The cannon fires a 16-lb cannonball with an absolute velocity of 900 ft/sec at 22° to the horizontal. The combined weight of the cannon and its cart is 1932 lb. If the recoil mechanism consists of the spring of constant k = 2160 lb/ft and the damper with viscous coefficient c = 720 lb-sec/ft, determine the maximum recoil deflection Xmax (a positive number) of the cannon unit. جاد Answer: Xmax= i 900 ft/sec 22° ft

The cannon fires a 16-lb cannonball with an absolute velocity of 900 ft/sec at 22° to the horizontal. The combined weight of the cannon and its cart is 1932 lb. If the recoil mechanism consists of the spring of constant k = 2160 lb/ft and the damper with viscous coefficient c = 720 lb-sec/ft, determine the maximum recoil deflection Xmax (a positive number) of the cannon unit. جاد Answer: Xmax= i 900 ft/sec 22° ft

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

H.W-2 A projectile is fired with an initial velocity of "A-150 m/s off the roof of the building. Determine the range R where it strikes the ground at B. VA = 150 m/s R 150 m
A drum with a 500-mm radius is attached to a disk with a radius of 250 mm. The disk and drum have a combined mass of 15 kg and a combined radius of gyration of 400 mm. A 12 kg block D is suspended by a wire that is warped around the drum. Another force P- 100 Nis applied to the wire that is warped around the disk. If the system is released from rest, neglecting the effect of axle friction determine: (a) the acceleration of the block. (b) the velocity of the block after 10 second. (c) the distance travelled by the block after 10 second. (d) the revolution by the drum just after 10 second. 500 mm P+ 250 mm
A tank and a deflector are placed on a frictionless trolley. The tank issues water jet (mass density of water = 1000 kg/m³) which strikes the deflector and turns by 45°. If the velocity of jet leaving the deflector is 4m/s and discharge is 0.1 m³/s, the force recorded by the spring will be Spring m²t Tank 45° Jet of water Deflector Tim Trolley
A bullet of mass m=0.1 kg is fired with a velocity v0=500 m/s forming an angle θ=30° with the horizontal and gets lodged in a wooden block of mass M=10 kg. The block can roll without friction on a hard floor and is prevented by springs from hitting the wall. Calculate theamplitude and period of vibration of the block and embedded projectile. Each one of the three springs has a stiffness k=3 kN∕m.
A tank and a deflector are placed on a frictionless trolley. The tank issues water jet (mass density of water = 1000 kg/m³), which strikes the deflector and turns by 45°. If the velocity of jet leaving the deflector is 4 m/s and discharge is 0.1 m³/s, the force recorded by the spring will be Spring 0000000 Tank O O Jet of water 45° Deflector TTTTT Trolley
A simple beam AB supports two concentratedloads P at the positions shown in the figure. A support C at the midpoint of the beam is positioned at dis-tance d below the beam before the loads are applied. Assuming that d 5 10 mm, L 5 6 m, E 5 200 GPa, and 198 10 mm 6 4 I 5 3 , calculate the magni-tude of the loads P so that the beam just touches the support at C.
The A-36 solid steel shaft is 2 m long and has a diameter of 65mm. It is required to transmit 60kW of power from the motor M to the pump P. Determine the smallest angular velocity the shaft in radian per seconds that can have if the allowable shear stress is 80 MPa.
Please, reaply as soon as posible. I have little time! Static Problem The band brake shown controls the rotation of the drum. The coefficient of friction between the belt and the drum is 0.25. The weight of the lever is negligible.Determine the force P that must be applied at the end of the braking lever to resist a torque T = 200 lb in, if the torque is applied in the: a) Clockwise b) Counterclockwise direction.
Find the minimum and maximum value of 'u' so that the steel balls will be able to enter the 70mm hole. Note that 'u' is the initial velocity.
Ql:-A cylinder of 1lft diameter and 2ft length floats in a tank that contains a liquid of specific weight .A u-tube manometer is connected as shown in figure. What is the weight of the cylinder whose upper the surface is flush with fluid surface PA--0.1 psi Water 2 ft Cylirder Gage fluid SG- 1.5 Sp wt.y 0.5 ft 02. w1
2. A 60-g bullet is fired horizontally with a velocity v, = 60om/s into the 3-kg block of soft wood initially at rest on the horizontal surface. The bullet emerges from the block with the velocity v: = 400 m/s, and the block is observed to slide a distance of 2.70 m before coming to rest. Determine the coefficient of kinetic friction between the block and the supporting surface. 3 kg 400 m/s 600 m/s 60 g 2.70 m
Ex4:For the beam shown in the fig. blew find the value of (y) ,using the data kN f'. = 40Mpa.fy = 414Mpa , L. L= 24,D.L = ( self weight) 57.5mm lo 5025mm LL=24KN/m d=500mım 6m Solution: 300mın