Solve nernst equation for solid oxide fuel cell by using natural gas as fuel and oxygen at cathode The input parameters of single cell are given below: Operating temp=550°c Cell voltage=0.8v Power density=850mw/cm2 Cell active area= 121cm2 Power of single cell=103 wat Ocv=1.020 Current density=2250mA/cm2

Q: An iron-carbon alloy initially containing 0.200 wt% C is exposed to an oxygen-rich and virtually…

A: Given data:The initial carbon concentration is The carbon concentration at the surface is The carbon…

Q: 10. The temperature of superheated steam if the pressure is 12 lb/in² absolute and the steam has 10°…

A: To find the temperature of superheated steam, you can use a steam table. However, I can provide you…

Q: The isomerization of acid A1: A1 ↔ A2 has an equilibrium constant of 30.0. The forward rate…

A:

Q: A plate, which is moving with velocity 10 cm/s, is placed 0.5 cm apart from a fixed plate. What will…

A:

Q: An evaporator is used to concentrate 4536 kg/h (10000 lbm/h) of a 20% solution of NaOH in water…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: Classify as per the order of their cuts, the various petroleum products obtained from crude…

A: Petroleum products are classified based on the order of their cuts in the refining process. Here is…

Q: 2. Say we need to have honey (viscosity 100 cp) flowing in a tube at 10 liter/min. Density is 1200…

A: To avoid turbulent flow, Ensure that the Reynolds number is less than the critical value, which is…

Q: Suppose it is required to produce heat at 10MW. What will be the amount of CO2 per hour produced if…

A:

Q: (a) Derive the change in the entropy for adiabatic reversible expansion of a diatomic ideal gas from…

A: (a) An adiabatic reversible expansion is given of a diatomic ideal gas fom Vi to VfThe initial…

Q: in determine the molar amounts atomic species balancer and • molecular specier balancen

A:

Q: Example 6.2. Figure 6.7 shows a simplified flow diagram of a typical capillary viscometer (a device…

A: To find the viscosity of the fluid, we can use the Hagen-Poiseuille equation, which relates the flow…

Q: 4. A feed of 4535 kg/h of a 2.0 wt%. Salt solution at 311°K enters continuously a single effect…

A:

Q: 4.69. Ethanol can be produced commercially by the hydration of ethylene: C₂H4 + H₂O → C₂H5OH Some of…

A: Given reaction for the hydration of ethylene is,Side reaction is,Mole percent of ethylene = 43.3…

Q: For a gas obeying the following equation of state V After showing that: - RT P C constant. where, C…

A:

Q: A feed of A with a volumetric flowrate of 4 L/min and an initial concentration of 1 mol/L enters a 2…

A:

Q: (C) What final conversion can be achieved if a 72-dm^3 PFR is followed in series by a 24-dm^3 CSTR?

A:

Q: Example 6.2. Figure 6.7 shows a simplified flow diagram of a typical capillary viscometer (a device…

A: To find the viscosity of the fluid, we can use the Hagen-Poiseuille equation, which relates the flow…

Q: Climate change is attributed to the accumulation of carbon dioxide in the atmosphere. While the…

A: CO2 concentration after industrial revolution = 412 ppmCO2 concentration before industrial…

Q: An aqueous solution of sodium chloride containing 0.2 wt% NaCl and 99.8% water is fed at a rate of…

A:

Q: Step 12 23 34 41 12341 AUTJ -200 ? ? 4700 ? Q/J ? -3800 -800 ? ? WIJ -6000 ? 300 ? -1400

A: Given:1. A closed system's one mole of gas passes through a four-step thermodynamic cycle.To…

Q: Calculate the pressure difference between points A and B 66.6 in Water 30.0 in 22.2 in 40.3 JJ in…

A: Assuming pressure at point A is PA and at point B is PB.We know specific gravity of water is 1 and…

Q: f the mixture has an overall molar composition of 45% A and 55% B (binary mixture), find the…

A:

Q: 4.8. In a power plant, the inlet water has a velocity of 100 ft/s and an elevation of 80 ft above…

A:

