RLC paralle circuit contains a resistor with a resistance of 16 ohms, an inductor with an inductive reactance of 8ohms, and a capacitor reactance of 20 ohms. What is the total impedance of this circuit?

RLC paralle circuit contains a resistor with a resistance of 16 ohms, an inductor with an inductive reactance of 8ohms, and a capacitor reactance of 20 ohms. What is the total impedance of this circuit?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter24: Resistive-inductive-capacitive Parallel Circuits

Section: Chapter Questions

Problem 6PP: In an RLC parallel circuit, the resistor has a resistance of 60 , the inductor has a reactance of...

See similar textbooks

Related questions

Q: 10 ΜΩ +20 V RD 6 ΚΩ The NMOS in the circuit shown has the following parameters and is operating in…

Q: Given that Z1 = 3 + J2 and Z2 = 2+ J3 express Z1/ Z2 complex exponential form

A: Z1 = 3 + J2Z2 = 2+ J3In complex exponential the value is expressed in a+jb form. The detailed…

Q: Find the maximum power that this circuit can deliver to a load if the load can have any complex…

A: The circuit diagram is shown below,

Q: Sketch all applicable depletion regions for an n-channel MOSFET when the source and drain remain…

A: According to the question, we need to sketch all applicable depletion regions for an n-channel…

Q: Say we have an LED that will turn on when driven with a low signal from the output of a single logic…

A: The LED should turn on with a low signal.We want the LED to flash on and off at 3 Hz when the gas is…

Q: You did 4 scans of a sample with an FTIR and averaged to 4 scans to result in a signal-to-noise…

A: The initial signal to noise ratio is .The desired signal to noise ratio is .

Q: A helix antenna has a spacing between the turns 0.05m and D= 0.1m. The number of turns (N) = 20. The…

A: The spacing between turns, Number of turns, The operating frequency,

Q: Calculate the voltages V1 and V2 for the circuit in the figure 15.128 in phasor form, use the…

A: In this question, we need to determine the voltages V1 and V2 using the voltage division method.

Q: Prepare & Analyze the whole Power System of the country "Philippines" Provide a Detailed Data that…

A: Analyzing the entire power system of a country, like the philippines is a complex and multifaceted…

Q: 2. Make a sketch of two sinewaves as follows. Sinewave A is the reference and sinewave B lags A by…

A: A = Sin (wt)B = Sin (wt-90°)

Q: 8. How long it takes for the signal to get from the output of the Modulator/transmitter, point in…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: An electric heater takes 1.48 kW from a voltage source of 220 V. Find the resistance of the heater?

A: In the electric heater,The power taken, .The source voltage, .

Q: Design an exclusive nor (XNOR) gate using only 74HC02 NOR gates. (Pin outs shown below). Complete…

A: Given:74HC02 NOR gate IC. we need to do:design an ex-nor (XNOR) gate by first drawing truth table,…

Q: Given the following ideal zener diode circuit with breakdown voltage 5.1 V, sketch the output…

A: Given:An ideal zener diode circuit, with breakdown voltage we need to sketch output voltage for…

Q: A speed controller controls the speed of a wound-rotor motor by reducing the _____ connected to the…

A: The rotor conductors are terminated by the RMF after it passes through the air gap and starts off…

Q: H.W1 The single-phase full wave rectifier has a purely resistive load of R, determine: a) The…

Q: There is a system that works with a sampling rate of 48 kpsp and requires a bandpass filter that…

A: Given:There is a system that works with a sampling rate of 48 kbps and requires a bandpass filter…

Q: au[n], la<1 1 1-ae-ju

A: Given: H(ejω) = 1 − 0.5e−jω We want to rearrange it in the form: Where is the Fourier Transform of…

Q: Problem : Find Vo. j1.50 - 20 j40 20 UE 120320 10/30°v ( ° 46 42 24/0°v (+ 20 w -j32 Answer Vo =…

A: Given circuit:Asked to find the voltage Vo in the circuit?

Q: I have an O Gauge track and would like to convert it into a “sensored” track. Additionally, I would…

A: According to the question, an O-gauge track and would like to convert it into a “sensored” track.…

Q: Calculate the complex power for each component in the circuit below. Use R₁, R2, R3 and R4 from your…

A: Given circuit:Asked to find the complex power in each element in the circuit?

Q: 4. We will now study a circuit that has a more complicated arrangement of resistors. = (a) Consider…

A: For the given circuit for the following values calculation of current I1, I2 and I3 using…

Q: | How] : Find Vo Ans: ₁ = -8 = R R ਆਈ R

A: The question is about finding gain of the Op-amp.

Q: From the steady space form for this system we can obtained: |--E] The transfer matrix of the system…

A: The question is about multiplication of matrices to finding the transfer function.

Q: the network shown below, the boolean expression for X is D(A + B + C) (AC + BC)D A + BC + D ((A + B)…

Q: The rotor windings of a wound-rotor motor are connected to ______ a. The power lines (L1, L 2, L3)…

A: The rotor windings of a wound-rotor motor are connected to an adjustable resistance circuit. This is…

Q: Discuss the process of semiconductor fabrication used in manufacturing microchips, including…

A: Semiconductor fabrication, also known as semiconductor manufacturing or chip fabrication, is the…

Q: Use nodal Analysis to find the following for the given circuit below: a) Voltage at Node "A" in V…

A: In this question, we need to determine the voltage at the node A, current in resistances R5 , R6…

Q: How do microchips differ from traditional integrated circuits (ICs) in terms of functionality and…

A: Microchips and traditional integrated circuits (ICs) are closely related, with microchips being a…

Q: Giver/Receiver diagram of Solar Power I need a picture

A: It is asked to draw the diagram of giver/receiver for a solar power.

