6 + aO2+3.763N2 → 1.8CO2 +0.2CO + 3H2O + a-3.4O2 +3.76aN2   C2H6 +…

Q: A partial oxidation is carried out by passing air with 1.2 mole percent (mol %) hydrocarbon through…

A: Given: 12% hydrocarbons through 40mm tubes packed with 2m of 3mm by 3 mm cylindrical catalyst…

Q: PROBLEM 2 To prepare a delicious banana milk on an industrial scale, there is an experimental…

A: Given data: Stream of banana fed to peeler, 99.9% of the peel is removed. In extruder press 50:50…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A (eth) + B (eth) → P (s)DHreact =−250 kJ/mol

Q: A mixture containing 40 kg A and 60 kg B is contacted with are solvent in a single-stage process.…

A: This is problem of extraction. We are given relative abundance in raffinate and selectivity from…

Q: Iron oxide, FeO(s) (mol mass 71.85 g/mol and specific mass 2.5g/cm3) is reduced to metallic iron,…

A: The question asks us to think of a chemical process that uses hydrogen gas to convert iron oxide to…

Q: A chemist attempts to prepare some very pure crystals of borax by dissolving 100g of Na2B407 in 200…

A: Borax is a common naturally available mineral that has various medicinal properties such as…

Q: One half-cell in a voltaic cell is constructed from a copper wire electrode in a 3.0 x 10° M…

A:

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A (eth) + B (eth) → P (s)DHreact =−250 kJ/mol

Q: Suppose 2.00 L of H2(g) at 620 torr is mixed with 1.00 L of N2(g) at 340 torr.  3H2(g) + N2(g)…

A:

Q: When 138 g of KOH is added to a 4.9 L container of O3 at 25°C and a pressure of 84 atm, the…

A:

Q: Serpentinization is the change in mineralogy, usually of mafic and ultramafic rocks such as…

A:

Q: NAAIO2 is recovered in the decanted solution

A: To separate two different density fluids which are immiscible to each other decantation is only…

Q: A gas mixture is at 20 °C and 1.4 atm, occupying a volume of 150 m^3 and is composed as follows;…

A: To solve this, let's first find the initial number of moles of each component in the gas mixture.…

Q: #3 acid via the oxidation of ammonia is: The first step in the reaction sequence for the production…

A: A limiting reagent is a reactant that gets used up completely when the reaction is completed. The…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A: A (eth) + B (eth) → P (s)DHreact =−250kJ/mol-rA = k cA cB

Q: A liquid is fed to a distillation column at 4 atm absolute pressure. Its composition as a mole…

A: In the above problem, the K values vs temp for a multicomponent distillation system is given.  The…