Raschig rings. The feed gas rate is 1500kg/hr. calculate the minimum liquid rate and the packed height. Equilibrium data for SO₂-water system at 30°C is

Q: Consider a series of reactions ARS in tubular reactor. Calculate the maximum outlet concentration of…

A: To calculate the maximum outlet concentration of R in the series of reactions A -> R -> S in a…

Q: 9. Determine the specific volume of saturated vapour by Redlich-Kwong equation for the following,…

A: Note: Since you have posted a question with multiple sub parts, we will provide the solution only to…

Q: 1. The sphericity of a cylinder of 1 mm diameter and 3 mm length is (a) 0.9 (b) 0.78 (c) 0.6 (d) 0.5

A:

Q: Provided that the mixture (binary) follows Raoult's Law and Dalton's Law, what is the expression for…

A: Dalton's Law of partial pressure states that the total pressure of the system is given by the sum of…

Q: leaving the distillation column are at different temperatures. a) Determine the number of degrees of…

A: 1) feed mixer contains pure nbutane at temperature T which is only unknown so it's degrees of…

Q: A contaminated soil sample (0.5886 g) was treated with 5 mL of 0.6 M KOH to extract the glyphosate.…

A: To solve the given problems, we need to use the provided information and perform the necessary…

Q: Estimate the specific enthalpy of ethyl alcohol at 1 bar and 200°C, taking the datum temperature as…

A: As no data are given on the exact variation of the Cp of the liquid with temperature, use an…

Q: Consider an ideal gas which is being throttled to a pressure of 1 bar at a rate of 100 mol/s…

A: Molar flow rate of an idea gas = 100 mol/sInitial pressure = 25 barFinal pressure (pressure at the…

Q: Butene is obtained as a result of the dimerization reaction of ethylene: 2C2H4(g) → C4H8(g)…

A: Given dimerization reaction of ethylene to butene is-The temperature of the reactor, T1=1500COutlet…

Q: By using the Psychrometric chart in Appendix III: a) Calculate the total heating coil capacity. I b)…

A:

Q: The vapor leaving the top of a distillation column goes to a condenser in which either total or…

A:

Q: cooling coil made of copper tube is immersed in a regulated constant temperature bath held at a…

A:

Q: water 60 0.041 Calculate: 1. The composition and flow rates for all streams around the absorber 2.…

A: .

Q: The temperature in degrees Celsius on the surface of a metal plate is given by T(x, y T(x, y) = 50-…

A: The variation of temperature on the surface of the metal is given as:To find:The rate of increase in…

Q: A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into…

A: Here gaseous mixture is put into a piston cylinder. Piston moves such that pressure of cylinder is…

Q: 7. At a particular section of packed distillation column, the bulk liquid concentration in a binary…

A: The height of an overall vapor phase transfer unit (HOG) in a packed distillation column can be…

Q: 4. Discuss in detail about activated complex theory. Show that Arrhenius law is a good approximation…

A: Chemical kinetics uses the activated complex theory, commonly referred to as the transition state…

Q: In a chemical engineering A pump is used to transport a liquid through a pipeline with a diameter of…

A: Answer:To calculate the flow velocity of the liquid inside the pipeline, we can use the equation for…

Q: A chemistry graduate student is studying the rate of this reaction: 2H3PO4 (aq) → P₂O²(aq) + 3H₂O…

A: 2H,PO, (aq)-PO, (aq) +3H,O (aq)The rate law of a chemical reaction is an expression that shows how…

Q: Derive the differential equation that describes the desorption in a plug flow basin (Hint: write a…

A: To derive the differential equation that describes the desorption in a plug flow basin

Q: Estimate the molar volume of CO₂ at 500 K and 100 bar using the (a) ideal gas equation and (b) the…

A: Temperature, T = 500 Kpressure, p = 100 bar = 107 PaVander waals constant are,, T = 500 Kb= 4.267 x…

Q: The illustration to the left represents a mixture of nitrogen (blue) and hydrogen (light blue )…

A: Given- limiting reagent- In a chemical process, the reactant that will be totally consumed is the…

Q: Question: Biodegradation in Biomaterials: Impact and Applications in chemical Engineering

A: Answer:Biodegradation plays a crucial role in the field of chemical engineering, particularly in the…

Q: Calculate the energy stored in 1000 cm3 of gas at 80 MN/m2 at 290 K using STP as the datum

A: Volume, V = 1000 cm3 T = 290 kP1 = 80000 KN/m 2P2 = 101.3 KN/m2we know that...U = -W = nCv(T2 - T 1…

Q: A fluid is flowing in 1 meter diameter pipe with 2 m/s density of fluid =1000 kg/m^3 viscosity of…

A: Given Diameter of pipe D = 1mVelocity of fluid V = 2 m/sDensity of fluid d = 1000 kg/m3Viscosity µ…

Q: What is the change in entropy when 0.7 m³ of CO₂ and 0.3 m³ of N₂ each at 1 bar and 25°C blend to…

A: Entropy, a central concept in thermodynamics, quantifies the amount of disorder or randomness in a…

Q: A try drier is to be used for drying a solid material. Each tray is 3 ft wide by 4 ft long and the…

A: wide = 3ftheight = 4 ftdepth = 1.8 in = 1.8 x 0.0833 ft = 0.15 ftVolume of the tray = 3 x 4 x 0.15 =…

Q: Q2) A mixture of 40% propane (C3Hs) and butane (C4H10) by moles is burned with 35% excess air.…

A: Composition of the feed is,'Propane = 40 %Butane = 60 %Flow rate of air = 45 SCMH% excess air = 35 %

Q: Ethylene oxide is produced by the catalytic oxidation of ethylene: 2C₂H4 + O₂ → 2C₂H4O An undesired…

A:

Q: fruit juice in each of the Identify the amount of concentrated concentrated juice A which contain…

A: xA =mass fraction of solids in  juice AxB = mass fraction of solids in juice BGiven,xA = 0.65…

Q: 2. Cyclohexane (C6H12) can be made by the reaction of 100 mole of benzene (CH) with hydrogen (H₂)…

A:

Q: Degree-of-freedom analysis Question 1 Strawberries contain about 15 wt% solids and 85% water. To…

A: Content of solids in strawberries = 15 wt%Content of water in strawberries = 85 wt%The residue…

Q: Pure CO is mixed with 100 percent excess air and completely burned at constant pressure. The…

A: Reaction:>CO + 0.5O2 -------> CO2Ti = 400KTf = 600KHr = 282.99kJ/molCp(kJ/mol.K) for:CO =…

Q: Q21 A- A triple effect backward feed evaporator are used to concentrate NaOH solution of 10. percent…

A:

Q: The reaction A+Big-Cop+D) is carried out in a reactor followed by a separator as shown below.…

A:

Q: How do different types of boundary conditions (such as Dirichlet, Neumann, and mixed boundary…

A: Boundary conditions are very important  in the mathematical modeling of heat transfer processes in…

Q: A heat exchanger is to consist of a number of tubes each 25 mm diameter and 5 m long arranged in…

A: pressure drop = 2KN/mdiameter, d = 25 mmlength, l= 5mviscosity, = 1 mNs/m2 = 10-3 NS/m2Heat load =…

Q: can you present your working in full

A: The volumetric flow rate (q) through a triangular tunnel depends on height (h), width (w) and the…

Q: 2. Use Maxwell Relations to determine expressions for entropy of Redlich-Kwong snd Peng-Robinson…

A: Maxwell's relations are a set of equations derived from the four fundamental thermodynamic…

Q: The McCabe-Thiele method is used to determine the efficiency of a distillation column for separating…

A: Answer: FalseThe statement is false.

Q: in the tank remains constant. Determine (a) the amount of heat transfer and (b) the reversible work…

A:

Q: Derive a heat rate expression for the following geometry. Assume there is a poor contact at the…

A:

Q: Use the References to access important values if needed for this question. According to the…

A: The reaction between the sulfuric acid and the zinc hydroxide is as under:sulfuric acid(aq) + zinc…

Q: For the following hypothetical Eutectic binary system, A and B, determine the melting point of pure…

A: Hypothetical eutectic phase diagram is given as shown below,

Q: A 'long' steel shaft of 10 cm diameter is austenised at 870°C and then quenched in a liquid at 30°C.…

A:

Q: In a chemical process, 500 kg of a reactant A reacts with 300 kg of a reactant B to produce 800 kg…

A: a) To determine the limiting reactant, we need to compare the amounts of product that can be formed…

Q: A multistage counter-current absorber is designed to recover solute A from a nitrogen gas stream.…

A: Inlet gas stream flow rate (VN+1) = 157 kmol/hMole fraction of solute in the inlet gas streamyN+1 =…

Q: Determine the molar volume of n-butane at 510K and 25 bar by each of the following: (a) The…

A: Given Temperature T =510KPressure P = 25 barto find = molar volume

Q: Q2: One kilomol of a mixture of A and B (Z₁=0.5) is passed through a heat exchanger and then flashed…

A: Let us assume F be the molar flow rate of feed, V be the molar flow rate of vapor and L be the molar…

Q: (i) Carbon Residue (ii) Corrosion

A: 1) Carbon residue- This is a measurement of the quantity of coke residue left after a hydrocarbon…