Q: An inventor has devised a complicated nonflow process in which 1 mol of air is the working fluid.…

A: A physical principle based on observed interactions between heat and energy, the second law of…

Q: top 10 practical learnings in chemical engineering that I can apply in real life

A: Chemical engineering is the branch of engineering where principles of science and mathematics is…

Q: Convert Henry's constant for benzene, 5.5 x 10^-3 atm.m³ per mole at 20°C, to a dimensionless…

A:

Q: 1. The velocity profile for a film of liquid flowing down a vertical wall driven by gravity is given…

A:

Q: A hydrocarbon is burnt with excess air. The Orsat analysis of the flue gas shows 10.81% CO2, 3.78%…

A: When a hydrocarbon, which is composed of carbon (C) and hydrogen (H), is burned in air, it reacts…

Q: At low to moderate pressures, the equilibrium state of the water-gas shift reaction s approximately…

A: given water gas shift reaction

Q: An ideal gas with a volume of 1 m³ is at 100 °C and 2 bar. The gas undergoes a process with two…

A:

Q: 5.31.* The venturi has meter in air flowing it. The through manometer, as shown, contains both…

A: It is given that air is flowing in the venturi meter.Given data are as follows:Inlet area of venturi…

Q: can youdo part d and e now

A: The reaction of stilbene (A) to produce trospophene (B) and methane (C) is an exothermic reaction…

Q: A fluid is flowing in a pipe. The pressure drop is 10 psi per 1000 ft. We now double the volumetric…

A:

Q: Granular activated carbon is used to adsorb haloacetic acids from 1L of water. The initial water…

A: To answer this question, we can use the Freundlich isotherm equation:where:q is the adsorption…

Q: Determine the reaction order,K value( unit must be included )and the R^2 value using the graphic…

A:

Q: 4. The industrial scrubber B in FIGURE Q4 consumes water (v=0.113 x 105 m²/s) at the rate of 0.1…

A:

Q: Connder the reaction. Suppose 20.0 Kmol of acet hydrogen, and 50.01 ms) of charged into a batch reac…

A:

Q: The exact elemental composition of an individual human body depends upon the relative amounts of…

A:

Q: A stirred-tank blending system initially is full of water and is being fed pure water at a constant…

A: 1% Define the parameters 2V = 2; % Volume (m³) 3q = 0.4; % Flow rate (m³/min) 4Ci =…

Q: Consider a process in which a carbon-based fuel is combusted in the presence of 70% excess oxygen…

A: Carbon based fuel is combusted in the presence of oxygen. Percent of excess oxygen given = 70%

Q: What is the loss in exergy when a heat transfer of 50 J occurs across a temperature difference of…

A: The loss in exergy is calculated using the following formula:Loss in exergy = (Heat transfer) * (1 -…

Q: thank you, last question  Regulations of Contaminant (A) call for PPM ≤ 20 PPM Is the treatment in…

A: The regulations of contaminant A call for a PPM of 20 or less. The initial concentration of…

Q: (a) Determine the differential of RT P = V-b and confirm whether it is exact. (b) Integrate from…

A:

Q: reaction steps. A carbon tetrachloride production process consists of a reactor and a separator sys…

A:

Q: 3 15 kg of steam is expanded in a piston from 1,000 kPa and 650 °C to 750 kPa and 350 °C. How much…

A:

Q: X₁0 mol -TA dm³-min 1.0 (dm³-min) mol -TA FAO (dm³-min) -TA mol 0.2 1.67 0.4 5.0 0.45 5.0 0.5 5.0…

A: Given, feed flow rate of ANow we tabulate data of conversion of A (XA) versus  using the table…

Q: steam table

A: State 1 : Superheated water vapor at P1 = 180 psia and T1 = 400 °F.State 2 : temperature, T2 =…

Q: (optional) Design a solar collector: Following the steps to decide the size of a solar collector.…

A:

Q: Scrubbing with an oil in a 4-tray tower

A:

Q: Water is flowing at an average velocity of 7 ft/s in a 6-in pipe. What is the pressure drop per unit…

A: