Suppose R = 230 n and C = 120 µF in a (charging) RC-series circuit with a 11 V power source. What is the maximum charge on the capacitor? After 2 time constants, the capacitor will reach what percent of its maximum charge?

Suppose R = 230 n and C = 120 µF in a (charging) RC-series circuit with a 11 V power source. What is the maximum charge on the capacitor? After 2 time constants, the capacitor will reach what percent of its maximum charge?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: The triangular current pulse shown is applied to a 20 mH inductor. Write the expressions that…

A: Graph is given as ; From the above figure current for time is 0 Therefore, expression of current…

Q: The two capacitors in the figure were charged and then connected as shown. Determine (a) the…

A: In this question we need to find a following

Q: The rectangular-shaped current pulse shown is applied to a 5 μF capacitor. The initial voltage on…

Q: What did you observe about the time it takes for the capacitor to fully charge (5RC) as the series…

Q: Agroup of identical capacitors are first connected in series then in parallel. If the parallel…

A: Let the capacitance of the identical capacitors is C and the number of capacitors = n

Q: In an RC circuit charging a capacitor, R and C are 100 2 and 22 nF, respectively. Find the new value…

A: In a RC circuit we know that the time constant of the circuit is given as follows. T = RC

Q: The equivalent capacitance of three capacitors A, B and C connected in series is 75 µF. If A is…

Q: The given figure is to be designed to pass a wave having a frequency of 3500 cps and block a 2500…

Q: 2. Five identical capacitors with a capacitance of 20 uF are connected in series and parallel, as…

Q: The voltage source 60-40u(t) V is in series with a 10 resistor and a 50 mH inductor. Find the…

A: d, I2(t) = I2(∞)+[I2(0-)-I2(∞)]e-t/T A = 2+[6-2]e-t/T A T=LR=50×10-310 =…

Q: d capacitor is connected to a col by closing a switch (see figure), energy is transferred to the…

Q: A resistor and a capacitance are connected in series to an emf source. The time constant of the…

Q: IN THE CIRCUIT BELOW, AFTER THE CONDITION OF STATIONARY STATE (TIME > 5*TIME CONSTANT), THE VOLTAGE…

Q: %3D 5. In Figure, after switch S is closed at time t 0, the emf of the source is automatically…

A: It is given that:

Q: circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold…

Q: A parallel-plate capacitor has plates of dimensions 2 cm by 3 cm. The plates are separated by 1 mm…

Q: Select all correct statement(s): 1, The equivalent resistance for resistors in parallel is the…

Q: A capacitor is connected into a 277-V, 400 Hz circuit. The circuit current is 12 A. What is the…

A: Here, Voltage V = 277 V Frequency f = 400 Hz Current = 12 A

Q: 13. Two capacitors C1= 50 µF and C2 = 30 µF are connected in series. Find the equivalent capacitance…

Q: In the circuit below, the switch closes at time t=0. Assume that Vs = 13 V, R switch closes is 3.9…

Q: An LC circuit is made by attaching a 0.2221 H inductor is connected across a variable capacitor…

A: Given L =0.2221…

Q: The voltage at the terminals of the 0.6 µF capacitor shown in the figure is 0 for / < 0 and…

Q: A capacitor has a capacitance of 0.1 μF with air as the dielectric. If the dielectric material is…

A: capacitor has a capacitance of 0.1 μF with air as the dielectric. ceramic material with a dielectric…

Q: 5.7 Figure P5.7 illustrates a De Sauty bridge in which the capacitors change differentially. The…

A: Given the circuit, as shown below: Given : vs(t)=5sin(ωt)ω=1RCo The detector can only resolve δVo=5…

Q: Problem: 1 Calculate the time constant t for the following circuit. t- 0 R= 47kn Vs = 5v C = 1000uF…

Q: The plot below shows the current flowing into a 3.3µF capacitor as a function of time. What is the…

Q: long time. At t-0 the switch is moved to position "b". Find the capacitor current as a function of…

Q: A capacitor is connected in series with a 2-N resistor and a 0.3-V battery. The current starts to…

A: Given: A series RC circuit with Capacitance, C=1.33×10−5 F Resistance, R=2 Ω Supply, V=0.3 V Current…

Q: When the capacitor is charged current flows on either side of the capacitor. Do electrons cross the…

A: A capacitor is an electrical device which consists of 2 conducting plates separated a dielectric…

Q: A capacitor network is shown including three capacitors, a power supply, and a switch. The switch is…

Q: The initial voltage across the capacitor shown in (Figure 1) is vc(0+) = 0. Sketch vc(t). Plot the…

Q: In the circuit shown in figure, after the switch is open for a long time, it is closed at t=0. Now,…

A: Choose the correct options In the circuit.find the value of the voltage across the capacitor at time…

Q: A group of identical capacitors are first connected in series then in parallel. If the parallel…

A: let the value of the capacitance is C total number of capacitors = n

Q: The two capacitors shown in the figure have been connected for some time and have reached their…

A: A capacitor is a passive element that store energy in an electric field. If n number of capacitor…

Q: 9 What is the capacitor current when the capacitor is fully charged?

A: Q= CV Q= charge stored in the capacitor C= capacitance of capacitor V= Voltage across the…

Q: Solve

A: The capacitors can be connected in two ways: Series Parallel

Q: Part B - Final charge on the capacitor What is the final (t = o0) charge on the capacitor? Part C-…

A: As we have given: ε=50 VR=20 ΩC=3 μF When the switch is closed the circuit becomes: For A) Apply…

Q: 3. Find the equivalent capacitance of the group of capacitors shown in the circuit below. 15.00 μF…

A: Given,

Q: A series circuit contains a 20-Ω resistor and a capacitor with a capacitance of 110.5 µF. If the…

A: It is given that, In a series circuit, The value of resistor is, The value of capacitor is, The…

Q: Q) Initial current across a capacitor connected across a DC source is huge and initial voltage is…

A: Proof that Initial current across a capacitor connected across a DC source is huge initial voltage…

Q: 3. For an RC circuit comprising a capacitor C= 2 µF in series with a resistance R- 1 M2 , the period…

Q: 5. A 0.05-µF capacitor is connected in parallel with a 10-nF capacitor. How much capacitance must be…

Q: c) Solve the value of ve, il and the energy stored in the capacitor and inductor in thecircuit of…

Q: What capacitance must be connected in series with a 30µF capacitor for the equivalent capacitance to…

A: Given: Two series capacitor having capacitance, C1=30 μFC2=?Ceq=10 μF

Q: In the given circuit; an initial voltage V-10 V exists across the capacitor. Calculate a) The time…

Q: Find the inductor current at t=150 ms if the voltage waveform below is applied to a 5 mH inductor.…

Q: RC circuit after the capacitor is charged, the switch is moved to dischsrge. The capacitor…

A: After being charged, when a capacitor of capacitance C discharges through a resistor R, the…

Q: What is the potential difference (voltage) across capacitor C3 in the circuit below?

A: In parallel circuit the voltage across the components are same.

Q: The series RLC circuit of Figure Q3 contains a resistor of R=200, an inductor of L=10mH and a…

A: As there are multiple questions, we shall answer only the first question. i.e the numerical on…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

100%

Suppose R = 230 N and C = 120_µF in a (charging) RC-series circuit with a 11_V power source. What is the
maximum charge on the capacitor? After 2 time constants, the capacitor will reach what percent of its
maximum charge?
%3D
8.
max charge
A.
0.002256 C
D.
0.002283_C
В.
0.001623 C
Е.
0.001678_C
С.
0.0008826 C
F.
0.00132 C
|--/
9.
percent
90.99 %
86.47 %
138.7 %
D.
92.44 %
52.58 %
152 %
А.
В.
Е.
С.
F.
|--/

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
List the five capacitor replacement rules.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open, the plate to the left of the capacitor has charge "Qo". The switch is closed the load and current vary sinusoidally with time. Represent graphically the load "Qo" and the intensity of current "I" as a function of time "t", and explain why the current leads the load by a phase difference of 90°.