Q: The industry standard for reversing the rotation of a wound-rotor motor is to _______ a. Reverse T1…

A: In the given questions we need to discuss that how to reversing the rotation of wound rotor motor.

Q: The RI ands R2 connections on a synchronous motor are for the

A: The question is about stator field winding.

Q: Problem Find ₁ and Vo. 12/0° V I₁ ww 252 -J252 1:2 Ideal + 252 -j252 46 3252 Answer I₁ = 3.07/39.81°…

Q: Consider the circuit given below. 4.2 ΚΩ www -1 V 6 ΚΩ +1V Μ 2 ΚΩ 7.2 ΚΩ V. 5.4 ΚΩ V₁ Vo If V1 =…

A: The question is about finding the output voltage of Op-amp.

Q: Describe the role of IoT in the energy sector. How can it help in optimizing energy consumption and…

A: The Internet of Things (IoT) plays a significant role in the energy sector by enhancing efficiency,…

Q: Discuss the challenges and innovations in miniaturization and cooling techniques for microchips. How…

A: Miniaturization and cooling techniques for microchips have been areas of significant innovation and…

Q: -> 26.30 www. www + + JOV 5V 10 Ar wwwww a www 4 is removed from the The 5V battery circult and…

A: The circuit diagram,

Q: [How s] Show that vo(t) = - [R²₁, V₂ (+) + (CR₂ + 4 ) dui(e) +Led)] cf2 For the circuit shown below?…

Q: Required information Consider the circuit given below. Vino R₁ R₂ m 12 m 4₁ R3 - Vout Determine the…

Q: PART A PART B 11 (a) 0.5 H inductive load (b) 0.02 F capacitor load (c) 0.05 H inductor load (d) 5 Q…

Q: How is IoT utilized in the agriculture sector for precision farming?

A: IoT (Internet of Things) is increasingly utilized in the agriculture sector for precision farming,…

Q: dy(t) 3. Given R = 5 kn, C = 1 µF, i(t) is the current in the circuit, r(t) is the input voltage,…

A: The question on the control system is shown below.The question is related to frequency response.The…

Q: 3. Determine the expression for the resonance frequency or of this circuit. L moo Vin R₁ R₂

Q: Question 6 Fill in the blanks to complete the truth table represented by this timing diagram. in…

A: Based on the given timing diagram the respective truth table needs to be obtained and the respective…

Q: Using KCL to find the unknown currents (I1, I2, I3 and I4 ) for the network shown in the Figure 3.

A: Given:a network,To find: the unknown currents (I1, I2, I3 and I4 ) using KCL.Note:According to KCL,…

Q: I. Show that the following signals are periodic and find its period. b. x(t) = Cos 2t + Cos 3t+ Cos…

Q: Vin VGG VDD RD The amplifier above has Rp = 2 k2 and is = biased by VGG and VDD to have gm mA/V. If…

Q: How is IoT utilized in smart agriculture for crop management and monitoring?

A: The term IoT, or Web of Things, alludes to the aggregate organization of associated gadgets and the…

Q: Problem: In the case of a 60Hz frequency, calculate v (t) and the power factor of a source. 0.2 Ω +)…

Q: Please design a 6:1 multiplexer following the below procedures with data inputs of D5, D4, D3, D2,…

A: Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Question

An RLC paralle circuit contains a resistor with a resistance of 16 ohms, an inductor with an inductive reactance of 8ohms, and a capacitor reactance of 20 ohms. What is the total impedance of this circuit?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given question

VIEW

Step 2: Total impedance

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In an RLC parallel circuit, the resistor has a resistance of 60 , the inductor has a reactance of 180 , and the capacitor has a reactance of 80 . Find the circuit power factor.
Which of the following is the capacitance of two 20-microfarad running capacitors connected in parallel? 10 microfarad 20 microfarad 30 microfarad 40 microfarad
An RLC parallel circuit has an apparent power of 400 VA. The inductor has a reactive power of 450 VARs, and the capacitor has a reactive power of 200 VARs. Find the true power or watts.
In an RLC parallel circuit, the resistor has resistance of 24 k , the inductor has a reactance of 36 k , and the capacitor has a reactance of 14 k . Find Z.
An RLC parallel circuit contains a resistor with a resistance of 16 Ω, an inductor with an inductive reactance of 8 Ω, and a capacitor with a capacitive reactance of 20 Ω. What is the total impedance of this circuit?
A resistive source of with frequency of 0.5GHz needs to match a resistive load that is in series with a 1.62pF capacitance. Design with the aim of a diagram a matching circuit for this problem.
the equivalent impedance of a capacitor in parallel with an iductor is equivalent to an open circuit (i.e equal to infinity) at a certain frequency.Drive an expression for this frequency
The graph shows the current vs. frequency graph of FOUR (4) RLC series circuits with different combinations of resistance (R) and capacitance (C) values. The value of L and the peak-to-peak voltage across both sets of data are the same. Find the following quantities:
A series circuit contains a 20-Ω resistor and a capacitor with a capacitance of 110.5 µF. If the circuit has a frequency of 60 Hz, what is the total impedance of the circuit?
A series RL with R = 56-Ω and L = 7-H connected across a 34 VDC source for a LONG TIME, how much energy is stored in the inductor?
Describe what happens to the power in this RLC series circuit as the capacitance decreases. Explain in general terms why the observed change should occur. (5 sentences)
Consider the parallel RLC circuit of Figure 2 with the source a 1-kHz sinusoid having an amplitude of 5 V. Regard the source voltage as having zero phase. Calculate the amplitude and phase (in degrees) of the following quantities: the current through the resistor, the current through the inductor, and the current through the capacitor. Calculate also the amplitude and phase of the current supplied by the source.