A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.

Q: Determine the values of the resistance and the series-connected inductance or capacitance for each…

A:

Q: QI: A continuous-time signal x(1) is shown in figure(1) Sketch and describe mathematically of the…

A:

Q: How many mebibytes are there in a gibibyte? O 512 O 1024 O 256 O 2048

A: The quantity of memory that may be used by an electronic device, such as a  smartphone, laptop,…

Q: equivalent resista O. A 12-ohm resistor is connected in parallel with a series combination of 8 ohms…

A:

Q: QUESTION 4 Determine the Norton equivalent to the circuits of Figure 4 and draw its equiva circuit.…

A:

Q: In vacuum, the electric field is solenoidal (i.e. it has zero divergence) In all points of space…

A: SOLUTION ANSWER-->                     Electric field will be…

Q: A

A: We need to find out peak Voltage and RMS voltage and frequency and time period for given waveform

Q: 4. A Si p-n junction diode with a built-in potential of 0.75 V at 300 K and the depletion region in…

A: Given, Built-in potential VB=0.75V, Temperature T=300K Depletion region at p side WP=100×Depletion…

Q: 12. Using the superposition theorem, find the load current in each circuit of Figure 8–76 LL. Figure…

A:

Q: Q.1: Choose the correct answer for each question 1- What does a GPS receiver measure? A) The phase…

A: SOLUTION                                  PART-1 ANSWER- option (B)  The…

Q: Design a series resonant circuit with an input source voltage of 1020° V to have the following…

A: Given: Peak current at resonance, I=800mA Bandwidth, ∆f=120Hz Resonant frequency, fr=8400Hz

Q: 3) An incandescent lamp has an internal resistance of 96 92 and operates at 120 V. a) How much…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: Describe how the principles of the RAID organization may be used in a broadcast-data environment…

A: A basic introduction to RAID Raid generally stands for  (Redundant array of independent disk). In…

Q: An electric lift is required to raise a load of 5 tonne through a height of 30 m. One quarter of…

A: We have an electric lift with, load or mass (m) = 5 tonne Height (h) = 30 m Time taken = 27 Minutes…

Q: Q: Characteristics of RISC are as follows (one of them is not true)* variable-length, easily decoded…

A: The term RISC stands for 'Reduced Instruction Set Computer'. In this kind of CPU architecture, the…

Q: Q2) Infinite line charge of pu-5nc/m at X-1, Y-1 and a sheet of charge of ps-3 nc/m² at y=-2, the…

A:

Q: A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230 V, 50 Hz supply…

A: Given: A single phase energy meter having, Meter constant, K=200 revkWh. Operating voltage, V=230 V.…

Q: A call of resistance 16Ω and inductance 1 H is connected to 110 V d.c. supply. Find (i) rate change…

A:

Q: Q3-Find V₂ & 1 using nodal analysis. 140 HE 5/0° A + -jan TEX IT An 120 NC 20/90 V

A:

Q: A transformer has a turn ratio of 1: 10. A resistance of 2000 ohms is connected across the secondary…

A: Given, Transformer turns ratio, a=110=0.1. Secondary terminal resistance, R2=2000 Ω.

Q: Given vectors: Ā= αāx + āy +4āz B = - 3āx + ßāy − 6āz C = 5āx - 2y + yāz *** Determine a, p, and y…

A: We need to find out value of unknown for given vector for given conditions

Q: Three capacitors are connected in parallel across a 230 V, 60 Hz supply. These capacitors have…

A: If three capacitors C1 , C2 , C3 are connected in parallel then equivalent capacitance is C1 +C2+C3.…

Q: Using Thevenin's theorem, find the current I, in the circuit shown. Hilt 30V Dº 6A + 1002 302 20 R₁…

A:

Q: A capacitor having a Q-factor of 400 is connected in parallel with a coil having a Q-factor of 50.…

A: As per the question, it is given that Q-factor of capacitor (Qc) = 400 Q-factor of coil (QL) = 60…

Q: A 220 V shunt motor has an armature resistance of 0.4 ohm and field resistance of 140 ohm. The motor…

A: We have an shunt motor which is having, Voltage (V) = 220 V Armature resistance (Ra) = 0.4 Ω Field…

Q: ا يسا ww نه BA Using Kirchoff's current law, calculate the unknown currents in the above circuit.

A: In this question,  We need to determine the unknown current in the circuit as shown the circuit…

Q: sentences: 8) The primary mmf is not equal and same direction to the secondary mmf in an ideal…

A: The question is about characteristics of Ideal transformer.

Q: Q In memory hierarchy which of the memory types is the expensive one O Cache memory O Disk memory O…

A:

Q: A 3 phase, 4 pole, 11 kV, 10,000 kVA alternator has neutral earthed through a resistance of 9 ohms.…

A:

Q: Differentiate AM DSBFC, DSBSC, and SSBSC in terms of the power distribution and bandwidth. What are…

A:

Q: An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A.…

A:

Q: Given the Z-transform of a signal by: X(z) = A. x(n) = (0.6)"u[n] x(n)=0.5(0.6)2nu[n] 24-0.6 |z]>…

A:

Q: A call of resistance 16Ω and inductance 1 H is connected to 110 V d.c. supply. Find (i) rate change…

A:

Q: Question 9 For each signal a[n] below, determine if the R{x[n]}, i.e., the real part of the function…

A: If the real part of x[n] contains sine or cosine part, then it is said to be oscillatory function.

Q: 3A 5A 1A Using Kirchoff's current law, calculate the unknown currents in the above

A: Given data, Circuit diagram is given as,

Q: Q In the arithmetic operations in ALU the meaning of arithmetic shift left instruction for a binary…

A:

Q: Two silicon diodes, with a forward voltage drop of 0.7 V, are used in the circuit shown in the…

A:

Q: Complete the diagram for an amplifier system below. Sin=-30 dBm Nin=-100 dBm Sin=-30 dBm Nin=-100…

A:

Q: Calculate the number of turns and the cross section of a conductor for a 300 kVA, 66000/400 volts,…

A:

Q: If E=12ay at origin due to infinite surface charge located at Z=0 O yO O X>0 O

A:

Q: Consider the scalar system xlt) = tx(t) Compute the state matrix Ølt, t.). transition

A:

Q: find the current passing through the surface Z=1, 0<x<1, 0<Y<1 if H= (y^2*x) ax-(3*z^3*y) az

A:

Q: How many digits is the Octal System capable of having?

A: Numbers can be represented using various number system. Four basic number systems are - Decimal…

Q: When burning normally, the temperature of the filament in a 230 V, 150 W gas-filled tungsten lamp is…

A: The internal contacts of the reed switch's internal conduct current when they initially make contact…

Q: For the circuit of figure below: a- Calculate Avs = Vo/Vs. b- Determine fHi and fio. c- Determine…

A:

Q: Q3) Consider a unity-feedback control system with the following feedforward transfer function: k…

A: Note : In 2nd question root locus has to be find by Matlab which is practical based so i am doing…

Q: A 3-phase, 220 kV, 50 Hz transmission line consists of 1-2 cm radius conductors spaced 2 m at the…

A:

Q: Draw the circuit diagrams of a first and a second order band pass filter and indicate its lower and…

A: The bandpass and bandstop filter: The bandpass filter is used to pass a specific band which can be…

Q: Consider the system in Figure 1. D(s) ယောင်ခေါင်းပေါင်း E(s) 1 K Σ s(s+5)(s+7) 5 s+2 R(s) a) What is…

A:

Q: Given the resistor values for the circuit shown, find the closed loop gain. (Round off to 2 decimal…

A: