Q2: A d.c ring distributor of 4 sides ABCDA is fed from point A with 250 v and has a resistance of 0.4 Q per 1 km. The distributor supplies loads of 150 A at point B, 300 A at point C and 250 A at point D. Determine the distance of each side of the ring knowing that AB side is equal to 1.111 of BC, and it (AB) is equal to 0.8 of CD, and it (AB) is equal to DA. Moreover, the current flow between AB is 336.75 A. Then determine the voltage at each load point. Hint: The voltage at point B is 243.265 v

Q2: A d.c ring distributor of 4 sides ABCDA is fed from point A with 250 v and has a resistance of 0.4 Q per 1 km. The distributor supplies loads of 150 A at point B, 300 A at point C and 250 A at point D. Determine the distance of each side of the ring knowing that AB side is equal to 1.111 of BC, and it (AB) is equal to 0.8 of CD, and it (AB) is equal to DA. Moreover, the current flow between AB is 336.75 A. Then determine the voltage at each load point. Hint: The voltage at point B is 243.265 v

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

1. The no-load terminal voltage of a battery is 30 V. The terminal voltage drops to 22 V when supplying a current of 5 A. Determine the emf and the internal resistance of this battery. 2. Two identical zinc carbon batteries are available. When connected in series, they supply 0.5 A to a 4 ohm resistor. When connected in parallel, they supply 0.4 A to a 5 ohm resistor. Determine the emf and internal resistance of each battery. 3. When supplying a current of 5 A, the terminal voltage of a battery is 15 V. The battery is then recharged at a rate of 3 A and the terminal voltage is found to be 21 V. Determine the emf and the internal resistance of the battery. 4. A battery with an emf of 12 V and an internal resistance of 0.8 ohm is to be recharged through a 20 V source. (a) show by means of a diagram the connection of the circuit elements. (b) What is the current in the circuit? (c) The recharging current is to be limited to 3 A. What is the value of the limiting…
Estimate voltage E2 when E1=90sin2400t V, R1=R2=20 ohms, L1= L2=3mH and M=0.15mH
example (H.w): A Current has an internal resistance of 782 ed to measure the Current through Rc in the below is used creuit. Find the percentuge error of the reading due to Ammeter hocaeding. Razike Rbzikuz AAmmeter
Problem 452 16V for circuit shown in figure, find the current in each resistor. Itas ce
4.-For-labeled currents, draw an arrow to show the direction of the actual positive current. For labeled voltages, circle the node that is at the actual highest potential. Note that the positive and negative signs of the voltage represent the polarity of the probes of a voltmeter connected to the device. The value shown is the reading on the voltmeter. (segment of wire) 2A -2A -5A 2.de 3A TA Cov E 5V 12V + 3V -10V -201
COPY THE ILLUSTRATION BELOW AND IDENTIFY THE BRANCH CURRENT AS STATED. R1 = 12 OHMS R2 = 72 OHMS R3 = 168 OHMS .... .O A solo: 12 72 36
Using IC that is approximately equal to IE. Determine the value of R1in ohms, when VCC=20V, RC=1740 ohms, RE=371 ohms, VC=7 V and R2=5341ohm
Problem 452 16V for circuit shown in figure, find the current in each resistor. ce
Determine the equivalent resistance across the terminals if R1 = 2R2 = 3R3 = 4R4.etc. and R11 = 3 ohms. R. Ry RI R.
Listen Calculate the built-in potential barrier, Vbi, for germanium with N = 10¹4 cm-3 and N₂ = 10¹7 cm¯³. Na cm-3 O Vbi = 0.335 V O Vbi Vbi = 0.312 V O Vbi Vbi = 0.395 V Vbi = 0.253 V
Coverage: Series and Parallel Combinations, and Ohm's Law Question: If simplified, the next figure shall be: - (a) A and the series of three resistors. - (b) A and the parallel of three resistors
2. Determine the equivalent resistance between the terminals a and b 452 352 C0.6662 0.61 0.33352 bo